G02 User Manual Gps Traker
G02 User Manual Gps Traker
G02 User Manual Gps Traker
(GPS+GSM+GPRS)
User Manual
Version 1.2
Please read this manual carefully before attempting installation and online
activation. Pictures are for indication and illustration purposes only.
1. Accessories
2. Specification
GSM: 850/900/1800/1900MHz
GPRS: Class 12, TCP/ IP
Voltage: 9-50vDC
Current:22mA12vDC
12mA24vDC
GPS positioning time: Cold start -38sec (open sky)
Warm start -32sec
Hot start -2sec (open sky)
GPS positioning precision: 10m (2D RM)
Temperature: -30 ~ +70
Humidity: 20% ~ 80% RH
Dimension: 90.0(L)x45.0(W) x13.5(H)mm
Weight: 45g
3. Function setting
Remarks: If you take GT02A to your country, please change the APN
parameter of the device (through sending SMS). You can ask your GSM
operator for APN.
Please SMS to the SIM card number which used in the GT02A.
APN,666666,APN name#
SERVER,666666,1,www.cooaccess.net,8821,0#
3.3
The GPRS time sending interval can be set to between 10s and 18000s.
The factory default setting for location updates is set at 10s.
3.5
4. Status indicator
4.1
Meaning
Power supply indicator,
Flashing
working normally
4.2
Meaning
4.3
GPS located
Meaning
Quick flashing
GSM initialization
No GSM signal
6.
Method of installation
6.2 Installing SIM card: each GT02A needs to insert a GSM SIM card.
The SIM card used should be enabled for GPRS.
1) Testing SIM card: to test SIM card, please install it into a normal GSM
mobile and ensure it can send and receive SMS, and enables for GPRS.
If there is an access password, or pin, please cancel it;
Testing GPRS network connection
2) Installing SIM card: Remove the upper cover of device, insert SIM
card as shown then replace cover, lock the shell with 3 bolts.
6.3 Selecting installation place and fixing it. There are two kinds of
installation: covert and non covert. If you need the covert installation,
please refer installation to an auto electrical contractor.
NOTE:
1) To prevent theft of the GT02A, the device should be installed as
covertly as possible.
2) Avoid placing the GT02A close to higher power electrical devices,
such as reversing radar, anti-theft device or other vehicle
communication equipment;
3) The GT02A should be fixed into position with cable ties or wide
double-side tape.
4) Your GT02A has built-in GSM antenna and GPS antenna. During
installation, please make sure the receiving side face is up, with no
metal object above the device to interfere with GPS reception. The
following places are suggested for installation:
- under the dash board below the front windshield;
- in the parcel shelf in the rear;
- in the front bumper( non-material face), please ensure the device cannot
get wet;
- Under the wiper version (non-metal), please ensure the device cannot
get wet;
7.
7.1
The standard voltage is 9V-50V, the red wire is the positive, the
7.3 After connecting the power cord, run the power cord plug to the
device. After installation, supply power to device.
7.4
7.5 Non covert installation: cigar lighter cord is optional, with 2A FUSE
for short-circuit over current protection. Please contact your dealer if this
mode is needed.
8. Power on/off
8.1
During normal operation, red power LED flashes, while blue GPS LED
and green GSM LED keep lighting. During signal searching process, GPS
or GSM LED will flash. If there is no light presenting on LEDs, the
device is not working normally.
8.2
10.2 If GSM can not receive the signals normally, please check whether
SIM card is installed correctly or there is no GSM signal at the location
you are, such as a basement parking, please drive to a place covered by
GSM signal reception.
10.3 If the red LED does not work when power is connected, please
check whether the fuse is blown. If so, please replace the fuse.
10.4 If the three LEDs do not turn on when power up, press the down
side key, if the three LEDs recover normally, the device is working
normally.
10.5 If you have enabled the web based tracking application, and the
GT02A displays off-line on the platform, please check 3 LEDs status
indicators first. You can check the status of the SIM card when you are in
an inconvenient situation. Please refer to the following steps:
1). Call the SIM card number of the device to check whether you can get
through.
2). Check whether the SIM card supports GPRS and a local APN.
3). Check the GSM/GPS reception area.
4). Check whether your SIM card charge is overdue.
5). Check if the connector and device is loose or the fuse has blown out.
11.
The GPRS web based tracking platform allows real time tracking with the latest
Google maps. There is also a playback feature that allows you to view where the
vehicle has been for up to 30 days in the past making it ideal for fleet management.