Professional Documents
Culture Documents
55-3 (Physics) PDF
55-3 (Physics) PDF
H$moS> Z§.
Series : GBM/C
Code No. 55/3
. - -
Roll No.
Candidates must write the Code on
the title page of the answer-book.
:
(i) - 26
(ii) - 5 -, -, -, - -
(iii) - 5 , 1 - 5 , 2 -
12 , 3 - 4 -
3 , 5
55/3 1 [P.T.O.
(iv) - , ,
(v) ,
c = 3 108 m/s
h = 6.63 10–34 Js
e = 1.6 10–19 C
0 = 410–7 Tm A–1
0 = 8.854 × 10–12 C2 N–1 m–2
1
= 9 109 N m2 C–2
40
= 9.1 10–31 kg
= 1.675 × 10–27 kg
= 1.673 × 10–27 kg
= 6.023 × 1023
= 1.38 × 10–23 JK–1
General Instructions :
(i) All questions are compulsory. There are 26 questions in all.
(ii) This question paper has five sections : Section A, Section B, Section C, Section D
and Section E.
(iii) Section A contains five questions of one mark each, Section B contains five
questions of two marks each, Section C contains twelve questions of three marks
each, Section D contains one value based question of four marks and Section E
contains three questions of five marks each.
(iv) There is no overall choice. However, an internal choice has been provided in one
question of two marks, one question of three marks and all the three questions of
five marks weightage. You have to attempt only one of the choices in such questions.
(v) You may use the following values of physical constants wherever necessary :
c = 3 108 m/s
h = 6.63 10–34 Js
e = 1.6 10–19 C
0 = 410–7 Tm A–1
0 = 8.854 × 10–12 C2 N–1 m–2
1
= 9 109 N m2 C–2
40
Mass of electron = 9.1 10–31 kg
Mass of neutron = 1.675 × 10–27 kg
Mass of proton = 1.673 × 10–27 kg
Avogadro’s number = 6.023 × 1023 per gram mole
Boltzmann constant = 1.38 × 10–23 JK–1
55/3 2
–
SECTION – A
1. , ? 1
Why must both the objective and the eye piece of a compound microscope have short
focal lengths ?
2. , A
B 1
In the figure given, mark the polarity of plates A and B of a capacitor when the
magnets are quickly moved towards the coil.
3.
?
1
State two reasons why high frequency carrier waves are needed in transmitting a
message signal.
5. +Q
1
A point charge +Q is placed in the vicinity of a conducting surface. Draw the electric
field lines between the surface and the charge.
55/3 3 [P.T.O.
–
SECTION – B
6. -
? 2
“ ”
State two properties of photons. For a monochromatic radiation incident on a
photosensitive surface, why do all photoelectrons not come out with the same energy ?
Give reason for your answer.
OR
A photon and a proton have the same de Broglie wavelength. Show, by actual
calculations, which has more total energy.
7.
2
Distinguish between nuclear fission and fusion. Explain how the energy is released in
both the processes.
8. , emf 4 V 1 , 5 10 V
d.c.
2
9. ‘ ’ ‘’ -
2
(ii) 2
(ii) In the following ray diagram, calculate the speed of light in the liquid of
unknown refractive index.
SECTION – C
11. LED V-I LED
LED
(a) , (b) 3
Draw the V-I characteristic of an LED. State two advantages of LED lamps over
conventional incandescent lamps. Write the factor which controls (a) wavelength of
light emitted, (b) intensity of light emitted by an LED.
55/3 5 [P.T.O.
12. - , 800 20 cm ,
4000 , 3 A
,
? 3
13. 10–7 m 10–9 m
? 3
Name the type of e.m. waves having a wavelength range 10–7 m to 10–9 m. How are
these waves generated ? Write their two uses.
14. 50 kV
“ ”
550 nm
3
55/3 6
15. (a) , ,
3
(b) 0, /2
(a) In Young’s double slit experiment, the two slits are illuminated by two different
lamps having same wavelength of light. Explain with reason, whether
interference pattern will be observed on the screen or not.
(b) Light waves from two coherent sources arrive at two points on a screen with
path differences of 0 and /2. Find the ratio of intensities at the points.
16.
R1 R2 3
Define the term current sensitivity of a galvanometer. In the circuits shown in the
figures, the galvanometer shows no deflection in each case. Find the ratio of R1 and R2.
55/3 7 [P.T.O.
17. C V
k = 10
– 3
18. (a) 20 ≤ A ≤ 170 , (BE/A)
A 3
(b) 240 7.6 MeV ,
Y Z, 110 130 , Y
Z , 8.5 MeV ,
(a) Draw a graph showing the variation of binding energy per nucleon (BE/A) vs
mass number A for the nuclei in 20 ≤ A ≤ 170.
