Professional Documents
Culture Documents
Mini Preparation
Mini Preparation
Introduction
In this lab period, we will begin to determine whether we have any recombinant plasmids (positive clones). First, we will isolate plasmid DNA from two of the transformed bacteria. Next we will cut the recombinant plasmid with the appropriate restriction enzymes. After DNA digestion we will load an agarose gel and the results will be examined during our next lab period. The minipreparation of plasmid DNA, or miniprep, is a small-scale isolation of plasmid DNA from bacteria. Two main approaches have been used for this isolation; the first and more traditional technique is often a variation on the original protocol by Birnboim and Doly (1979). The second uses a special silica matrix to bind DNA and then release it under certain conditions. The matrix is often included in a spin-column. Many of the biotechnology companies sell kits for plasmid isolation that use this technology. We will use the traditional method for the miniprep and you will have an opportunity to use the spin-columns in other isolation procedures. LEARNING GOALS: 1. Understand the biochemical and molecular effects of each reagent used in the miniprep protocol. 2. Understand the difference in mobility between a DNA fragment and an intact plasmid. 3. Know the main conformations of uncut plasmid DNA and be able to recognize them on a gel. 4. Be able to recognize the major differences between bulk prep plasmid DNA (which is very pure) and miniprep plasmid DNA.
Page 1
Biol 312 L Molecular Biology Lab However, the purification is rather crude and may contain small pieces of chromosomal DNA. Rough pipetting can break off pieces of chromosomal DNA (shearing). Shearing will also break the supercoiled plasmid, producing the nicked circle or even the linear conformations and reducing the amount of desired supercoiled conformation. There may be traces of nucleases (DNase) that will degrade DNA and shows up as smearing in the gel lane. Finally, salts and other impurities will reduce the activity of restriction enzymes. Thus the miniprep is likely to have partial digests of the plasmid. Separate procedures are used for large-scale or bulk preps of plasmid DNA. These protocols may start with 25 - 1000 mL of bacterial culture.
Miniprep Solutions
1. (GTE) Alkaline Lysis Solution I 50 mM glucose 25 mM Tris-Cl (pH 8.0) 10 mM EDTA (pH 8.0) Glucose acts to maintain osmotic pressure, and the Tris buffers the cell at pH=8.0. The EDTA binds divalent cations in the lipid bilayer, which weakens the cell envelope. After cell lysis (next steps) EDTA limits DNA degradation by ++ binding (chelating) Mg ions that are a needed cofactor for bacterial nucleases. 2. (SDS/NaOH) Alkaline Lysis Solution II caution 0.2 N NaOH (freshly diluted from a 10 N stock) caution 1% (w/v) SDS This alkaline mixture lyses the cells. The SDS detergent dissolves the lipid components of the cell membrane and cellular proteins. Sodium hydroxide denatures both the chromosomal and plasmid DNA into single strands; the two strands of intact plasmid DNA remain intertwined. 3. (3 M KoAC/Acetic Acid) Alkaline Lysis Solution III 5 M potassium acetate, 60.0 ml caution glacial acetic acid, 11.5 ml H2O, 28.5 ml The acetic acid solution brings the pH to neutral, and the DNA strands can renature. The large chromosomal strands cannot rehybridize perfectly, but instead become a partially-hybridized tangle. Potassium acetate precipitates the SDS (with its lipids and proteins) from the solution. The SDS/lipid/protein precipitate traps the tangled chromosomal DNA. This creates the white goop that pellets after centrifugation. Only the plasmid DNA, small fragments of chromosomal DNA, and RNA remain in solution. 4. Isopropanol This alcohol rapidly precipitates nucleic acids. However, if allowed to sit for longer, proteins will also precipitate. Thus we time this step for a quick precipitaion before centrifugation. 5. Ethanol An ethanol wash helps remove salts and any remaining SDS as these can interfere with a restriction digest.
Page 2
Biol 312 L Molecular Biology Lab 6. TE buffer 10 mM Tris-Cl (desired pH) 1 mM EDTA (pH 8.0) ++ Tris buffers the DNA solution. EDTA binds divalent cations (especially Mg ions) that are a needed cofactor for bacterial nucleases and thus limits DNA degradation.
2. Fragment Resolution
There are limits to the ability of agarose to separate DNA fragments of different sizes. When two fragments are close together in size, they may appear as one band in the gel rather than two. For example; if you expect 6 DNA fragments and thus 6 bands on a gel but you see only 5 bands, then it is likely that two of the fragments have not resolved in the gel. It is termed a doublet when two fragments appear as one band. Carefully examine Figure 5.1 and notice that there are two doublet bands.
