Professional Documents
Culture Documents
Untitled
Untitled
Lecture 1
Introduction to Soap And
Detergent, Soap Making And
Recovery of Glycerine
135
LECTURE 1
INTRODUCTION TO SOAP AND DETERGENT,
SOAP MAKING AND RECOVERY OF
GLYCERINE
INTRODUCTION
Soap is one of the oldest chemical produced over two thousand years ago by saponification
animal fats with the ashes from plants. Although soap are mainly used as surfactant for washing,
bathing cleaning, but they are also being used in textile spinning and as important constituent of
lubricating grease. Now soap and detergent have become integral part of our society. There has
been continuous development Soap making technology starting with batch kettle making process
in cottage industry and to present continuous modern soap making process using either fat
saponification or by fatty acid neutralization utilizing a wide variety of natural and synthetic feed
stock [Zhu et al., 2004]. Soaps are also key components of most lubricating grease which are
usually emulsion of, calcium, sodium, lithium soaps and mineral oil.
Synthetic detergent is an effective substitute of washing soap have become now very popular
replacing the soap. All soaps and detergents contain a surfactant as their active ingredient.
However detergent has better cleaning properties than soap because good detergency and has
increasingly popular. Environmental issues during initial stages because of non biodegradable
nature of the detergent caused major concern. With the production of linear alkyl benzene there
has been continuous increase in detergent production because of the biodegradable nature of the
detergent.
During 40s and 50s the detergent market was primarily captured by the dodecyl benzene
(DDB), a product formed by alkylation of benzene with propylene tetramer in a hard detergent
alkylation unit. However, that the branched structure of the alkyl group was responsible for the
poor biodegradability of the detergent, and the linear alkyl Benzene (LAB) was introduced in the
early 60s have substantially replaced its counter parts.
India is one of the largest producer of soap in the world. However, per capita consumption of
toilet bathing soap in India is 0.8 kg against 6.5 kg in USA, 4.0 kg in china, 1.1 kg in Brazil and
2.5 kg in Indonesia. Soaps are the largest portion of the fast moving consumer Goods (FMG)
136
markets with bathing soap and toilet soaps contributing about 30% of the soap market. In india
soaps are available in five million retail stores out of which 3.75 million are in the rural area. The
major player in the personal wash soap market are HUL, Nirma and P & G. In soap industry, the
popular sector has witnessed growth with toilet soaps [http://www.cirec.com/2011/01/soap-and-
detergent-industry-in-india].
Soap and Detergent differ in their action with hard water. Soap form insoluble compounds with
hard water containing calcium and magnesium ions which precipitates and reduce foming and
cleaning while detergent may react with the ions responsible for hardeness but the resulting
product is either soluble or colloidally dispersed in water [ Austin 1984].
SOAP
Soap is the alkali salt of fatty acid. Some of the important fatty acids used in soap manufacture
are lauric acid, myristic acid, palmitic acid, stearic acid, oleic acid, linoleic acid, linolenic acid,
reicinolenic acid. Fatty acids have varying chain length and may be saturated or unsaturated.
Fatty acid content of the oils vary. Unsaturated fatty acids give softer soap with lower melting
point and are less stable while soap from saturated fatty acids are firm, slowly soluble, milder
and have good detergency [Dixit,2011]. Total fatty acid is considered beneficial ingredient of
toilet soap. Property of soap depends on the chain length of fatty acids in blend, amount of
saturation and unsaturation, formulation and soap structure. A judicious blend of oils and fats are
necessary to obtain soaps of ideal properties.
Catogrisation of Soap
Soaps has been graded in terms of total fatty matter. Soap may be catogorised astoilet soaps or
bathing soap or specialty soap like baby( comparatively of high purity), transparent( soap with
high glycerine content), herbal and antibacterial soap. Bureau of Indian standards (BIS) has
catogrised on the basis of total fatty matter(TFM): Grade I ( Minimum 76%), Grade II(minimum
70%), Grade III(minimum 60%), bathing bar (minimum TFM 40%). Soft soap are made by
using potassium hydroxide instead of sodium hydroxide. Bathing bars may be made from partial
soap and partial detergent or wholly synthetic detergent
137
Raw Material
Soaps are commonly made from fats and oil and sodium hydroxide. Oils and fats can be
classified either lauric or nonlauric oils /fats. In soap making palm oil, coconut oil, caster
oil,neem oil, kernel oil, ground nut oil, ricebran oil and animal fat especially tallow are used.
