Professional Documents
Culture Documents
1 062 Qatar Reference
1 062 Qatar Reference
Reference
4 Project Management
4 Design, Configuration and Documen-
tation
4 Installation, Wiring and Testing
4 Commissioning
4 Training of KAHRAMAA’s personnel
for operation and maintenance
Substation Automation
Control and Protection System
At station level, SAS570 Substation Auto-
mation Solutions with proven functional-
ity including interlocking and automatic
sequences provide high-quality operator
support for control and monitoring of the
entire stations.
Print Server
Ethernet LAN
4x RER 111
GPS CLOCK Starcoupler
RECEIVER
Optical LON Interbay Bus
BAY Level (in Star Configuration)
Protection unit
RET 521 Bay control unit
REC 316*4
4 x 132kV Lines 2 x 132/66kV Trafo 132kV Bus Section 66kV and 11kV Feeders
Multi Service Communication on Optical Network
Communication Network
Back in the nineties KAHRAMAA started to In the supervisory center each equipment
use optical fibers for the communication be- can be supervised and all alarms can be
tween the substations and the power plants. collected and displayed. Based on this
Lately this network is now extended by centralised overview of the status of the
several new links and ABB is again supplying communication network fast and efficient
utility-grade FOX equipment which supports reaction is possible in case of failures.
all services requested to be interconnected: The new system is designed for transmis-
n Traditional voice signals (telephone sets) sion of real-time signals and operation in
n Trunk lines between analogue & digital the harsh environment of power utilities.
PAX/PABX All equipment is mounted into steel cabi-
n Data Transmission for SCADA (RTU) nets, configured and carefully tested in the
n Transmission of Metering Values ABB factory. - During installation special
n Data connections based on IP / Ethernet. attention was given to the reliable power
supply of the equipment where now 2 in-
The transport capacity in the FOX network is dependent supply lines are available - one
set to 155 Mbit/s (STM-1) which gives suffi- of them with an un-interruptable supply
cient reserves for the near future and eventual chain using batteries and chargers.
extensions. Further upgrading to STM-4 and
STM-16 is always possible without interrup-
tion of interconnected services. Teleprotection signalling with NSD570
As a standard solution KAHRAMAA is
requesting a dedicated solution with inde-
pendent links using redundant NSD570
equipment for the transmission of the
commands to protect the high voltage
lines. - As an integrated solutions, FOX
can support this service also.
Project Reference:
KAHRAMAA 132/66/11kV Gharafa South West
& 66/11kV Education City Substation
Optical Communication Network
The network consists of
n 1 completely new SDH ring with FOX515
multi-service equipment.
n 1 existing SDH ring with new access
multiplexers FOX515.
n Several dedicated NSD570 links to trans-
mit protection commands. FOX515 for multi-service communication on optical fibres
Existing RTU
NSD570 NSD570 NSD570
NSD570
NSD570
Gharafa
NSD570
132/66kV/11kV
NSD570 NSD570
Existing RTU
Existing RTU
© ABB Switzerland Ltd, June 2006. The right to modifications or deviations due to technical progress is reserved.
reliable and fully managed, for applications
in access, regional and backbone networks.
As network elements they fully comply with
relevant ITU-T recommendations.
n Optical Amplifiers: Cover all requirements
for optical communication links up to 300 km
without intermediate equipment. Standard
transmission capacities range from 155 Mbit/s
(STM-1) up to 2.5 Gbit/s (STM-16).
n PDH Microwave Radio: EL series, 7 GHz
band, 4 x E1, 8 x E1, 16 x E1, protected configu-
1KHA - 001 062 - REN 1000 - 06.06 - Printed in Switzerland