Professional Documents
Culture Documents
Work Health and Safety
Work Health and Safety
Spring 2015
Page 1 of 10
Spring 2015
1 OVERVIEW
In this module, we will be looking at workplace safety issues in Australia, generally, including:
some of the challenges that workplaces face in implementing and maintaining safe systems of work.
The law also seeks to protect workers through the criminal law by imposing obligations on employers (and
others who may affect the safety of people at a workplace). The consequences of breaches these legislative
duties vary from improvement notices and on-the-spot fines from a regulator, to large fines and
imprisonment by order of a court. While work health and safety (WHS) (previously, occupational health
and safety or OHS) is often used to describe workplace safety in general, in the legal sphere it is a reference
to the criminal regulation of workplace safety. This is where we will be focusing most of our attention in
this unit.
In Australia, the law provides for the protection of workers through a variety of mechanisms. Under the
common law, employers owe a duty of care to employees. There is also a right under the law of
employment for an employee to refuse to follow a direction from his/her employer where the employee
may be put in danger. There has also been statutory intervention under the workers compensation
legislation to compensate employees for injuries sustained while at work and while travelling to and from
work. Such schemes also encourage the rehabilitation of employees. All of these schemes may be class as
civil law mechanisms.
2 HAZARDS, RISKS AND CONTROLS IN THE WORKPLACE
Page 3 of 10
Spring 2015
A hazard can be defined as something which has the potential cause harm to a persons health
and safety. This could include substances and work practices.
A risk is the chance or probability that the hazard will lead to harm to a persons health and safety.
A simple example of the above is a wet floor. The wet floor is a hazard in that it has the potential to cause
an injury if someone were to slip. The chance of someone slipping is a risk. The risk is higher if someone
the wet floor is in a busy area. A control of the risk might be to cordon-off the area or dry the area.
From a legal perspective, the identification of hazards and risk is important. An employer may be liable
under WHS legislation for merely failing to prevent a risk to a persons health and safety (i.e. it is not
necessary for there to actually be an injury).
Many businesses and undertakings in Australia are corporations. In line with trends in others areas of
regulatory enforcement, WHS legislation often imposes obligations directly on directors and managers of
corporations to implement safe systems of work or ensure that their corporation does so.
Page 4 of 10
Spring 2015
This involves eliminating (or substituting) the hazard that gives rise to the risk of injury.
For example, a risk of fall from a dug hole can be eliminated by filling in the hole.
Hazard
Elimination
Elimination
Isolation
This involves removing a person at risk from the hazard. For example, where an
employee is working with high voltage electrical power, switching the power supply off
is a form of isolation.
Engineering Control
Administrative Controls
Administrative controls are primarily directed at workers and how they approach a
hazard. Such controls include training, systems of safe work, rest breaks and rotations.
Worker
Minimisation
This involves using equipment to modify the envirnoment where the hazard is located.
An example of an engineering control would be a barricade around a hole or a noise
muffler.
A problem faced in many workplaces is how seriously workplace safety is taken by employers or employees.
While employers may have water tight contracts with employees and contractors and have an array of
safe work procedures and protocols, the extent to which contractors and employees practise a safe system
of work is also a hurdle in ensuring safe work practices.
A workplace that considers safety to be a high priority is said to have a safe work culture. There has been
considerable literature in the field of WHS and human resource management as to implementing such a
culture in workplaces. The following is an excerpt from M Quinlan et al, Managing Occupational Health and
Safety, 2009.
[75-983] Construction industry to tackle safety culture
The Federal Safety Commissioner (FSC) has announced a new and innovative framework to address the
safety culture and tackle the poor safety record of the construction industry. This article by OHS journalist
David West was first published at the CCH website on 26 October 2006.
Page 5 of 10
Spring 2015
The framework, A Construction Safety Competency Framework: Improving OH&S performance by creating
and maintaining a safety culture, was developed by the Cooperative Research Centre (CRC) for Construction
Innovation.
When applied, the framework creates a matrix of safety management tasks, safety critical positions and the
necessary safety competencies, collectively aimed at changing the culture of safety. Dean Cipolla, project
leader and John Holland Group safety manager said: The framework is all about culture change even though
it may look like an engineering document.
Over the past three years, the John Holland Group has been the testing ground for the framework, where it
has led to a 25% drop in accident and injury severity. Mr Cipolla is so encouraged by the results to date that
he believes that the framework can become an industry standard.
