Serial Communications Module: Digital Drive
Serial Communications Module: Digital Drive
Control Techniques
UD71
Serial Communications Module
900
SO
2
I
L
AP
Digital Drive
A
PROV
UD71flyer 25/3/98 9:42 am Page 2
Hardware connections
The following table details the hardware connections for the EIA RS485 Specification
communications port.
Network
Pin EIA EIA EIA Host
RS485 RS485 RS232 9way RS485 and RS232 ports both optically-isolated
4 Wire 2 Wire SK1 Data rates from 4800 bits/sec to 19200 bits/sec
PL1 PL1
Up to 1200m network length at 19200 bits/sec
1 OV OV CD* CD*
2 Tx Tx/Rx** TXD RXD Up to 15 nodes without network repeaters
3 Rx Tx/Rx** RXD TXD Supports ANSIx3.28-2.5-4 protocol in slave mode
4 NC NC DTR* DTR*
5 NC NC OV OV
6 Tx Tx/Rx** DTR* DTR* Environment
7 Rx Tx/Rx** RTS* RTS* Ambient Temperature: -5C to +40C
8 NC NC CTS* CTS* Storage Temperature: -40C to +50C
9 NC NC NC RI*
Weight: 124g
(NC - no connection). Maximum Altitude: 4000m
* Depending on the host software being used it may not be necessary to connect the
Humidity: +5% to +95% at 40C,
terminals marked.
** Pins 2 and 3, and pins 6 and 7 must be connected together in two wire mode. non-condensing
F O R M O R E I N F O R M AT I O N C O N TA C T :