RISK ASSESSMENT REPORT - George Municipality - Tender ENG0042016 Installation of Perimeter Concrete Palisade Fe
RISK ASSESSMENT REPORT - George Municipality - Tender ENG0042016 Installation of Perimeter Concrete Palisade Fe
PROJECT:
COMPILED BY:
CONSULTANT: Roscoe Nel ISHS (Pty) Ltd
TELL: 044 874 6698 PO BOX 3286
CELL: 072 887 3828 GEORGE INDUSTRIA
6536
mailto:[email protected]
CONTENTS
Title
Terms of Reference
Executive summary
Report
1.5 Conclusion
Annexure 1
Please find risk assessment template (Annexure 1) which can be used by the
contractor to manage additional identified risks.
1
TITLE
The Hazard Identification and Risk Assessment of Occupational Health and Safety
parameters on the premises of: Pacaltsdorp Substation, ENG004/2016 Installation of
Perimeter Concrete Palisade Fence
TERMS OF REFERENCE
Mr. Roscoe Nel of Integrated Safety and Health Systems (Pty) Ltd conducted a
Health and Safety Risk Assessment based on scope of works set out, site visit and
technical specifications of the works intended and approved architectural
drawings. The survey was conducted on 29 January 2016, during normal working
hours.
EXECUTIVE SUMMARY
This assessment and observations were made at the above site under the
conditions which prevailed on the date of the survey. Detailed conclusions are
given in the relevant sections of this report.
Fig 1 Fig 2
3
For convenience, the general findings are given as follows:
Hazard Identification and Risk Assessment (HIRA):-
From the HIRA investigation it was found that:
Chemical hazards
• Handling of potential hazardous chemical substances that include cement
mortar and cement dust inhalation can pose a possible risk;
• Excavations include risk of contact with Biological agents. living things, or
substances produced by living things, that can cause illness or disease in
humans which include bacteria, viruses, and fungi as well as larger organisms
such as parasites and plants
Physical hazard
• Site establishing containers and other tools and equipment falling when
offloading;
• Transport of Labourers and work tools and equipment to and from site.
• Labourers falling from vehicles, Collisions with other vehicles. Collisions with
items being transported on same vehicle; Collisions with pedestrians.
• Excavations include risk of contact with open trenches and excavations;
• Impalement, entrapment, collapse and collisions and fire (Equipment Risks):
Machine running out of control, fuel catching a light, machine coming in
contact with operator or employees body parts. Machine generating fumes
and dust, Replacing drive belts, No machine guards, collapse of temporary
works/ structures;
• Noise can pose a high risk from mechanical tools when cutting/chasing for
plumbing/ electrical installations.
• Hot Work, Fire, and Explosive Hazards. Workers performing hot work such
as welding, cutting, brazing, soldering, and grinding are exposed to the risk of
fires from ignition of flammable or combustible materials in the space, and from
leaks of flammable gas into the space.
• Work from Elevated positions, persons can fall from elevated positions when
working from ladders, scaffold, and roof. Items can fall on persons from
elevated positions.
• Electrocution
• (Also noted: Location of site and elements specific to the location Findings on
page 3)
Ergonomics
• Workplace conditions that pose the risk of injury to the musculoskeletal system
of the worker including weather conditions.
• Manual material handling can pose a possible risk when lifting/carrying cement
bags/ construction material.
4
HAZARD IDENTIFICATION AND RISK ASSESSEMENT
Section 9(1) of the OCCCUPATIONAL HEALTH and SAFETY ACT 1993 (Act no. 85 of
1993), requires inter alia that the employer shall establish as far as is reasonably
practicable, what the hazards to the health and safety of persons are attached to
any work which is performed, further establish what precautionary measures
should be taken with respect to such work and he shall provide the necessary
means to apply such precautionary measures. The construction regulations further
requires that a baseline risk assessment for an intended construction work project
be compiled and a suitable, sufficiently documented and coherent site specific
health and safety specification for the intended construction work based on the
baseline risk assessment to be prepared.