(b) A nucleus of mass number 240 and having binding energy/nucleon 7.6 MeV
splits into two fragments Y, Z of mass numbers 110 and 130 respectively. If the
binding energy/nucleon of Y, Z is equal to 8.5 MeV each, calculate the energy
released in the nuclear reaction.
55/3 8
19. (a) (n)
3
(b) 590 nm 596 nm - 4 mm
2 m
(a) Explain how the intensity of diffraction pattern changes as the order (n) of the
diffraction band varies.
(b) Two wavelengths of sodium light 590 nm and 596 nm are used in turn to study
the diffraction at a single slit of size 4 mm. The distance between the slit and
screen is 2 m. Calculate the separation between the positions of the first
maximum of the diffraction pattern obtained in the two cases.
20. 12 mH 30 mH
:
(a) emf
(b)
, 3
(a) emf induced with the rate of change of current in each inductor
(b) energy stored in each inductor with the current flowing through it.
Compare the energy stored in the coils, if the power dissipated in the coils is the same.
21. (i) (ii) , (iii) 3
Write the functions of (i) Transducer, (ii) Transmitter, (iii) Repeater used in
communication systems.
55/3 9 [P.T.O.
22.
180
3
Draw the circuit diagram of a common emitter transistor amplifier. Write the
expression for its voltage gain. Explain, how the input and output signals differ in
phase by 180.
OR
Draw the circuit diagram of a full wave rectifier. Explain its working principle. Draw
the input and output waveforms.
SECTION – D
23.
,
-
2+2
(a)
(c) ?
55/3 10
Mr Kamath, the chief mechanical engineer, in Northern railways went to Tokyo to
attend a seminar on fast moving trains. His friend Mr Hiorki explained how Japanese
people are concentrating on energy conservation and saving fossil fuels using maglev
trains. Mr Kamath travelled from Tokyo to Osaka in maglev train and found that the
sound is less, travel is smooth and understood the Japanese technology in mass
transporting systems. Maglev trains work on the principle of Meissner’s effect.
(c) What is Meissner’s effect ? Write the value of magnetic permeability for perfect
diamagnetism.
SECTION – E
24. (a) ac - 2+3
(b) 200 mH , 400 f 10
50 V ac
(i) -
,
55/3 11 [P.T.O.
(a) l , v , B
, emf
2+3
(b) 15 , 60 cm ,
360
60 emf
400 mV ,
, emf ?
(a) Prove that an ideal capacitor in an a.c. circuit does not dissipate power.
(b) An inductor of 200 mH, capacitor of 400 f and a resistor of 10 are connected
in series to ac source of 50 V of variable frequency. Calculate the
OR
(a) A metallic rod of length l is moved perpendicular to its length with velocity v in
a magnetic field B acting perpendicular to the plane in which rod moves. Derive
the expression for the induced emf.
(b) A wheel with 15 metallic spokes each 60 cm long is rotated at 360 rev/min in a
plane normal to the horizontal component of earth’s magnetic field. The angle of
dip at that place is 60. If the emf induced between rim of the wheel and the axle
is 400 mV, calculate the horizontal component of earth’s magnetic field at the
place.
How will the induced emf change, if the number of spokes is increased ?
55/3 12
25. (a)
, , 3+2
(b) L AB = kx , x A
(a) r P
3+2
(b) 4 C +1 C 2 m
(a) State Gauss’ law. Using this law, obtain the expression for the electric field due
to an infinitely long straight conductor of linear charge density .
(b) A wire AB of length L has linear charge density = kx, where x is measured
from the end A of the wire. This wire is enclosed by a Gaussian hollow surface.
Find the expression for the electric flux through this surface.
OR
(a) Derive the expression for the electric potential at any point P, at distance r from
the centre of an electric dipole, making angle , with its axis.
55/3 13 [P.T.O.
26. (a) ,
(i)
, (ii) 3+2
(b) , L1, L2 L3 30 cm ,
L1 60 cm
L3 (i) (L1 L2) (ii) (L2 L3)
(a)
(D) (A)
3+2
(b)
, ,
- 2
55/3 14
(a) Explain with reason, how the power of a diverging lens changes when (i) it is
kept in a medium of refractive index greater than that of the lens. (ii) incident red
light is replaced by violet light.
(b) Three lenses L1, L2, L3 each of focal length 30 cm are placed co-axially as
shown in the figure. An object is held at 60 cm from the optic centre of lens L1.
The final real image is formed at the focus of L3. Calculate the separation
between (i) (L1 and L2) and (ii) (L2 and L3).
OR
(a) Deduce the expression, by drawing a suitable ray diagram, for the refractive
index of a triangular glass prism in terms of the angle of minimum deviation (D)
and the angle of prism (A).
Draw a plot showing the variation of the angle of deviation with the angle of
incidence.
(b) Calculate the value of the angle of incidence when a ray of light incident on one
face of an equilateral glass prism produces the emergent ray, which just grazes
______________
55/3 15 [P.T.O.
55/3 16