Sistem Hidrolik Cat 320D
Sistem Hidrolik Cat 320D
Bookmarks X
*This document is best viewed at a
Options
screen resolution of 1024 X 768.
Features
Cover Page
To set your screen resolution do the following:
Tables RIGHT CLICK on the DESKTOP.
Component Select PROPERTIES.
Connector
CLICK the SETTINGS TAB.
Schematic
Machine Views
MOVE THE SLIDER under SCREEN RESOLUTION
Chassis View until it shows 1024 X 768.
Cab View CLICK OK to apply the resolution.
Engine View
*Due to different monitor sizes and PDF reader preferences
The Bookmarks panel will allow you to there may be some variance in linked schematic locations
quickly navigate to points of interest.
EC-C1
When only one callout is showing on a
machine view, clicking on this button will
Click on any text that is BLUE and make all of the callouts visible. This
underlined. These are hyperlinks button is located in the top right corner
that can be used to navigate the of every machine view page.
schematic and machine views.
FUNCTION KEYS
Switch Switch Switch
or Motor Variability
Spring
Two-way Three-Way Four-Way
CYLINDERS Fluid
(Adjustable)
Conditioner
Unidirectional Bidirectional
CONTROL
AB AB
Single Acting Double Acting
MOTORS Pressure
FIXED DISPLACEMENT Spring
P T P T Compensation
Normal Position Shifted Position Infinite Position
CHECK
Control Line Restriction
ACCUMULATORS Unidirectional Bidirectional
Valves (Variable)
VARIABLE DISPLACEMENT
Basic Spring Shuttle Pilot NON- COMPENSATED
Symbol Loaded Controlled Spring Loaded Gas Charged Line Restriction
Restriction
(Fixed)
Unidirectional Bidirectional
MAIN AUX.
Line Restriction
PILOT CONTROL Variable and Pressure
2-Section
RELEASED PRESSURE ROTATING SHAFTS Compensated
Pump
Unidirectional Bidirectional
External Return Internal Return
Attachment Pump: Variable and
REMOTE SUPPLY PRESSURE Pressure Compensated
COMBINATION CONTROLS
LINES MEASUREMENT
Solenoid Solenoid Solenoid Solenoid and Servo Thermal Detent Crossing Joining
or Manual and Pilot Pilot or Manual Pressure Temperature Flow
Push-pull Lever Manual Shutoff General Manual Push Button Pedal Spring Vented Pressurized Return Above Fluid Level Return Below Fluid Level
Reed Switch: A switch whose contacts are controlled by a magnet. A magnet closes the contacts of Harness Connector Serialization Code: The "C" stands for
"Connector" and the number indicates which connector in the
a normally open reed switch; it opens the contacts of a normally closed reed switch.
harness (C1, C2, C3, ...)
L-C12
Sender: A component that is used with a temperature or pressure gauge. 3E-5179
The sender measures the temperature or pressure.
T Its resistance changes to give an indication to the gauge of the temperature or pressure. 5A
Component
Relay (Magnetic Switch): A relay is an electrical component that is activated by electricity. Fuse (5 Amps) 9X-1123 Part Number
It has a coil that makes an electromagnet when current flows through it.
The electromagnet can open or close the switch part of the relay. 325-AG135 PK-14
Harness identification code:
This example indicates wire group 325, Wire Gauge
Solenoid: A solenoid is an electrical component that is activated by electricity. wire 135 in harness "AG". Wire Color
It has a coil that makes an electromagnet when current flows through it.
The electromagnet can open or close a valve or move a piece of metal that can do work. 1 Deutsch connector: Typical representation
of a Deutsch connector. The plug contains all
2 sockets and the receptacle contains all pins.
Magnetic Latch Solenoid: An electrical component that is activated by electricity and held latched by a
permanent magnet. It has two coils (latch and unlatch) that make electromagnet 1 Sure-Seal connector: Typical representation
when current flows through them. It also has an internal switch that places of a Sure-Seal connector. The plug and receptacle
2 contain both pins and sockets.
the latch coil circuit open at the time the coil latches.
RENR7157-07
October 2012
System 3 Prime
Tap Locations
Pressure, Sampling, and Sensor
Tap Schematic
Description
Number Location
CC Left Pump Negative Flow Signal Pressure E-1
DD Right Pump Negative Flow Signal Pressure E-1
EE Left Pump Delivery Pressure B-2
FF Right Pump Delivery Pressure A-2
GG Pilot Pump Delivery Pressure A-4
HH Left Pump Power Shift Pressure B-1
JJ Case Drain Pressure B-1
KK Right Pump Power Shift Pressure A-1
SOS Hydraulic Oil Sampling Port A-3
70- 7517 RNE R
, e ga P 42 i D
) se hc ni 82 x se hc ni 43 : s noi s ne m (
(TRAVEL) (UP)
BOOM (2)
SDr
SPi
(SWING)
(OUT) (IN) aL3
T-OUT2 STICK (1)
(LOCK) (R) (L)
SWING
(FWD) (BACK)
TRAVEL (L)
(FWD) (BACK)
TRAVEL (R)
ATCH
(OPEN) (CLOSE)
BUCKET
(UP) (DOWN)
BOOM (1)
BDr
(OUT)
STICK(2)
BR5
AR5
(IN)
NEGATIVE FLOW VALVE GP
VIEW ALL CALLOUTS
FWD
30
TOP VIEW
CC
2
DD
VIEW B
12
EE
JJ
17
10
KK
GG
FF
HH 18 11 SOS
19