During the survey the presence of occupational health stresses and safety factors
(i.e. chemical, physical and ergonomically) were considered, the severity of the
risk factor, the frequency of exposure to the risk factor and possibility of
occupational decease or injury was assessed and weights allocated on a scale of
1 – 5. Each of these weights carries a certain point’s value as follows.
5
CATEGORY SEVERITY FREQUENCY POSSIBILITY
1 40 10 10
2 15 6 6
3 7 3 3
4 3 2 1
5 1 1 0,5
6
1 .4 RESULTS AND DISCUSSION
The HIRA as described above was conducted for construction conditions based
on scope of works set out and approved architectural drawings of the facility.
Activities are evaluated on the exposure to the following risk factors: Chemical
Hazards, Physical Hazards and Ergonomic Hazards (as mentioned in depth with
HIRA investigation).
Chemical Hazards:
• Handling cement mortar and cement dust inhalation can pose a substantial
risk;
7
Physical Hazards:
• Noise and fumes can pose a high risk from mechanical tools when
cutting/chasing for installations
Ergonomic Hazards:
• Manual handling (lifting, carrying) heavy construction equipment and material.
• Weather conditions: - Temperatures – Hot, cold rainy and windy conditions
when working at heights.
Chemical Hazard -
• Excavations include a possible risk of contact with Biological agents. living
things, or substances produced by living things, that can cause illness or disease
in humans which include bacteria, viruses, and fungi as well as larger organisms
such as parasites and plants
1.5 CONCLUSION
From the HIRA investigation it was found that Physical hazards (Impalement,
Entanglement, Collapse, Crushing, Collisions, Electrocution, Hot Works, and
Working at Heights,) are high risk factors. Elimination and Engineering control
measures applies.
The exposure to the Chemical hazard (Dust) is limited due to the specified
construction material used for this project is pre-fabricated but PPE control
measures for all activities is required..
Ergonomics (manual material handling) can pose a substantial risk due to
repetitive activities like lifting and carrying heavy construction equipment and
material. Administrative and PPE and control measures apply.
Although the possibility of excavations leading to the risk of chemical hazards
(biological agent contact/exposure) is classified as unlikely especially because
previous construction activities were already performed on that site without
incident, the classification of possible risk remains and administrative and PPE
control measures should be considered.
8
Annexure 1
ADDITIONAL RISK ASSESSMENT
ASSESSED BY: COMPANY:
DATE OF ASSESSMENT: TEL/CELL:
INDICATE WORK TO BE
DONE, ACTIVITIES/
PROCESSES, TODAY:
INDICATE RISKS 3. ASPHYXIATION
1. ADVERSE ENVIRONMENT 2. ASBESTOS (CO2, N2, ETC)
IDENTIFIED.
5. COLLAPSE (e.g. SCAFFOLD/ FLOOR
4. BURNS/SCALDS PLATES) 6. COLLISION
INCLUDE WORKERS,
VISITORS & THE PUBLIC 7. CRUSHING 8. DROWNING 9. ELECTRICUTION
WHO MAY BE EFFECTED 12. EXPLOSION
10. ENTANGLEMENT IN (IGNITION
BY WORK TO BE DONE, MOVING OBJECTS 11. ENTRAPMENT SOURCES)
ACTIVITIES/ PROCESSES. 15. FALLING FROM
HEIGHTS
NB:ALL RISKS ARE TO 13. EXPOSURE TO PATHOGENS 14. EYE INJURY/STRAIN (PERSONNEL)
18. IMPACT INJURY
BE TREATED AS HIGH FROM FLYING
RISKS. 16. FIRE 17. HIGH PRESSURE INJECTION INJURY OBJECTS
19. INGESTION OF 21. INHALATION OF
CHEMICALS/OILS 20. INHALATION OF DUSTS/POWDERS GASSES/FUMES
22. INJURY FROM FALLING 23. MANUAL HANDLING INJURY e.g.
OBJECTS BACK/ARM STRAIN 24. NOISE
27. SAFETT
25. POLLUTION TO EQUIPMENT
WATERCOURSE, AIR, LAND 26. REPETITIVE STRAIN INJURY FAILURE
28. SKIN CONTACT WITH
CHEMICALS/OILS/HBA’S 29. SKIN LACERATION INJURY 30. SLIPS/TRIPS