SF 430 Disassemply
SF 430 Disassemply
Note : Check the roller for any dirt. If dirty, wipe it off
with soft cloth dampened with IPA (Isopropyl
Alcohol). If the roller is heavily worn, replace
it with a new one.
Bushing
White Roller
Control Panel
3-1
Control panel
3-2
ADF Roller
ADF Roller
Exit shaft
CIS
Bracket
Spring
3-3
Main PBA
Scan motor assy
3-4
3-5
Bracket-LF
SMPS ground wire
3-6
LIU PBA
3-7
Guide Boss
Holder Rubber
Holder Rubber
Sheet ADF
Rubber ADF
Rubber ADF
Holder Rubber
Notes
Sheet ADF
Rubber ADF
Safely Precautions :
Do not force to open or fasten plastic material
components.
3. Clean the surface of the rubber pad with IPA
(Isopropyl Alcohol). After wiping it, be sure to dry
it. Check the rubber wear. If the wear reaches 1/2
its original thickness, replace it with a new one.
Pinset or
Screw Driver
3-8
Tie stopper
OPE unit
3-9
OPE PBA
Notes:
Do not turn the OPE unit upside down after you
remove the screws securing the PBA. Keys and
rubber contacts may be separated and easily lost.
When you reassemble the OPE unit, make sure
the keys are in correct position.
When you reassemble the PBA, secure the screws
according in the order of the number printed on the
PBA.
After reassembling, operate the machine to make
sure it works properly.
After reassembling, make sure the LCD is not
blocked.
3-10
Guide Extension
Main PBA
Dummy ASF
TX motor LF motor
CIS
USB
Speaker
LIU
OPE
Print Head
(CR Assy)
SMPS
Parallel
(IEEE1284)
3-11
3-12
CR shaft
FPC cable
Carriage assy
Sensor Lever
3-13
Feed Roller
Bearing Feed
3-14
3-15