SST 200
SST 200
Operational capability
The SST-200 turbine is developed to achieve high efficiency for generator drives combined with high reliability for mechanical drives, and is characterized by easy handling, facilitated by the modular package. SST-200 drivers are designed for automatic operation needing no special consideration during operation.
Power Generation
Operational exibility
Back pressure or condensing with internally controlled extraction and possibility of several bleeds allows the selection of optimal solutions for the industrial applications. Back pressure and condensing turbines are available with upward or downward exhaust. The blading design for industrial applications enables exibility of operation without disturbance for extensive and rapid changes of load. This design provides for high efficiency over the whole operation range, giving the customer highly exible plant operation. To ensure good steam consumption at full and part loads, the turbines are designed with ow control. A multi-stage control valve system incorporating very few and well protected parts ascertains reliable steam ow control.
Optimum performance
The turbine casing and casing components are designed to permit short start-up times. Internally controlled extraction gives high efficiency over a wide range of ow. The SST-200 rotor is tted with resonance-proof blading. The reliability of the blading is achieved primarily through a low total stress load on the blades. Rotor for a condensing turbine with resonanceresistant blading
1
H
Live steam conditions pressure .......................up to ........ 80 bar / 1160 psi temperature .................up to ........ 480 C / 896 F Bleed ..............................up to ........ 25 bar / 363 psi Controlled extraction pressure .......................up to ........16 bar / 232 psi temperature .................up to ........ 350 C / 662 F Exhaust steam conditions
back pressure ...............up to ........10 bar / 145 psi condensing ..................up to......... 0.6 bar / 8.7 psi All data are approximate and project-related.
Legend
1 Steam turbine 2 Base frame
Typical dimensions
L W H Length...... 4 m / 13.1 ft Width........2 m / 6.5 ft Height...... 2.5 m / 8.2 ft
Customer benets
Fast and early layout planning Short delivery time
Reference examples
SST-200 has been sold for a rich variety of applications around the world. The following references are typical examples of this versatility of application.
Abu Quir, Egypt, mechanical drive in test facility Tamoil, Switzerland, 2 turbines producing on average 5 MW each in mechanical drive application
10
30
Output (MW) 50
70
130
150 +
SST-200 steam turbines are part of a modern range of Siemens steam turbines developed to meet the most demanding customer requirements for cost-efficient power generation and mechanical drive applications in power plants and industrial environments. This is achieved by using a highly modularized system of state-of-the-art components with well proven design features. Its development is based on experience accumulated during a century of steam turbine design, manufacturing and operation.
The SST range of our turbines cover the complete spectrum from 2 to 180 MW and are available in back pressure, condensing and extraction design. The table above shows the Siemens full range of industrial steam turbines and their most important parameters. Whether you need a generator drive for power generation or a mechanical drive for compressors, blowers and pumps just tell us your needs and together we can select the optimum turbine or turboset which is most suited to respond to them.