Place the letter of the description that best fits the term in the space provided. (+1 each) 1)________ ANSI A Used to show a close-up view of features that are too small to adequately specify in another view. 2)________ Section View B The maximum and minimum sizes shown by the tolerance dimension. 3)________ Auxiliary View C Used to show features that are located on an inclined surface in true size and shape. 4)________ Detail View D An acceptable amount of dimensional variation that will still allow an object to function. 5)________ Tolerance E This institute creates the engineering standards for North America. 6)________ Limits F The target dimension from which the limits are calculated. 7)________ Specified Dimension G Used to show inside details not apparent on the exterior of the part. 8)________ Allowance H The minimum clearance or maximum interference between parts. Name the type of Linear Dimensioning pictured below. (+1 each)
9.___________________________ Name each of the following below. (+1 each)
Name the two types of Dimensioning METHODS pictured below. (+1 each)
14.___________________________ 15.____________________________ 10. 13. 11. 12. Match each Figure with the correct Section. (+1 each) Figure 1
Figure 2
Figure 3
16. Full Section ___________________
17. Offset Section ___________________
18. Half Section ___________________ Match the number with each vocabulary word. (+1 each) 19. Through Hole ________ 20. Clearance Hole ________ 21. Blind Hole ________ 22. Countersink ________ 23. Counterbore ________
Define Each Symbol (+1 each) 24. _________________________ 25. _________________________ 26. __________________________ 27. _________________________
Name the type of Tolerance, What is the Dimensional Variation (DV), and What are the Maximum and Minimum Values of the dimensions. (+4 each)