Professional Documents
Culture Documents
C1032 - 06
C1032 - 06
1
C1032 06
6.7 Width of woven wire plaster base shall be not less than statement documenting how the product has failed to conform
36 in. (914 mm). to the requirements of the specication.
6.8 Length of woven wire plaster base shall be in accor-
9. Certication
dance with Table 2.
9.1 When specied in the purchase order or contract, the
7. Inspection producer or supplier shall furnish a report certifying that at the
7.1 Inspection of the material shall be agreed upon between time of shipment, the materials were in compliance with the
the purchaser and the producer or supplier as part of the requirements of this specication.
purchase agreement. 10. Packaging and Package Marking
10.1 PackagingWoven wire plaster base shall be pack-
8. Rejection and Rehearing
aged in bundles, rolls or pallets.
8.1 Material that fails to conform to the requirements of this 10.2 MarkingWhen shipped for sale or resale, the name
specication shall be reported to the producer or supplier of the producer or the supplier and the brand and description of
promptly and in writing. The notice of rejection shall contain a the contents shall be legibly marked on each pallet, bundle or
roll. The quantity for bundles shall be square yards and number
TABLE 2 Minimum Length of Flat Sheets and RollsA of sheet per bundle. The quantity for pallets, bundles or rolls
Flat Sheets 100 linear in. (2.540 m)
shall indicate the mesh-opening size and wire thickness.
Rolls 150 linear ft. (45.72 m)
Rolls, with backing 100 linear ft. (30.48 m)
11. Keywords
A
Allowable variations shall be not more than 34 in. (19.0 mm) in width or 11.1 backing; base; cement plaster; at; gypsum plaster;
length. plaster; self-furning; woven wire
SUMMARY OF CHANGES
Committee C11 has identied the location of selected changes to this specication since the last issue,
C1032 04, that may impact the use of this specication. (Approved June 1, 2006)
(1) Combined Tables 1 and 2 into new Table 1. (3) Renumbered Table 3 as Table 2.
(2) Changed references to old Tables 1 and 2 to new Table 1
within the text of the specication.
ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentioned
in this standard. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk
of infringement of such rights, are entirely their own responsibility.
This standard is subject to revision at any time by the responsible technical committee and must be reviewed every ve years and
if not revised, either reapproved or withdrawn. Your comments are invited either for revision of this standard or for additional standards
and should be addressed to ASTM International Headquarters. Your comments will receive careful consideration at a meeting of the
responsible technical committee, which you may attend. If you feel that your comments have not received a fair hearing you should
make your views known to the ASTM Committee on Standards, at the address shown below.
This standard is copyrighted by ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959,
United States. Individual reprints (single or multiple copies) of this standard may be obtained by contacting ASTM at the above
address or at 610-832-9585 (phone), 610-832-9555 (fax), or [email protected] (e-mail); or through the ASTM website
(www.astm.org).