Professional Documents
Culture Documents
Bridge Erection Method
Bridge Erection Method
The Team
Director : Kresno Hadi
Team Leader : Oka Muliono
Team Member
1. Suryanto
2. Darji Al Surip
3. Ali Nur Chamid
4. Lukman Hakim
5. Muhlisin
6. Muamar
7. Durjo (Replacement)
8. Aris Priyatin (Replacement)
9. Nasori (Replacement)
The Equipment
Prepare By Main Contractor
1. Crane 25 Tons including the operator and fuel
2. Generator Set for Electricity
3. Solid Wood 25x25
4. Steel Pipe 2.5 Inch
5. Blender with gas and air tank
Prepare by Erector
1. Impact tool and Moment Torque
2. Hydraulic Jack 50/25 tons
3. Tracker
4. Wire Cable 22 mm with link belt
5. Wrench
6. Hammer
7. Steel Saw
8. Electrical Wire for Impact Tools
9. Safety Standard Equipment for Workers
Time Frame
- 20 Days
The Method
Bridge Erection Method/Installation Steps :
1. Making Temporary Support using Solid Wood (Coconut
Wood/Pines) with width as same as the Bridge
2. Place Girder on the wood ( on the ground)
3. Install the vertical connection plate on the girder (left and Centre)
4. Place the Bearing on position in abutment
5. Joint the girders
6. Install The Horizontal Connection Plate
7. Place the Left Side Girder on the 2nd Row in abutment and
temporary support (Welding or Tightening)
8. Place the left side Girder on the 1st row in abutment and temporary
support
9. Place All Girders
10. Install the bracings
11. Install the diaphragm
12. All installed