The FSC has also launched Safety Principles and Guidance A practical guide for improving occupational
health and safety (OHS) in the building and construction industry. This document promotes a level of
commitment to safety that goes beyond complying with legislative requirements, encouraging industry
participants to demonstrate a commitment to sustained improvement in OHS outcomes. The safety principles
and guidance are in keeping with the FSCs commitment to Priority 5 of the National OHS Strategy 2002
2012, which is to strengthen the capacity of government to influence OHS outcomes.
At the launch of the framework on 29 September 2006, Workplace Relations Minister Kevin Andrews called
it a practical tool and a positive way forward for companies wanting to reform the culture of the industry.
For its part, the Australian Government is also supporting OHS research through both the Australian Safety
and Compensation Council and the Office of the Federal Safety Commissioner, both organisations are
represented here this morning, Mr Andrews said.
This is important because, while the construction industrys OHS performance is improving, it is still a
long way short of best practice and too many Australians are still being killed and injured every year. The
2003 Cole Royal Commission found the occupational health and safety performance of the building and
construction industry was unacceptable.
The construction industry makes up 8% of the Australian workforce but accounts for more than 15% of all
fatalities in the workplace. In 20032004, there were 52 traumatic injury deaths within the construction
sector, which represents a 6.7 fatality rate per 100,000.
The office of the FSC was established a little over a year ago with the aim of improving the poor safety
record in the industry. It aims to use the leverage of the Australian Government as a major construction
client to bring about cultural and behavioural change.
The first year for the FSC has been one of consultation and cooperation with both the industry and state and
territory governments. FSC achievements and initiatives include:
the development and implementation of an accreditation scheme for companies contracting for
Australian Government building and construction projects
an investigation of how best to assist subcontractors with a systematic approach to OHS
the development of safety principles and guidance
the commencement of the development of a standardised and comprehensive system for measuring
the Australian building and construction industrys OHS performance.
A focus on culture
Mr Cipolla admitted that the safety record in the construction industry is not very good and said, we are at
a point where we need to see cultural change in the management of safety.
Page 6 of 10
Spring 2015
Until now the safety training for staff whether they are unskilled workers, tradesmen or engineers has been
ad hoc stuff by companies. The framework provides a baseline set of cultural and mechanical skills for all
employees.
We have identified the competencies needed by all workers in the industry to perform each safety
management task effectively.
The framework aims to identify staff positions critical to safety and the safety management tasks that need
to be performed well. For example, tenderers can have an impact on safety, as can general managers,
supervisors and tradespeople. Most positions are safety critical.
The framework identifies nine broad staff actions essential to a positive and effective safety culture,
including company values, demonstrating leadership, clarifying required and expected behaviour and
personalising safety performance. The framework then expands and explains these actions and indicates how
they work to influence the safety behaviour of employees and thereby improve overall safety performance.
The CRC claims that the nine actions can be introduced at no direct cost other than the time taken by
executive managers to visit sites.
In total we have identified 39 safety management tasks and have mapped the safety critical positions that
should be performing each activity. These have been formed into a matrix, which is the basis of the
framework, Mr Cipolla said.
For each of the 39 safety critical tasks, the framework lists in detail the steps that should be followed when
completing them, the knowledge and skills required to effectively complete the tasks and the behaviour that
should be undertaken while completing them.
Mr Cipolla pointed out that the framework may not only become the industry standard, but may also be
applied to other industries.
A lack of a safe work culture not only means that employees have higher exposure to risks, it also means
that any systems or procedures on paper are generally not able to be relied upon by employers seeking to
show that they did everything they could to prevent a risk.
As noted above, the consequences of breaching WHS duties involving criminal penalties including fines
and imprisonment. While a breach of WHS duties may amount to criminal offences, the actual process of
enforcement has some key differences when compared with traditional offences. In New South Wales,
for example, WorkCover (as opposed to the police) investigate breaches. Prosecutions were, until recently,
conducted in the Industrial Court (as opposed to the Local, District or Supreme Courts). Prosecutions
may be directed against companies (as opposed to only individuals). Unlike most common law offences,
WHS offences are absolute liability (i.e. the commission of a wrongful act is prohibited regardless of the
intention of the offender).
