Exam Code: 640-802 Cisco Certified Network Associate: Demo Version
Exam Code: 640-802 Cisco Certified Network Associate: Demo Version
Demo Version
To Access Full Version, Please go to
www.itexamworld.com
www.itexamworld.net
-
Question: 1
What are two reasons that a network administrator would use access lists? (Choose two.)
Answer: A, C
Question: 2
A default Frame Relay WAN is classified as what type of physical network?
A. point-to-point
B. broadcast multi-access
C. nonbroadcast multi-access
D. nonbroadcast multipoint
E. broadcast point-to-multipoint
Answer: C
Question: 3
A single 802.11g access point has been configured and installed in the center of a square office.
A few wireless users are experiencing slow performance and drops while most
users are operating at peak efficiency. What are three likely causes of this problem? (Choose
three.)
Answer: C, E, F
Question: 4
Refer to the exhibit.
How many broadcast domains exist in the exhibited topology?
A. one
B. two
C. three
D. four
E. five
F. six
Answer: C
Question: 5
Refer to the exhibit.
What two facts can be determined from the WLAN diagram? (Choose two.)
A. The area of overlap of the two cells represents a basic service set (BSS).
B. The network diagram represents an extended service set (ESS).
C. Access points in each cell must be configured to use channel 1.
D. The area of overlap must be less than 10% of the area to ensure connectivity.
E. The two APs should be configured to operate on different channels.
Answer: B, E
Question: 6
The command frame-relay map ip 10.121.16.8 102 broadcast was entered on the router. Which
of the following statements is true concerning this command?
Question: 7
Which type of attack is characterized by a flood of packets that are requesting a TCP connection
to a server?
A. denial of service
B. brute force
C. reconnaissance
D. Trojan horse
Answer: A
Question: 8
Which of the following are associated with the application layer of the OSI model? (Choose two.)
A. ping
B. Telnet
C. FTP
D. TCP
E. IP
Answer: B, C
Question: 9
Refer to the exhibit.
The network administrator has created a new VLAN on Switch1 and added host C and host D.
The administrator has properly configured switch interfaces
FastEthernet0/13 through FastEthernet0/24 to be members of the new VLAN.
However, after the network administrator completed the configuration, host A could
communicate with host B, but host A could not communicate with host C or host D.
Which commands are required to resolve this problem?
Answer: A
Question: 10
For security reasons, the network administrator needs to prevent pings into the
corporate networks from hosts outside the internetwork. Which protocol should be
blocked with access
control lists?
A. IP
B. ICMP
C. TCP
D. UDP
Answer: B
Question: 11
What are two recommended ways of protecting network device configuration files from outside
network security threats? (Choose two.)
Answer: B, D
Question: 12
Refer to the exhibit.
The access list has been configured on the S0/0 interface of router RTB in
the outbound
direction. Which two packets, if routed to the interface, will be denied? (Choose two.)
Answer: D, E
Question: 13
What are two security appliances that can be installed in a network? (Choose two.)
A. ATM
B. IDS
C. IOS
D. IOX
E. IPS
F. SDM
Answer: B, E
Question: 14
Refer to the exhibit.
Switch1 has just been restarted and has passed the POST routine. Host A sends its initial frame
to Host C. What is the first thing the switch will do as regards populating the switching table?
Answer: C
Question: 15
Exhibit:
The user of Host1 wants to ping the DSL modem/router at 192.168.1.254. Based on the Host1
ARP table that is shown in the exhibit, what will Host1 do?
Answer: B