Fatty acid present in tallow are mysteric acid, palmitic acid, stearic acid, oleic acid, linoleic acid
whereas the coconut oil contains lauric acid, mysteric acid, palmitic acid, stearic acid. Different
oils produce soaps of varying hardness, odour and lathering properties. Normally 75-85% tallow
and 15-25 % coconut oil is used in soap making. C
12
and C
14
soaps lather quickly but they
produce an unstable, coarse bubble foam while C
16
and C
18
lather slowly but lead to stable, fine
bubble foamed. For saponification caustic lye (50% caustic soda) is used. Some of the other
ingredient in soap are talc as filler which also act as carrier for perfume, fragrance. sodium
silicate to give firmness to the soap, sodium carbonate, dyes to impart colour
Soap Making Process
The soap making process consists of reaction of animal fats along with coconut oil with sodium
or potassium hydroxide. The traditional process consists of direct saponification of oil and fats in
batch process. The commercial process consist saponification in a kettle pan boiling batch
process or a continuous process The production of soap comprises saponification(soap making),
removal of glycerol, soap purification, finishing which consist of mixing and homogenisation of
the soap base with additive such as perfumes , coloring matter, skin grooming substances and
final extrusion, cutting shaping and packaging.
Basic Steps in Soap Manufacture are saponification, glycerine removal, soap purification,
finishing [Table M-IV 1.1]. Figure M-IV 1.1illustrate the process diagram for soap
manufacturing. Process for toilet soap bar making is shown in Figure M-IV 1.2
138
Figure M-IV 1.1: Soap Manufacturing Process Direct Saponification of Oils
and Fat and Glycerine recovery
141
Figure M-IV 1.2: Process of Toilet Soap Bar Making
GLYCERINE RECOVERY
Glycerol is important by product of soap manufacture. The process of soap manufacture from
fats and oils usually yield glycerol to about 10% of the value of the soap formed and because of
its application in many uses, its recovery is very important for better economy of soap
manufacture. Some of the major industrial application of glycerol include manufacture of alkyl
resins and flexible polyurethane for plastic industry. It is also an important ingredient of in
142
cosmetics and adhesive manufacture [Israel et al. 2008]. Sweet water from wash column and lye
from the static separator containing glycerol is processed for producing glycerine.
First step in glycerine recovery is the pretreatment of lye for removal of traces of soluble soap in
the lye. Ferric chloride is added to the lye to precipitate the soluble soap as ferric soap which is
separated by filtration. The acidic filtrate after removal of soap is acidic and contains excess
ferric chloride. This is treated with caustic soda and ferric chloride is separated as ferric
hydroxide precipitate which separated by filtration. The filtrate after removal of soap is sent to
evaporation section. In multiple effect evaporator dilute glycerine is concentrated to 52percent
glycerine. Some salt is separated at this stage. The concentrated liquor after separation of salt is
centrifuged and the concentrated glycerine is sent to another single effect evaporator to achieve a
concentration of about 84percent glycerine. This is called crude glycerine which is further
refined in special distillation column at 140
o
C and 755 mmHg. The distillation column contains
three condenser in series from which different fraction of glycerine are recovered which is
further treated with activated carbon to achieve the finished product.
SOAP REMOVAL: The spent lye contains a small quantity of dissolved soap which must
be removed before the evaporation process. This is done by treating the spent lye with ferrous
chloride. However, if any hydroxide ions remain the ferrous ions react with them instead, so
these are first removed with hydrochloric acid:
HCl + NaOH NaCl + H2O
The ferrous chloride is then added. This reacts with the soap to form an insoluble ferrous soap:
FeCl
2
+ 2RCOONa 2NaCl + (RCOO)
2
Fe
This precipitate is filtered out and then any excess ferrous chloride removed with caustic:
2NaOH + FeCl
2
Fe(OH)
2
(s) + 2NaCl
This is filtered out, leaving a soap-free lye solution.
Salt removal: Water is removed from the lye in a vacuum evaporator, causing the salt to
crystallise out as the solution becomes supersaturated. This is removed in a centrifuge, dissolved
in hot water and stored for use as fresh lye. When the glycerine content of the solution reaches
80 85percent, it is pumped to the crude settling tank where more salt separates out.
143
Glycerine Purification: A small amount of caustic soda is added to the crude glycerine and
the solution then distilled under vacuum in a heated still. Two fractions are taken off - one of
pure glycerine and one of glycerine and water. The glycerine thus extracted is bleached with
carbon black then transferred to drums for sale, while the water/glycerine fraction is mixed with
the incoming spent lye and repeats the treatment cycle.
REFRENCES
1. Austin G.T. Soap and detergent., Shreves Chemical Process Industries, 5
th
Edition,
McGraw Hill Publication, 1975, p.529
2. Dixit,S. Toilet soaps and bathing bars Chemical business, October,2011,p.18
3. Israel, A.U., Obot, I.B., Asquo, J.E. Recovery of glycerol from spent soap lye by-E-Journal
of Chemistry Vol 5, No.4, pp. 940-945, October, 2008 http://www.e-journal.net].
4. James A. K., Reigels Handbook of Industrial Chemistry 9
th
Edition, CBS Publication, 1997.
5. New Zealand institute of Chemistrynzic.org.nz/ChemProcess/detergents
6. Zhu S., Chambers J.G., Naik V., Encyclopedia of Chemical Technology Kirk-othmer, fifth
edition, Vol.22, 2004
7. http://www.cirec.com/2011/01/soap-and-detergent-industry-in-india.