Lab 27
Lab 27
Date:
SCH4U
OBJECTIVES
In this experiment, you will
Gain experience mixing solutions of specified concentration
Experimentally determine the dissociation constant, Ka, of an acid
Investigate the effect of initial solution concentration on the equilibrium constant
MATERIALS
USB
LabQuest unit
Logger Pro
Vernier pH Sensor
two 100 mL beaker
2.00 M HC2H3O2
wash bottle
distilled water
100 mL volumetric flask
pipets
pipet bulb (pipet pump)
goggles
PRE-LAB
1.
2.
Write the equilibrium constant expression, Ka, for the dissociation of acetic acid, HC2H3O2.
(Space 3 in Data & Calculations table)
You have been assigned two different HC2H3O2 solution concentrations by your teacher
(___________ and ___________). Determine the volume, in mL, of 2.00M HC2H3O2 required to
prepare each. (Space 4 of Data & Calculations table) Get approval from your teacher
before you begin the lab.
PROCEDURE
1.
2.
Name:
Date:
SCH4U
3.
4.
5.
6.
7.
Fill the flask with distilled water to the 100 mL mark. To prevent overshooting the mark,
use a wash bottle filled with distilled water for the last few mL. Mix thoroughly.
Connect your USB and pH probe to the LabQuest unit if you would like to record a copy of
the data. If it is an older probe you will first need to connect an adapter, and then press
Sensor Sensor Setup Choose the pH option.
For the following steps, one person will hold the pH sensor, while another swirls the
beaker of solution under it. Be prepared to record the pH of the solution.
5.1.
Use about 40 mL of distilled water in a 100 mL beaker to rinse the pH Sensor.
5.2.
If the pH Sensor is still dirty, repeat step 5.1.
5.3.
Pour about 50 mL of your solution into a clean 100 mL beaker and use it to rinse
the sensor thoroughly.
5.4.
Use the remaining 50 mL portion to determine pH. Swirl the beaker of solution
vigorously. (Note: Readings may drift without proper swirling!) Record the
measured pH reading in your data table.
5.5.
When done, place the pH sensor in a beaker of distilled water.
Repeat the procedure for your second assigned solution.
Rinse the pH sensor thoroughly in distilled water, then place the sensor back into the
buffer solution.
Use a scientific calculator to determine the [H+]eq from the pH values for each solution.
Use the obtained value for [H+]eq and the equation: HC2H3O2(aq) H+(aq) + C2H3O2-(aq), to
determine [C2H3O2]eq and [HC2H3O2]eq.
Substitute these calculated concentrations into the Ka expression you wrote in Step 1 of
the Pre-Lab.
Compare your results with those of other students. What effect does initial HC2H3O2
concentration seem to have on Ka?
Name:
Date:
SCH4U
DATA TABLE
1. Assigned Concentration
mL
mL
2. Measured pH
3. Ka Expression
5. [H+]eq
6. [C2H3O2-]eq
7. [HC2H3O2]eq
8. Ka Calculation