Safety Data Sheet: Delo Gold Ultra SAE 15W-40
Safety Data Sheet: Delo Gold Ultra SAE 15W-40
Eye: No specific first aid measures are required. As a precaution, remove contact lenses, if worn, and
flush eyes with water.
Skin: No specific first aid measures are required. As a precaution, remove clothing and shoes if
contaminated. To remove the material from skin, use soap and water. Discard contaminated clothing and
shoes or thoroughly clean before reuse.
Ingestion: No specific first aid measures are required. Do not induce vomiting. As a precaution, get
_____________________________________________________________________
EXTINGUISHING MEDIA: Use water fog, foam, dry chemical or carbon dioxide (CO2) to extinguish flames.
GENERAL CONSIDERATIONS:
Consider the potential hazards of this material (see Section 2), applicable exposure limits, job activities, and
other substances in the work place when designing engineering controls and selecting personal protective
equipment. If engineering controls or work practices are not adequate to prevent exposure to harmful
levels of this material, the personal protective equipment listed below is recommended. The user should
read and understand all instructions and limitations supplied with the equipment since protection is usually
provided for a limited time or under certain circumstances.
_____________________________________________________________________
Attention: the data below are typical values and do not constitute a specification.
Color: Amber
Physical State: Liquid
Odor: Petroleum odor
Odor Threshold: No data available
pH: Not Applicable
Vapor Pressure: <0.01 mmHg @ 37.8 °C (100 °F)
Vapor Density (Air = 1): >1
Boiling Point: 315°C (599°F)
Solubility: Soluble in hydrocarbons; insoluble in water
Freezing Point: Not Applicable
Density: 0.872 kg/l @ 15°C (59°F) (Typical)
Viscosity: 18.1 mm2/s @ 100°C (212°F) Minimum
Octanol/Water Partition Coefficient: No data available
FLAMMABLE PROPERTIES:
Flashpoint: (Cleveland Open Cup) 215 °C (419 °F) Minimum
Autoignition: No data available
Flammability (Explosive) Limits (% by volume in air): Lower: Not Applicable Upper: Not
Applicable
_____________________________________________________________________
Skin: Contact with the skin is not expected to cause prolonged or significant irritation. Contact with the skin
is not expected to cause an allergic skin response. Not expected to be harmful to internal organs if
absorbed through the skin.
Acute Dermal Toxicity: The acute dermal toxicity hazard is based on evaluation of data for similar
materials or product components.
Skin Irritation: The skin irritation hazard is based on evaluation of data for similar materials or product
components.
Skin Sensitization: The skin sensitization hazard is based on evaluation of data for similar materials or
product components.
Inhalation: Not expected to be harmful if inhaled. Contains a petroleum-based mineral oil. May cause
respiratory irritation or other pulmonary effects following prolonged or repeated inhalation of oil mist at
airborne levels above the recommended mineral oil mist exposure limit. Symptoms of respiratory irritation
may include coughing and difficulty breathing.
Acute Inhalation Toxicity: The acute inhalation toxicity hazard is based on evaluation of data for similar
materials or product components.
During use in engines, contamination of oil with low levels of cancer-causing combustion products occurs.
Used motor oils have been shown to cause skin cancer in mice following repeated application and
continuous exposure. Brief or intermittent skin contact with used motor oil is not expected to have serious
_____________________________________________________________________
ECOTOXICITY
This material is not expected to be harmful to aquatic organisms. The product has not been tested. The
statement has been derived from the properties of the individual components.
This material contains one or more components that have a branched alkylphenol impurity that is highly
toxic to aquatic organisms (disclosed in section 3). The components containing the impurity have been
tested and are not toxic to aquatic organisms. Therefore the data in Section 3 for the alkylphenol impurity
should not be used to classify the product for aquatic toxicity.
MOBILITY
No data available.
POTENTIAL TO BIOACCUMULATE
Bioconcentration Factor: No data available.
Octanol/Water Partition Coefficient: No data available
Use material for its intended purpose or recycle if possible. Oil collection services are available for used oil
recycling or disposal. Place contaminated materials in containers and dispose of in a manner consistent
with applicable regulations. Contact your sales representative or local environmental or health authorities
for approved disposal or recycling methods.
The description shown may not apply to all shipping situations. Consult 49CFR, or appropriate Dangerous
Goods Regulations, for additional description requirements (e.g., technical name) and mode-specific or
quantity-specific shipping requirements.
Land Transport New Zealand Shipping Description: NOT REGULATED AS DANGEROUS GOODS
FOR TRANSPORTATION UNDER THE NEW ZEALAND LAND TRANSPORT RULE
_____________________________________________________________________
CHEMICAL INVENTORIES:
All components comply with the following chemical inventory requirements: AICS (Australia), DSL
(Canada), EINECS (European Union), ENCS (Japan), KECI (Korea), PICCS (Philippines), TSCA (United
States).
Prepared according to the Hazardous Substances and New Organisms Act 1996 and Approved Code
of Practice: Preparation of Safety Data Sheets (HSNO CoP 8-1 09-06) by the Chevron Energy
Technology Company, 100 Chevron Way, Richmond, California 94802.
The above information is based on the data of which we are aware and is believed to be correct as of the
date hereof. Since this information may be applied under conditions beyond our control and with which we
may be unfamiliar and since data made available subsequent to the date hereof may suggest modifications
of the information, we do not assume any responsibility for the results of its use. This information is
furnished upon condition that the person receiving it shall make his own determination of the suitability of
the material for his particular purpose.
MSDS
_____________________________________________________________________