Using Routers As An Access Point - Netgear
Using Routers As An Access Point - Netgear
Important: Do not connect the wireless router/access point to your network yet, as it
may have the same IP address as the router that's now connected to the Internet.
1. If the wireless router/access point is in the default state with the Configuration
Assistant running, disable it:
a. Select Start > Run, and type
http://www.routerlogin.com/CA_HiddenPage.htm
b. Select Disable Configuration Assistant.
2. Disconnect any cable connected to the wireless router/access point WAN port.
3. Connect the wireless router/access point to PC using Ethernet cable, as shown
below.
Extra Considerations
Separate the two devices to the edge of their wireless ranges, or else
Use different SSIDs.
4. If the router with Internet access is also wireless, you should configure different
wireless channels on each device. Use the non-overlapping wireless channels 1,6, and
11 to avoid wireless interference.
To Configure the Router with Internet Access
Connect to one of the wireless router/access point's LAN Ethernet ports, turn off its
DHCP server, and give the wireless router a static IP on your LAN:
You can now log in to the wireless router/access point at its new address of
http://192.168.1.99 and configure wireless features such as WEP and Access
Control List
UPnP, DMZ, Port Forwarding, and Port Triggering are not used on the wireless
router/access point, and it doesn't matter how they are configured.
1. Configure the LAN IP address to be within the same subnet as your PCs.
Take care not to use an IP address already being used.
Limit the number of addresses in the DHCP range and assign an IP
address outside of the range to the router you want to use as the
Access Point.
2. Disable DHCP on the wireless router/access point.
3. Connect one of the LAN ports on the wireless router/access point to a LAN port
on the Router.
4. Configure the SSID and any security settings on the wireless PCs to match the
wireless router/access point's SSID and security settings.
a. SSIDs must be the same on all wireless devices. (These are case-
sensitive: netGEAR is not the same as NETGEAR.)
b. Tip: Make sure the wireless PCs can connect before configuring WEP,
WPA-PSK, or other wireless encryption.
Potential Issues
1. DHCP configuration may not work reliably because the wireless router/access point
may not correctly relay DHCP information from the router. Workaround: Use static IPs
on the wireless PCs.
2. If your computers use static IPs, make sure the gateway is the IP address of the
router connected to the Internet, ie: 192.168.1.1
3. The routers DHCP servers IP range may overlap the statically assigned IP address
of the wireless router/access point. Workaround: Limit the DHCP range, and set the
static IPs outside of the DHCP range.