Biol 312 L Molecular Biology Lab like replication and transcription. The isolated supercoiled (sc) plasmid DNA is wound up into a compact structure. Imagine taking a circle of string and rolling it around in your hands until it forms a little ball. Because of its compact shape, sc DNA is the fastest moving conformation in the gel.
Figure 5.1: A ladder lane that contains two doublets. The ladder is a HindIII+BamHI digest of Lambda. This Figure also gives examples of the conformations of uncut plasmid DNA in the lane marked pGLO(-). This is not miniprep DNA and the lanes are clean.
B) Nicked Circle DNA (Form II) is also called relaxed circle. In bacteria, the enzyme topoisomerase I will nick one strand of the helix so that DNA polymerase has access to the DNA for replication. Once one of the strands has been cut, the superhelical tension relaxes and the tightly-wound ball becomes a floppy circle. A nick can also occur during isolation of the plasmid because of enzyme activity or mechanical shearing of the DNA. Nicked circle (nc) is the slowest conformation of uncut DNA. C) Linear DNA (Form III) is produced when a restriction enzyme cuts a plasmid at only one site. Both strands of the helix are cut at the same place. Linear DNA can occur because of endonuclease contamination of the isolated plasmid, or because of harsh treatment. On a gel the linear DNA will run between the sc and nc conformations (possibly closer to the sc band).
Page 4
Biol 312 L Molecular Biology Lab These are the three main conformations of single plasmid molecules, or monomers. However, under certain conditions, two plasmid molecules can join to form a dimer. Since the dimer form is twice as large as the monomer, it will run higher in the gel. It is possible to have sc, nc, and linear forms of the dimer. As with the monomeric plasmid, the sc will be the fastest conformation and the nc will be the slowest. It is also possible for more than two plasmid molecules to join and create high molecular weight multimers. It is usually difficult to distinguish conformations of multimers. We will concentrate on single plasmid molecules. Figures 5.2 - 5.4 show several examples.
Figure 5.2: In this cloning experiment, a fragment of Lambda DNA (LPCR) is inserted into the plasmid pBLU. The concentration of uncut pBLU (lane 6 from left) is low, so the linear conformation is faint. The LPCR fragment has small pieces cut from the ends. The first four samples from the left are student minipreps.
Figure 5.3: Very overloaded lanes of uncut plasmids pAMP and pKAN (how do we know these lanes are overloaded?). However, because there is so much DNA, all of the conformations are visible. HIII is a Lambda HindIII digest used as the ladder.
Page 5
Figure 5.4: Another example of the conformations of uncut plasmid DNA. Which plasmid is larger, the pAMP or the pKAN? How can you tell?
Figure 5.5: Several samples of miniprep DNA. M1 and M2 stand for miniprep one and miniprep two, respectively. The (+) or (-) represent WITH or WITHOUT restriction enzymes. Note the dark wells and the smear in some of the lanes. But overall, these are very good minipreps and all the minipreps show complete digests.
Page 6
Questions to ponder:
1. Explain why EDTA is an important component of TE buffer, which is used to dissolve the miniprep DNA. 2. Compare the lanes containing your miniprep DNA with the lanes containing control plasmid. Explain the possible reasons for variations.
Page 7
Biol 312 L Molecular Biology Lab 3. Identify the conformations of uncut plasmid in the control lane and in your uncut miniprep lanes. 4. Were any positive clones found in your class gels? How can we identify a positive clone?
Figure 5.6: Comparison of miniprep with bulk prep DNA. (left) Control DNA of uncut (UC) and cut (C) pAMP and pKAN plasmids. Note that the control DNAs are partial digests! The samples from student PM did not get RNase, and there is a heavy RNA cloud that can obscure any DNA bands in the area. (right) The first eight lanes are two sets of student minipreps, where the numbers 1 and 2 represent the two miniprep samples with (+) or without (-) restriction enzyme. These lanes show the smearing that can be found in miniprep DNA from digestion by DNase, and some of the wells appear darker from pieces of chromosomal DNA. One of the minipreps still has a very faint RNA cloud but this is not significant. Compare the control DNA with the miniprep DNA no smearing in the lanes and no dark staining in the wells. Did the controls cut to completion in this experiment? How can you tell?
REFERENCES Birnboim, H.C. and Doly, J. 1979. A rapid alkaline procedure for screening recombinant plasmid DNA. Nucleic Acids Res. 7: 15131523. Protocol obtained from CSH Protocols; 2006; doi:10.1101/pdb.prot4084 Ish-Horowicz, D. and Burke, J.F. 1981. Rapid and efficient cosmid cloning. Nucleic Acids Res. 9: 29892998.
Page 8