Professional Documents
Culture Documents
Coaxial Dipole
Coaxial Dipole
Assembly Details
July 2009 1
Hooking it Up
A conventional PL-259 UHF type coax
connector for RG-8 coax will actually screw
onto the bottom of the lamp tubing. The
threads are not a perfect fit, but will tighten
satisfactorily. The stainless whip runs down
all the way to the very tip of the PL-259 con- Figure 2 Details of final assembly of coaxial dipole.
nector. Solder it in there. Before doing so,
however, install all the pieces of the antenna
onto the threaded lamp tubing.
size, less obtrusive appearance and superior
Many hams may think that stainless merely need to provide enough space for
weatherproofing
as compared to a J-pole.
steel wont solder. It definitely will with a all the pieces of the antenna to go together.
I
had
a
48
inch
whip
on
hand
that
I
used
hot iron and acid flux. Scrape the end of the
ARRL Member John Portune, W6NBC,
whip and dip it in hydrochloric swimming uncut for my 146 MHz coaxial dipole and received a BSc in physics from Oregon State
pool acid. With a little action from the tip of a similar 17 inch uncut whip for 440 MHz. University in 1960, his General Radiotelethe soldering iron the whip will tin perfectly I merely cut the lamp tubing to an appropri- phone license in 1961 and his Advanced class
well. Before soldering, however, grind two ate length to fit the whips. What does matter, amateur license in 1965. He spent five years in
or three small side notches in the bottom however, is the length of the whip above the England as G5AJH and upgraded to Amateur
Extra class in 1985 to become a volunteer
end of the whip. A Dremel tool works well top of the lamp tubing as well as the length examiner (VE). John retired as a broadcast
for this. The notches will help the solder of the coaxial sleeve. These need to be close television engineer and technical instructor at
securely lock the whip into the tip of the to a /4. For 440 I used 612 inches, on 220, KNBC in Burbank and then from Sony
PL-259 connector. Neutralize any leftover 13 inches, and 19 inches for 146 MHz. These Electronics in San Jose, California.
John is active on many bands and modes,
antennas are quite broad band and will cover
acid with baking soda solution.
predominantly
from his HF RV mobile station.
Perhaps surprising to some, it really isnt the entire band in each case with these sizes.
He has written various articles in ham radio
No
cutting
or
pruning
is
necessary.
necessary to solder any other parts of the
and popular electronics magazines and remains
For ruggedness, or perhaps for stealth, active as a VE team leader, ham license teacher
antenna. There is adequate mating surface at
the joints for the RF to cross over efficiently. you can install the whole antenna inside of and Web site designer. You can reach John at
Do, however, seal all possible water access 2 inch PVC water or ABS soil pipe and close 1095 W McCoy Ln #99, Santa Maria, CA 93455,
spots with common silicone RTV glue and the ends with end caps. I live in a mobile or at [email protected].
home park where antennas are not permitted,
or plastic electrical tape.
but my landlord thinks my coaxial dipoles
Did you enjoy this article?
Make it for the Band You Like
(in ABS pipe) are vent pipes.
Cast your vote at:
www.arrl.org/members-only/
Try out one of these homebrew coaxial
There isnt an exact length required for
qstvote.html
the lamp tubing or the stainless whip. These dipoles. You may find you prefer its smaller
2 July 2009