Professional Documents
Culture Documents
3G Causes & Suggestions
3G Causes & Suggestions
Please check all AMR CODEC are enabled or not on WCELLor please check DT logs
where RRC connection setup, established & failed or rejected.
VIDEO CALL NOT WORKING:
Please check DT logs
Layer 3, RRC attempt failure
RRC registration failure (RAC/LAC combination should be created in SGSN)
HSDPA NOT WORKING:
Please check following parameters
HSDPA ENABLE
HSDPA 64QAM
HSDPA 16QAM LICENSE
There should not be any alarm on site related to HSDPA FAILURE or HSDPA
CONFIGURATION REJECTED by NODEB
HSDPA SLOW SPEED:
Please check following parameters
Parameter
PrxOffsetWPS
CIRForFDPCH
FDPCHCodeChangeEnabled
FDPCHEnabled
HSDPA64QAMallowed
HSUPA2MSTTIEnabled
PtxFDPCHMax
PtxFDPCHMin
PtxOffsetFDPCHSHO
UsersPerHSSCCHCode
HSDPAMPO
CPCEnabled
EDCHMinSetETFCIT0
window
value
WCELL_AC
8
WCELL_AC
-44
WCELL_AC
6
WCELL_AC
1
WCELL_AC
1
WCELL_AC
1
WCELL_AC
90
WCELL_AC
200
WCELL_AC
6
WCELL_AC
30
Wcell_PS
12
Wcell_PS
1
Wcell_PS
29
Over & above please check all SIM QoS PROFILE from HLRIt should be set to
maximum for all APN ( Access Point Node )
CELL RESELECTION & HANDOVER :
1. 2G to 3G : please check following parameters
Please check in 2g database, 3g neighbour is defined or not & vise versa
ADJW creationRun in 2g BSC
QqualminChange in RNC ( WCELL )
QRxlevminChange in RNC ( WCELL)
QSRCChange in BSC
QSRPChange in BSC
2. 3G to 2G :
ADJG creation : neighbours database will run in RNC.
3. 3G to 3G :
ADJS creation : will run in RNC
Also please check following parameters in BSC
1) Minimum FDD Threshold(FDM); Value: -16>>> Proposed -14db
This parameter defines a minimum Ec/Io threshold which must be exceeded before a non-GPRS
capable dual mode mobile is allowed to make a reselection from the serving GSM cell to an
adjacent WCDMA RAN cell that is using frequency division duplex (FDD) type access
technology/mode---0
2) FDD Cell Reselect Offset(FDD); Value: -32(default)---Proposed 0.
With this parameter you define a UTRAN cell reselection offset for non-GPRS capable dual mode
mobiles which are in the idle state.
The mobiles add the offset to the running average (RLA_C) of the received signal level of the
serving GSM cell and non-serving GSM cells. After that the mobiles compare the measured
RSCP values of UTRAN cells with signal levels of the GSM cells.
3) Threshold to search UTRAN cells (QSRI); Value: 7--OK
With this parameter you define the threshold for dual mode mobiles in idle state to search for and
to measure UTRAN neighbour cells introduced in 3G Cell Reselection list when a running
average of the received downlink signal level (RLA_C) of the serving cell is below (0-7) or above
(8-15) the threshold. This parameter is broadcast only on BCCH.
NOTE:
If the parameter value is 7, dual mode mobiles in idle state measure always neighbour UTRAN
cell(s). If the parameter value is 15, dual mode mobiles in idle state do not measure any of the
neighbour UTRAN cells.
GPRS-capable mobiles do not use this parameter if NCCR is active in the serving cell.
4) GPRS threshold to search UTRAN cells (QSRP); Value: 7---Ok
With this parameter you define the threshold for GPRS capable dual mode mobiles to search for
and to measure UTRAN neighbour cells introduced in 3G Cell Reselection list when a running
average of the received downlink signal level (RLA_C) of the serving cell is below (0-7) or above
(8-15) the threshold.
This parameter is broadcast on BCCH.
In case this parameter is broadcast on BCCH it shall be used only if GPRS cell re-selection
parameters for one or more cells are sent to the MS in a Packet Cell Change Order or Packet
Measurement Order message
NOTE:
If the parameter value is 7, GPRS-capable multi-RAT MSs measure always neighbour UTRAN
cell(s). If the parameter value is 15, GPRS-capable multi-RAT MSs do not measure any of
neighbour UTRAN cells.
GPRS-capable mobiles use this parameter only if NCCR is active in the serving cell.
5) Minimum CPICH Ec/Io level (MET); Value: -16---ADJC level----- Proposed -12
With this parameter you define the minimum CPICH Ec/Io level of an adjacent WCDMA RAN cell
for an inter-system handover attempt. The threshold level must be exceeded before the BSC is
allowed to trigger a handover attempt towards the adjacent WCDMA RAN cell.
2g to 3G
Proposed
values:
cell reselection
QSRI(QSearchI)
QSRP(QSearchP)
7
alway
s
(-12
db)
FDD(FDDQOffset)
FDM(FDDQmin)
3g to 2g
proposed
values:
(alway
s)
(alway
s)
cell reselection
QRxLevMin
QQualMin
Ssearch_RAT
(-53)
(-18
db)
2
(105db
m)
MULTI RAB SERVICE : File should be uploaded from MSS & HLR then only this
service can be activated.