Professional Documents
Culture Documents
C933 PDF
C933 PDF
1
C933 – 09
5.5 Weight—The nominal weight, exclusive of backing, producer or supplier promptly and in writing. The notice of
shall be from 1.14 to 1.95 lb/yd2 (0.618 to 1.058 kg/m2). rejection shall contain a statement documenting how the
Permissible variation in percentage over and under the nominal welded wire lath has failed to conform to the requirements of
weights shall be in accordance with mill tolerances. the specification.
6. Sampling
9. Packaging and Package Marking
6.1 When specified by the purchase agreement, samples of
welded wire lath shall be taken at the place of manufacture or 9.1 Welded wire lath shall be packaged in bundles or rolls.
at the place of destination. If samples are taken at the 9.2 Unless otherwise required by the purchase agreement,
destination, such samples shall be taken within 24 h of the lath shall have legibly marked thereon the following: the
receipt of the material. product description; the name of the producer or seller; the
6.2 At least 0.25 % of the number of sheets of welded wire brand name (if any); and the ASTM designation for the
lath in a shipment, but not less than three sheets, shall be so product.
selected as to be representative of the shipment and shall 9.2.1 Each bundle or roll of lath with no backing shall be
constitute a sample for the purpose of tests by the purchaser or marked with metal or paper tags securely attached to the
user. bundles or rolls.
7. Inspection 9.2.2 Each sheet of lath with backing shall be marked on the
7.1 Inspection of the welded wire lath shall be agreed upon backing material.
between the purchaser and the producer or supplier as part of
the purchase agreement. 10. Keywords
SUMMARY OF CHANGES
Committee C11 has identified the location of selected changes to this specification since the last issue,
C933 – 07b, that may impact the use of this specification. (Approved July 15, 2009)
(1) Revised 4.1.3 to change the embedment depth from 1⁄8 in.
to 1⁄4 in.
ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentioned
in this standard. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk
of infringement of such rights, are entirely their own responsibility.
This standard is subject to revision at any time by the responsible technical committee and must be reviewed every five years and
if not revised, either reapproved or withdrawn. Your comments are invited either for revision of this standard or for additional standards
and should be addressed to ASTM International Headquarters. Your comments will receive careful consideration at a meeting of the
responsible technical committee, which you may attend. If you feel that your comments have not received a fair hearing you should
make your views known to the ASTM Committee on Standards, at the address shown below.
This standard is copyrighted by ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959,
United States. Individual reprints (single or multiple copies) of this standard may be obtained by contacting ASTM at the above
address or at 610-832-9585 (phone), 610-832-9555 (fax), or [email protected] (e-mail); or through the ASTM website
(www.astm.org).