Department of Mechanical Engineering Me6501Computer Aided Designquestion Bank Unit - I Part A
Department of Mechanical Engineering Me6501Computer Aided Designquestion Bank Unit - I Part A
www.studentsfocus.com
computer terminal.
20. What is meant by clipping? Explain with the help of a diagram.
Part-B
1. Elaborate on the basic requirements that a CAD software has to satisfy.
2.Distinguish between modes of the design process and models of designs.
3. Describe the various database models which are generally used.
4. What are the differences between the sequential approach to the product
development process and the concurrent engineering approach?Why should the
latter be adopted?
5. A scaling factor of 2 is applied in the Y direction while no scaling is applied in
the X direction to the line whose two end points are at coordinates (1, 3) and (3,6).
The line is to be rotated subsequently through 300, in the counter
clockwisedirection. Determine the necessary transformation matrix for the
operation and the new coordinates of the end points.
6. What are the reasons for implementing a computer aided design system.
7.The vertices of a triangle are situated at points (15, 30), (25, 35) and (5, 45). Find
the coordinates of the vertices if the triangle is first rotated 100' counter clockwise
direction about the origin and then scaled to twice its size.
8. Describe the basic types of coordinate transformation in CAD,and then show
how these may all be calculated using matrix operations through the homogeneous
coordinate with an example of matrix .How may a general rotation transformation
be expressed in terms of a combination of other transformation..
9.What is meant by Interactive Computer Graphics? Explain its various elements
10. Briefly explain the Clipping and Line drawing with an example.
www.studentsfocus.com