Protective & Marine Coatings: General Polymers 3746
Protective & Marine Coatings: General Polymers 3746
1. Premix GP3746 (resin) using a low speed drill and Jiffy blade. Sਠਥਤਲ਼ਸ
Mix for one minute and until uniform, exercising caution not to Refer to the MSDS sheet before use.
introduce air into the material.
Published technical data and instructions are subject to change
2. Add 2 parts GP3746 (resin) to 1 part GP3746B (hardener) by without notice. Contact your Sherwin-Williams representative
volume. Mix with low speed drill and Jiffy blade for three minutes for additional technical data and instructions.
and until uniform. To insure proper system cure and performance,
strictly follow mix ratio recommendations.
Mਠਨਭਲ਼ਤਭਠਭਢਤ
3. Apply GP3746 using a squeegee or trowel and back roll with a Occasional inspection of the installed material and spot repair can
3/8" nap roller at a spread rate of 50-160 square feet per gallon prolong system life. For specific information, contact the Technical
(1.3-4.0 meters squared per liter) to yield 10-30 mils (250-750 Service Department.
microns) WFT making sure of uniform coverage. Take care not to
puddle materials and insure even coverage.
Note: Epoxy materials will appear to be cured and “dry to touch” prior
to full chemical cross linking. Allow epoxy to cure a minimum of 3 days
Dਨਲਢਫਠਨਬਤ
prior to exposure to water or other chemicals for best performance. The information and recommendations set forth in this Product Data Sheet are
based upon tests conducted by or on behalf of The Sherwin-Williams Company.
Such information and recommendations set forth herein are subject to change and
pertain to the product offered at the time of publication. Consult your Sherwin-
Williams representative to obtain the most recent Product Data Information and
Tਨਭਲ਼ਨਭਦ Application Bulletin.
www.sherwin-williams.com/protective