Professional Documents
Culture Documents
Electrodag 550
Electrodag 550
Electrodag
550
Easy-Mixing, Stable
Highly Conductive
Nickel Coating
Features:
Smooth
Easy mixing
Stable electrical properties post heat cycling and humidity
(-40F/-40C to 160F/71 QC; 120F/49C and 95% RH)
Burnish resistant (electrical resistance minimally affected by wear)
Easy processing--air dries
Overcoatable by decorative top coatings with minimum affect on shielding and
decorative coating properties
Economical
Compatible with plastics commonly used in electronic equipment cabinetry
Easy handling/consistent properties
Overspray removable without stain
UL recognized
Typical Properties:
(as supplied)
Pigment
Binder
Pigment solids
Diluent
Typical Properties:
(when dried)
Density
Flash point
Theoretical coverage
Volume percent solids
Shelf life
VOC
: nickel
: acrylic
: 59.5%
: Acheson solvent blend SB-1, SB-8,
or SB-10 depending on substrate
: 13.5 Ib/gal
: 45F (7.2C)
: 405 sq ft/gal @? 1 mil
: 25.3%
: 12 months under original seal
: 656 g/l (5.46 Ib/gal) 5
Sheet resistance
Attenuation
Pencil hardness
Maximum service temperature
Information presented in this product data sheet is considered reliable, but conditions and methods of use, which are beyond our control, may modify
results. Before. adopting our products for commercial use, the user should confirm their suitability In no case should recommendations or suggestions
for the use of our products be understood to sanction violation of any patent
Surface Preparation
Surface should be clean and dry.
Mixing and Dilution
Thoroughly mix Electrodag 550 on a paint shaker before thinning. (Note: Since
Electrodag 550 is a slow/soft settling material, mixing time when compared to
conventional nickel coatings, can be substantially reduced.) For proper dilution, use a
ratio of 1:0.8 (product to solvent by volume).
Application
Electrodag 550 should be spray applied using conventional propeller-agitated
pressure pot spray systems. Small prototype runs may be sprayed with well mixed
product, using suction cup spray equipment.
A nominal 2.0 to 2.5 mil coating thickness is recommended for good shielding
performance. However, a thinner coating may be acceptable, depending on the
shielding requirements of the device being protected. Avoid dry spray for maximum
adhesion and conductivity.
During humid days, the addition of no more than 6 fluid ounces per gallon of
diacetone alcohol or butyl alcohol to Electrodag 550 will eliminate blushing. The
blushing is characterized by a white tint to the dried surface.
Drying
Electrodag 550 dries to touch in about 5 minutes; to handle in approximately 30
minutes, depending on ambient temperature.
Quality Control:
Mask Cleaning:
For high volume production where masks are often used to prevent coating
certain areas, the masks can be cleaned with lacquer thinner or ketone solvents.
Application Assistance: For additional information on production start-up with Electrodag 550, contact an
Acheson Application Specialist, Acheson Colloids Company, P.O. Box 611747, Port
Huron, Michigan 48061 -1747, (810) 984-5581.
Precautions:
Flammable. Harmful if swallowed, inhaled, or absorbed through skin. May cause eye
irritation. Wash thoroughly after handling. Keep away from heat, sparks, and open
flame. Keep container tightly closed when not in use. Use with adequate ventilation.
Avoid breathing vapor. (See Acheson Material Safety Data Sheet for proper first aid
instructions.)
Container Sizes:
Note:
OB-222.RV297