Australian Standard: Methods For Sampling and Testing Aggregates Part 0: List of Methods
Australian Standard: Methods For Sampling and Testing Aggregates Part 0: List of Methods
Australian Standard: Methods For Sampling and Testing Aggregates Part 0: List of Methods
0—1999
Australian Standard™
Review of Australian Standards. To keep abreast of progress in industry, Australian Standards are
subject to periodic review and are kept up to date by the issue of amendments or new editions as
necessary. It is important therefore that Standards users ensure that they are in possession of the latest
edition, and any amendments thereto.
Full details of all Australian Standards and related publications will be found in the Standards Australia
Catalogue of Publications; this information is supplemented each month by the magazine ‘The
Australian Standard’, which subscribing members receive, and which gives details of new publications,
new editions and amendments, and of withdrawn Standards.
Suggestions for improvements to Australian Standards, addressed to the head office of Standards
Australia, are welcomed. Notification of any inaccuracy or ambiguity found in an Australian Standard
should be made without delay in order that the matter may be investigated and appropriate action taken.
Australian Standard™
STANDARDS AUSTRALIA
Australian Standard
Methods for sampling and testing aggregates
GENERAL INTRODUCTION
The test methods listed below were prepared by the Standards Australia Committee
CE/12, Aggregates and Rocks for Engineering Purposes.
In the preparation of the test methods, the Committee has taken note of all available
overseas Standards and drafts, and in particular acknowledges the usefulness of ASTM
(American Society for Testing and Materials) documents.
This Part lists the methods for the sampling and testing of aggregates used in concrete,
asphalt, sprayed bituminous surfacings, pavements, railway ballast and for other
engineering purposes.
LIST OF METHODS
Number in
Title
series
1141.0 List of methods
1141.1 Definitions
1141.2 Basic testing equipment
1141.3.1 Sampling — Aggregates
1141.3.2 Sampling — Rock spalls, boulders and drill core
1141.3.3 Sampling — Preparation of stabilized pavement materials
Accessed by SWINBURNE UNIVERSITY OF TECHNOLOGY on 08 Mar 2011
Number in
Title
series
1141.16 Angularity number
1141.17 Voids in dry compacted filler
1141.18 Crushed particles of coarse aggregate derived from gravel
1141.19 Fine particle size distribution in road materials by sieving and decantation
1141.20 Average least dimension of aggregate by direct measurement
1141.21 Aggregate crushing value
1141.22 Wet/dry strength variation
1141.23 Los Angles value
1141.24 Aggregate soundness — Evaluation by exposure to sodium sulphate solution
1141.25.1 Degradation factor — Source rock
1141.25.2 Degradation factor — Coarse aggregate
1141.26 Secondary minerals content in basic igneous rocks
1141.27 Resistance to wear by attrition
1141.28 Ball mill value
1141.29 Accelerated soundness index by reflux
1141.30 Coarse aggregate quality by visual comparison
1141.31 Light particles
1141.32 Weak particles (including clay lumps, soft and friable particles) in coarse
aggregate
1141.33 Clay and fine silt (settling method)
1141.34 Organic impurities other than sugar
1141.35 Sugar
1141.36 Sulphur in metallurgical slag, crushed rock or other pavement materials
Accessed by SWINBURNE UNIVERSITY OF TECHNOLOGY on 08 Mar 2011