Professional Documents
Culture Documents
Zeta PDF
Zeta PDF
ABSTRACT
This project envisages a zeta converter fed the maximum power as possible and dictated by
by photovoltaic module as input power source. A ambient operating conditions, a specific circuit
Zeta converter is a fourth-order DC-DC converter known as Maximum Power Point Tracker (MPPT) is
made up of two inductors and two capacitors and employed therefore, to maximize the efficiency of the
capable of operating in either step-up or step-down renewable energy system, it is necessary to track the
mode. The proposed scheme consists of a solar maximum power point of the PV array. In most
panel, a zeta dc-dc converter, and MPPT common applications, the MPPT is a DC-DC
controller. In this Maximum power point tracking converter controlled through a strategy that allows
is achieved by using Perturbation and Observation imposing the photovoltaic module operation point on
(P&O) method, also known as hill climbing the Maximum Power Point (MPP) or close to it. The
method, is popular and most commonly used in proposed scheme consists of a solar panel, a zeta dc-
practice because of its simplicity in algorithm and dc converter, and MPPT controller. In this Maximum
the ease of implementation. power point tracking is achieved by using
Perturbation and Observation (P&O) method, also
Keywords - Photo voltaic module, P&O algorithm, known as hill climbing method, is popular and most
Zeta Converter commonly used in practice because of its simplicity
in algorithm and the ease of implementation
I. INTRODUCTION
Nowadays a dc-dc converter is widely used II. ZETA CONVERTER
as power supply in electronic systems. A zeta A zeta converter is a fourth order non linear
converter is a fourth order dc-dc converter capable of system being that, with regard to energy input, it can
amplifying and reducing the input voltage levels seen as buck-boost-buck converter and with regard to
without inverting the polarities [1]. The reason being the output, it can be seen as boost-buck-boost
is that it includes two capacitors and two inductors as converter.
dynamic storage elements. Compared with a Cuk
or Sepic converters, the Zeta converter has
received the least attention.
Among the renewable options, solar PV
energy has been drawing increasing interest in recent
years as an alternative and important source of
energy for the future. Solar cells transform energy
from an essentially unlimited source „the Sun‟ into
useable electricity. PV systems constitute an
environmentally friendly alternative way for energy Fig.1 Basic Zeta converter circuit
production using the energy from the sun. PV system,
virtually zero running cost energy is the input source The ideal switch based realization of zeta
of power. They operate quietly without emissions, converter is depicted. A non-isolated zeta
even if the load increases. With recent developments, converter[2] circuit is shown in the fig.1 above.
solar energy systems are easily available for Although several operating modes are possible for
industrial and domestic use with the added advantage this converter depending on inductance value, load
of minimum maintenance. However, the output resistance and operating frequency, here only
power induced in the photovoltaic modules depends continuous inductor current „iL1‟ analyzed using the
on solar radiation and temperature of the solar cells. well known state-space averaging method[3] .
Photovoltaic modules have a very low conversion The analysis uses the following assumptions.
efficiency of around 15% for the manufactured ones. 1. Semiconductors switching devices are considered
Besides, due to the temperature, radiation and load to be ideal.
variations, this efficiency can be highly reduced. In 2. Converter operating in continuous inductor
fact, the efficiency of any semiconductor device current mode.
drops steeply with the temperature. In order to ensure 3. Line frequency ripple in the dc voltage is
that the photovoltaic modules always act supplying neglected.
2692 | P a g e
N. Sowmya Smitha Raj, Smt. B. Urmila / International Journal of Engineering Research and
Applications (IJERA) ISSN: 2248-9622 www.ijera.com
Vol. 3, Issue 4, Jul-Aug 2013, pp.2692-2696
2693 | P a g e
N. Sowmya Smitha Raj, Smt. B. Urmila / International Journal of Engineering Research and
Applications (IJERA) ISSN: 2248-9622 www.ijera.com
Vol. 3, Issue 4, Jul-Aug 2013, pp.2692-2696
The solar energy conversion using algorithm is selected and certain changes are made in
photovoltaic system and zeta converter circuit are the present work. The flow chart of the algorithm is
presented. The block diagram of proposed scheme shown in the Fig.6
with PV array is given in fig.5 below. The system
consists of following components: 1.) PV array
2.)Zeta converter 3.) MPPT system 4.) resistive
load.
2694 | P a g e
N. Sowmya Smitha Raj, Smt. B. Urmila / International Journal of Engineering Research and
Applications (IJERA) ISSN: 2248-9622 www.ijera.com
Vol. 3, Issue 4, Jul-Aug 2013, pp.2692-2696
SIMULINK MODELS:
Fig.7 Simulink model of PV cell
Fig. 8 Simulink model of P&O algorithm
2695 | P a g e
N. Sowmya Smitha Raj, Smt. B. Urmila / International Journal of Engineering Research and
Applications (IJERA) ISSN: 2248-9622 www.ijera.com
Vol. 3, Issue 4, Jul-Aug 2013, pp.2692-2696
Output waveforms of zeta converter with PV Converter“ , Trans. Ind. Electronics, vol. 36,
source with MPPT algorithm implementation no. 1, pp. 64-70, Feb.1989
[2] E. Vuthchhay, .Bunlaksananusorn , and H.
Input voltage: 100V Hirata “Dynamic Modeling and Control of a
Output voltage: 230V (boost mode, duty cycle=70%) Zeta Converter” Electrical
: 42V(buck mode, duty cycle= 30%) Engineering/Electronics, Computer,
Telecommunications and Information
Technology, 2008. ECTI-CON 2008. 5th
300
International Conference on Volume 2, 14-
17 May 2008 Page(s):969 – 972.
250
[3] Denizar Cruz Martins, Membsr IEEE &
Glaucio N. de Abreu. “Application of the
200
zeta converter in switched-mode power
supplies”. Power Conversion Conference,
output voltage
150
1993. Yokohama 1993. Conference Record
of the19-21 April 1993 Page(s):147 – 152..
C. Sudhakarababu and M. Veerachary “zeta
100
[4]
converter for power factor correction and
voltage regulation”. TENCON 2004. 2004
50
VI. CONCLUSION
Mathematical analysis of ZETA converter is
carried out for design values of the capacitor and
inductor. A simple power electronic controller for
interfacing PV array with the load has been simulated
using ZETA converter. The subsystems of overall
scheme such as PV array model, ZETA converter
model have been built and tested individually before
integrating to the overall system. A maximum power
point tracking algorithm has also been incorporated.
The simulation studies of the proposed scheme
MPPT have been carried out and the results are
furnished. The values of parameters used for
simulation are listed
REFERENCES
[1] J.J. Jozwik and M.K. Kazimierczuk, "Dual
Sepic PWM Switching Mode DC/DC Power
2696 | P a g e