Criminal sanctions are used to regulate the conduct of businesses in a variety of contexts at both the state
and federal level. Examples include:
Page 7 of 10
Spring 2015
integrity in financial services (Australian Securities and Investments Commission Act 2001 (Cth)); and
financial reporting (Anti-Money Laundering and Counter-Terrorism Financing Act 2006 (Cth));
Breaches of these statutes can result in substantial fines to the company involved. It may also result in the
directors (or those directly involved in the breach) being personally liable to a fine or imprisonment.
A critical question in this subject, which is by no means unique to WHS law, is whether it is in fact necessary
to have a WHS regulatory framework when the law of negligence provides safeguards against unsafe
workplaces and systems of work. As we will see in the next seminar, under the law of tort, an employer
must take reasonable care not to expose its employees to health and safety risks. Similarly, the Work Health
and Safety Act 2011 (NSW) imposes a duty on employers (as persons conducting a business or an
undertaking) to ensure, so far as is reasonably practicable, the health and safety of its employees. The two
are not identical duties. The latter is more onerous. Nonetheless, there is a considerable overlap. The law
of negligence has long been recognised to deter undesirable behaviour. Perhaps the leading economic
explanation is provided by Judge Richard Posner in one of his extra-curial works.1 Posner argues that if a
person is made liable for damages for particular conduct, he or she will take greater precautions to avoid
such conduct. Another judge, Judge Guido Calabresi, a proponent of the market deterrence theory,
argued that the costs of accidents will be reduced if the cheapest cost avoider (the person causing the
injury) is made strictly liable to compensate an injured party.2
If the law of negligence protects workplace safety, why is there a need for a criminal law protecting the
same? The differences might be seen in the consequences. In criminal law, a breach of the law gives rise
to a criminal penalty. In civil law, a breach gives rise to an award of damages. As Professor John Coffee
notes, criminal law prohibits whereas civil law prices.3 Accordingly, and in economic terms, civil law
does not seek to stop behaviour but to compensate for the negative aspects of the impugned behaviour.
There are weaknesses with this approach including that the jurisprudence on the negligence in the
workplace continues to regard the duty of employers as an important one and not simply one to
compensate for non-conformance to standards by an employer.
Another potential issue with solely relying on the law of negligence is what Posner identified as being two
crucial ingredients which are also its potential shortcomings.4 First, civil law relies on a victim. In
negligence, the victim must have been injured in order to commence proceedings as negligence is not
actionable per se. Secondly, the only threat is compensation. As we will see from the nature of workplace
risks, often safety incidents will arise due to safety being overlooked in the operation of a business or
undertaking. If the benefits of running a risk-prone workplace (because, for example, it provides greater
output or low overheads) outweigh the risk of compensation, an employer is unlikely to be deterred from
Richard Posner, Economic Analysis of Law (Aspen Publishers, 6th ed, 2003) ch 6.
Cited in Andrew Burrows, Remedies for Breach of Tort and Contract (Oxford University Press, 3rd ed, 2004) 39-40.
3 John Coffee, Paradigms lost: the blurring of the criminal and civil law models and what can be done about it (1991-1992) 101 Yale
Law Journal 1875, 1876.
4 Richard Posner, Economic Analysis of Law (Aspen Publishers, 7th ed, 2007) 292.
2
Page 8 of 10
Spring 2015
the law of negligence alone. This suggests that criminal law may have a place. Even if it does, the question
that must then be considered is the extent to which the criminal law should regulate workplace safety.
5 THE IMPORTANCE OF WORKPLACE SAFETY
Workplace safety is an important issue for any business. Poor safety practices can expose workers to injury
and, in some cases, death. Aside from the importance of ensuring that workers are safe, businesses should
treat safety as a priority for the following reasons:
Workplace injuries inevitably lead to less productivity while injured staff member are recovering.
Businesses often measure this through an LTI (lost time in injury). The higher the LTI, the less
productivity (and increase in cost) for the business. It has been estimated that a business (on
average) will lose 10% of its profits due to injuries.
Businesses in todays environment have a high turnover of staff compared with business many
decades ago. Employees move from workplace to workplace. Poor workplace safety can foster a
negative image of the employer.
At a basic level, businesses can be exposed to litigation from injured workers and the families of
deceased workers. While insurance may cover loss arising from litigation, businesses may face
higher insurance premiums where there are frequent injuries leading to compensation claims.
Following the enactment of WHS legislation, businesses can be exposed to criminal liability.
Directors and managers may also be personally liable for breaches of such legislation by their
companies.
Page 9 of 10