Professional Documents
Culture Documents
Experiment N04-Cup Draw
Experiment N04-Cup Draw
I.I.T. Kanpur
EXPERIMENT NO.4
Cup Drawing through Hydraulic Press
OBJECTIVE
To draw a cup by cup drawing process and measure the drawing force and strain.
EXPERIMENT
To correlate the initial and final dimension of the job and to estimate the drawing forces
on draw a cup.
Drawing forces are measured using an IPA Load cell FC-074HO, capacity 70K kg; gauge 350
OHMS, for the measurement of drawing forces. Die steel tool (Die & punch) and cold rolled
steel work piece (1.0, 0.75, 0.6 mm) are used for the experiments.
BACKGROUND
In deep drawing, a cup shaped product is obtained from sheet metal with the help of a punch
and a die. The sheet metal is held over the die by means of a blank holder to avoid defects in the
product.
bending operation. Further the portion of the job between the punch and the die walls undergoes
a longitudinal drawing.
The major objective of our analysis is
(i)
to correlate the initial and final dimension of the job and
(ii)
to estimate the drawing force F.
And compare these results with the experimental result.
There will be three loads acting during deep drawing operation i.e. the Flange, bending and
pulling over die curvature. Total load will be addition of these three loads.
Assuming that r and are the principle stresses and is compressive so
d r r
0
dr
r
r
K
2
d r
2K
dr
r
By integrating
2 K
d r r dr
r 2 K ln r c1
Boundary condition at r=R, r
(1)
PH
Rt
PH = Holding pressure
Substituting boundary condition in equation (1)
PH
R
Rt
r
r 2 K ln
Fig. (4):
(2)
R
PH
Rot
Rd
r 2 K ln
rd t
t
rd
2
rd
2
t
rd rn = radius of neutral plane
2
Maximum strain =
Average strain
t
2rn
t
2rn
t
2
4rn
t
0
4rn
R
t
PH
2 K ln 0
(3)
Rot
4rn
Rd
Since sheet metal is pulled over the die curvature and if the angle of contact between sheet and
die is , total pressure required by the punch to draw the cup is
PH
R
t
2 K ln 0 e
4rn
Rd
Rot
(4)
(5)
PROCEDURE
1.
2.
3.
4.
5.
Set-up the experiment and let the instruments warm up for 15 minutes.
Measure drawing force on different sheet thickness.
Measure blank holding pressure.
Mark grid by stencil and permanent marker.
Evaluate the strain.
RESULTS
1. Evaluate the theoretical and experimental values of the drawing force.
2.
Evaluate the strain.
3. Tabulate the results as shown below.
Tool material: EN-31
Work material: Cold Rolled Sheet (0.02 C)
Shear strength: 400 N/mm2
S.
No.
Blank holding
pressure
Blank dia.(D).: ..
Cup dia. (d): .
Sheet thickness: (t1).
Sheet thickness: (t2).
Sheet thickness: (t3).
Drawing Force
Theo.
Expt.
REPORT
1. Present calculations for one set of reading and provide the tabulated results.
REFERENCES
1. Manufacturing Science by A. Ghosh & A.K.Malik
2. Production Engineering by Swadesh Kumar Singh
Final
thickness