Specification For The Application of Thermal Spray Coatings (Metallizing) of Aluminum, Zinc, and Their Alloys and Composites For The Corrosion Protection of Steel
Specification For The Application of Thermal Spray Coatings (Metallizing) of Aluminum, Zinc, and Their Alloys and Composites For The Corrosion Protection of Steel
00
Specification for the Application of Thermal Spray
Coatings (Metallizing) of Aluminum, Zinc, and
Their Alloys and Composites for the Corrosion
Protection of Steel
SSPC-SP 1
UV light Test/ Solvent evaporation test to confirm
Degreasing solvent free surface.
Compressed air shall be checked for oil & moisture
Air Test presence as Per ASTM D 4285.
Surface profile Min 70 1. NACE No 2 Near white metal finish,
µm verify using SSPC VIS 1.
2.Steel surface temp at least 3°C above dew point,
RH should be below 80%.
3.Angular Profile Measurement ASTM D 4417
Method C Replica tape. one measurement every 10
to 20 m2.
4.Clear cello tape test to confirm absence of dust as
per ISO 8502-3
5. Method for testing Soluble salts as ISO 8502-6
and ISO 8502-9.
Masking 1. All fit & function surfaces
2.Overspary control areas
3. Areas not to be TSC
Blasting Media ( Should 1. Copper Slag, Size G16 to G 24,
be free from oil 2.Blasting media Selection as per As per SSPC AB1.
contamination, sodium 3. Salt in Blasting media Contamination measured
chloride, sulphur salts) As per ASTM D 4940.