Ise-Iv-Microprocessors (10CS45) - Assignment PDF
Ise-Iv-Microprocessors (10CS45) - Assignment PDF
10CS45
Assignment Questions
UNIT- 1
1. Define Microprocessor, Microcontroller, Reprogrammable System, and an Embedded System.
2. What do you mean by the power of a Microprocessor? Mention the Architectural Parameters
to distinguish between Microprocessors.
3. Draw and explain the block diagram of microprocessor based system and also explain the
general sequence it follows to execute the instructions.
4.Distinguish between
Microprocessors.
Accumulator-Based
and
General
Purpose
Register
Based
Page 1
MICROPROCESSORS
10CS45
POP
Page 2
MICROPROCESSORS
10CS45
Page 3
MICROPROCESSORS
10CS45
UNIT - 7
1. Explain how a software delay program can be written for 100msec delay for an 8086 system
connected with 10MHz crystal.
2. Explain clearly the process of reading a WORD from an odd address in an 8086 system,
bringing out the necessity of performing two memory read operations in this case, as compared
to reading a WORD from an even address that requires only one memory read operation.
3. Bring out the differences between static and a dynamic RAM.
4. Interface eight 8K chips of RAM and four 8K EPROM with 8086. Interface the RAM bank at
a segment address 0B00h and the EPROM bank at a physical address F8000H. Do not allow any
fold bank space.
UNIT - 8
1. Discuss modes of operation of 8255 programmable peripheral interfaces.
2. Draw and explain a typical Stepper Motor Interface. Further, write an ALP to rotate a shaft of
a 4-phase stepper motor in clockwise by 5 rotations.
3. Write short notes on the following:
i) MACROS ii) Control of High Power devices using 8255.
4. What are the criteria to be considered before interfacing memory to the processor?
5.Interface a DAC 0800 to 8086 and write a program to generate a triangular waveform.
6. Interface a set of 8 simple switches and 8 simple LEDS to 8086 using a 8255 PPI chip. The
8255 should be selected for the following addresses. Write a program to indicate the status of the
switches on LEDs
port A:0740 H, port B:0742H, port C:0744H CWR:0746H.
***********************
Page 4