Azurahorn
Azurahorn
Contact : [email protected]
*Auspost carton size limit 140cm girth (thats a tape wrapped around it).
International couriers are extremely expensive - approx wts and dims can be
supplied if you want to check it out. Couriers within Australia are
reasonable and I can supply estimates on request.
ACOUSTIC HORNS
AH-550
The AH-550 has a mouth diameter of 300mm
and an axial length of 205mm to a 1 throat.
Throat sizes can be made up to 2 diameter.
AH-425
The AH-425 has a mouth diameter of 420mm and
an axial length of 260mm to a 1.4 throat.
Commissioned by Lynn Olsen for the Beyond the
Ariel project (see thread on diy audio)
AH-340
The AH-340 has a mouth diameter of
600mm and an axial length of 340mm to
a 1.5 throat. The horn sports the
complete Le Clach flare back. Throat
sizes can be made down to 1.
AH-204
The standard AH-204 has a mouth
diameter of 800mm, with a throat of 170
mm (+/- as required) and an axial length of
310mm when made for 8 Lowthers. A
version with a mouth diameter of 650mm
can be made.
Throat sizes can be made for smaller cone drivers or compression drivers down to 2
from a one piece mould.
The Le Clach flare rate is 204Hz at 0.8 T factor calculated from a 168mm throat
size.
AH-160
The 160 was the original Azurahorn,
now available again from an accurate
new mould. This is a large horn with
950mm mouth. The axial length is
450mm when made for 8
Lowthers. .
Bass Horn
The ABH-50 Bass Horn is a 50Hz L-shape bass
horn with a mouth area of 7700 sq cm
proportioned to the Golden Mean. Throat
diameter is 170mm and overall length is approx
2.3m. The expansion is 48Hz / 0.6 Hypex
calculated using David McBeans HornResp.
Not available for sale offered as plans and inspiration only though I do have
moulds for the vertical section if needed by local die hard.
Horns are made to order and production runs are not necessary.
However capacity is limited. Colour is restricted to white.
The horns should be lightly faired to remove the hard glossy Fibreglass
look. This gives them a soft white silky finish, like alabaster. It makes a
good base for custom spray painting if desired.
Flanges may be cast onto the horn after cutting the throat to the
specified diameter. The mounting holes are then drilled. Alternatively
flanges can be pre-fabricated and bonded on.
Horns are packed safely in strong custom made cardboard cartons,
wrapped in bubble wrap and nested