Professional Documents
Culture Documents
97.4 ABC Course PDF
97.4 ABC Course PDF
this outcome is a
result of activation of
internal mechanisms for healing.”
E.Wale
SCENAR ABC
INTRODUCTION LEVEL
TRAINING COURSE
CONTENTS
2
WHAT IS A SCENAR and WHAT’S SCENAR THERAPY?
Historical Reference
3
In order to avoid making any medical claims, simply speak of the
experience of the Russians. “According to Russian research,
SCENAR therapy …..”
HOW DOES IT WORK?
• Regulates homoeostasis
• Intoxicated individuals.
4
WHAT CONDITIONS SCENAR CAN TREAT?
♦ Diseases of blood;
♦ Disorders involving immune mechanisms;
♦ Endocrine, nutritional and metabolic disorders.
ENT diseases;
Eye diseases;
Skin conditions;
Dental problems
• in burns,
• fractures,
• insect bites,
• allergic reactions;
• stress and mental depression, etc.
5
SCENAR 97.4
Dose
indicator
‘On’ 10 Off
indicator 59.3 Off
The SCENAR switches itself off after 5 minutes if no settings have been changed.
When ‘Nobody’ appears on the screen for 30 seconds, it switches itself off.
When switched on and after changing the power, the power level is displayed in the
top left hand corner of the screen for two seconds, after which it changes to a timer.
6
POWER
The strength of the impulses.
Is the situation
painful or an emergency
YES NO
Vague
7
MODE SELECTION
= ON / MODE SELECTION
BUTTON
Pressing this button changes the mode through the various options as shown below.
Diag =
F= Mod =
Z= Dmpf =
Intens =
After changing one of the modes, when you press the mode selection button again, the
mode that was changed reappears on the screen first.
8
DIAGNOSTIC MODE
Frequency
8 Apply to the skin and readings will appear. (more about these later)
9
MODULATION
4:1 3:1
Note: Pressing the buttons briefly will increase the modulation one step at a time and
if pressed and held down will circulate round the options until released.
10
Dmpf – DAMPING OF THE WAVE FORM
Damping is the change in the initial form of the signal. Damping
also controls the corresponding dynamic response of the organism
at action. Damping has to do with the shape of the wave, form
introduced into the body. For example, a sharp wave will elicit a
particular response and damping alters the properties of the
respond.
Sk1 Sk2 Sk3 Sk4
Sk4 Sk2
4 To change Dmpf down, press Sk3
Note: Pressing the buttons briefly will increase the damping one step at a time and if
pressed and held down, will circulate round the options until released.
11
HOW TO USE DAMPING
NO
YES
Sk 2 or 3
YES NO
Sk 4 or FmVar Sk 1 Sk Off
12
INTENSITY
Intensity is the number of impulses in each bundle at with frequency 59.3 Hz. In the
wave form, it denotes the number of peaks in the wave.
13
1 From factory default settings, press four times until “Intens “
appears on the screen.
Note: Intensity does not circulate round – only goes up to 8 and back down again,
depending on which button is pressed.
YES NO
14
Z – PULSE DELAY
Pulse delay is the time delay between peaks of the wave.
________________________________________________________________________
1 2 3 4 5 6 7 1 2 3 4 5 6 7 8 9
Z = 30 Z = 50
1 Obviously, there is no effect in changing Z unless the SCENAR is in Intens = 2
or above.
Note: Z does not circulate round. It only goes up or down according to which button
is pressed.
15
FREQUENCY
Frequency is the number of complete oscillations per second.
2 From factory settings, press six times until “Freq = 59,3 Hz“
appears on the screen.
Note: Pressing and releasing the button causes a change in small increments. Pressing
and holding causes a continuous change in frequency. However, at the following
numbers, 29.7, 59.3, 90.3, 121, 180, the numbers stop and it is necessary to release the
button and press again to continue changing.
Is condition degenerative?
YES NO
Is there Is there
severe pain? acute inflammation?
NO
YES
NO YES
YES
Is it a
Chronic Use 40 – 90HZ for
Condition? Y Use FM small muscle
groups
YES
NO
16
GENERAL GUIDELINES
• Ask the patient not to shower or bath two hours before and after
the treatment.
CURRENT COMPLAINTS
• Ask the patient to point with one finger (if possible) to what is
the most pressing problem right now. (usually pain)
• Ask the patient to recall anything about the pain eg. Character,
severity, timing, radiation etc.
17
SKIN SIGNS IN SCENAR THERAPY
Reaction of the organism
Examine the skin properly before, during and after the treatment. The
signs or treatment indicators will show where to work and dynamics of the
treatment process.
Primary Signs
Differences in the skin, which are apparent before treatment.
Hyperaemia / pallor
Focal pain
Itching / Rash
Local pain after treatment
Small Asymmetry
Example: when working in Diag 0 skin coloration changes in two
directions: redness and pallor. A small white patch within a red area
or vice versa, is called a small asymmetry and is important to treat
this.
