3600-2018 v2
3600-2018 v2
AS 3600:2018
Concrete structures
AS 3600:2018
This Australian Standard® was prepared by Committee BD-002, Concrete Structures. It was
approved on behalf of the Council of Standards Australia on 22 June 2018.
This Standard was published on 29 June 2018.
Engineers Australia
La Trobe University
Master Builders Australia
National Precast Concrete Association Australia
Steel Reinforcement Institute of Australia
University of Melbourne
University of New South Wales
University of Sydney
Standards Australia wishes to acknowledge the participation of the expert individuals that
contributed to the development of this Standard through their representation on the
Committee and through the public comment period.
Standards may also be withdrawn. It is important that readers assure themselves they are
using a current Standard, which should include any amendments that may have been
published since the Standard was published.
Detailed information about Australian Standards, drafts, amendments and new projects can
be found by visiting www.standards.org.au
Australian Standard®
This is a free 9 page sample. Access the full version online.
Concrete structures
COPYRIGHT
© Standards Australia Limited
All rights are reserved. No part of this work may be reproduced or copied in any form or by
any means, electronic or mechanical, including photocopying, without the written
permission of the publisher, unless otherwise permitted under the Copyright Act 1968.
Published by SAI Global Limited under licence from Standards Australia Limited, GPO Box
476, Sydney, NSW 2001, Australia
ISBN 978 1 76072 146 6
AS 3600:2018 2
PREFACE
This Standard was prepared by Standards Australia Committee BD-002, Concrete
Structures, to supersede AS 3600—2009.
The principal objective of this Standard is to provide users with nationally acceptable
unified rules for the design and detailing of concrete structures and members, with or
without steel reinforcement or prestressing tendons, based on the principles of structural
engineering mechanics. The secondary objective is to provide performance criteria against
which the finished structure can be assessed for conformance with the relevant design
requirements.
The following list indicates the major differences between this edition and the 2009 edition
of AS 3600:
This is a free 9 page sample. Access the full version online.
The terms ‘normative’ and ‘informative’ are used in Standards to define the application of
the appendices to which they apply. A ‘normative’ appendix is an integral part of a
Standard, whereas an ‘informative’ appendix is only for information and guidance.
This is a free 9 page sample. Access the full version online.
AS 3600:2018 4
CONTENTS
Page
Page
Page
SECTION 15 DIAPHRAGMS
15.1 GENERAL ............................................................................................................... 207
15.2 DESIGN ACTIONS ................................................................................................. 207
15.3 CAST IN-PLACE TOPPINGS................................................................................. 208
15.4 DIAPHRAGM REINFORCEMENT ........................................................................ 208
Page
APPENDICES
A REFERENCED DOCUMENTS ............................................................................... 252
B TESTING OF MEMBERS AND STRUCTURES.................................................... 254
D RESIDUAL TENSILE STRENGTH TEST FOR SFRC .......................................... 260
AS 3600:2018 - PDF
This is a free 9 page sample. Access the full version online.