18
NOTION - VECTOR
Direction of the movement of the electrode corresponding to the
direction of the reaction in the body.
General vector
Zonal vector
When working on the zone use the vector, which shows the most
of dynamics. Once you have achieved the dynamics, then you
can stop working on the zone.
GENERAL PRINCIPALS
Dynamics Stability
Asymmetry Small asymmetry
Combination Alternation
Opposition Cycle
LOCATION PRIORITY
• Secondary Factors to asymmetry
• Opposite Side
• Channel (Meridian)
• Gloves & Socks
• Treat horizontals rather than neurological dermatomes
• Treat until there is a change either BETTER or WORSE
(minutes to hours)
19
AIMS IN SCENAR THERAPY
To achieve dynamics.
We create dynamics
As a result you will see that the organism will represent the same constant
signs at the area which reflect a pathological focus:
In colour;
In the sound of the device;
In stickiness of the device on the skin;
In patients sensation of pain.
20
BASIC TREATMENT METHODS
Diag 0
• Place the SCENAR on the skin outside the area selected for
treatment.
• In Diag =0, move the SCENAR over the skin with firm
pressure looking for signs of asymmetry – redness, stickiness
etc.
Diag 1
• Then compare areas that have had a ‘dose’. The one with the
highest dose (threshold of the reaction) (see page 23) is
treated again until the relative speed of the reaction (second
number from left on the top line) becomes 0 (often a few
minutes).
21
WORKING IN THE SUBJECTIVE REGIME
DIAGNOSTIC = 0
When to use:
Move the device steadily (speed) and firmly (pressure) in one direction.
Start treatment at any presenting primary signs.
When you have achieved a asymmetry, change the action regime (Freq,
Mod, z, Dmpf, Intens or any combination of these). Work, looking for a
small asymmetry. Then work on the area of small asymmetry, varying the
direction of the electrode (4 directions), attempting to achieve a dynamic
change (in the pain, in the colour, in stickiness of the electrode, in the local
sensation, in the sound from the device). Ideally work until the sign
disappears or until an opposite sign appears.
• Change the action regime and extend the area of action along a
horizontal line or along a segment.
22
WORKING IN THE INDIVIDUALLY MEASURED
OUT REGIME
DIAGNOSTIC = 1
When to use:
• to localise symptoms
• to save time when looking for asymmetry
• to avoid healing crisis
• to optimise the action time
• If areas of small asymmetry have been revealed during the
treatment in Diag 0, you may work on them again in Diag 1.
The higher the bottom left figure (Initial Reaction), the better that
electrode position is to treat. By comparing readings from various areas, it
is possible to choose the best places to dose for optimum effect.
When an area is chosen to dose, the electrode is placed on the skin and a
‘dose’ is given. When the ‘dose’ is completed, the machine emits an audio
signal and a ‘*’ appears in the bottom right corner. The number in the
bottom right is also recorded and can be compared to others for further
treatment.
If the SCENAR is placed on the skin and the sound of the multi-tone rings
immediately, remove the SCENAR from the skin and place it back.
Continue to do this until contact is established and treat this area.
When the IR (left bottom corner) and Dose (bottom right corner) are the
same in two areas, ie. there is no difference between areas, choose the area
for treatment with the lowest dynamic based on the form coefficient. (See
instruction manual p18).
23
PROTOCOLS FOR SCENAR
Is there a diagnosis?
YES NO
In order to increase the benefits of treatment, work on the symmetrical zones (explain).
It is not possible to work on pain spots because of open wounds, plaster or bandages,
you should work on zones symmetrical to the painful area.
FREQUENCY OF TREATMENT
YES NO
24
SCENAR SETTINGS
Settings Acute Inflammation Chronic Aggravation of
Inflammation Chronic process
Power High Comfortable High/Comfortable
Modulation 3:1 1:1 FmVar 3:1 5:1 3:1 FmVar
Damphing Sk2 / Sk3 Var Sk4 / Var
Intencity 1-8 1 1-8
Diag 1
Mod – Off
Damph – Off
Intens – Off
Z – 20
Frequency – 59.3 Hz
Adjust power to comfortable sensation and do not change the power until
you complete the diagnostics.
25
ZONES FOR GENERAL ACTION IN SCENAR
THERAPY
There are general and specific zones in Scenar Therapy.
2 Collar zone;
3 Palm
5. Meridians
6. Reflexive zones
26
REFLECTIVE ZONES IN SCENAR THERAPY
Stomach
Small Intestine
Genital organs
Ears
Lung
Heart
Gall
Gallblad
bladder
Fig. 13. A scheme of the location of the foot zones and pointsand Pancreas
Spleen
27
28
ZONES FOR GENERAL ACTION
C7
Liver
Pancreas
Liver Ovaries
(back surface)
zone
Collar zone
SSN
Abdomen Adrenals
“Palm”
Scrotum
, Adrenals,
27