DAC1 27 01 Rev 0
DAC1 27 01 Rev 0
Service Bulletin No.: DAC1-27-01 Rev 0 Date Issued: April 26, 2001
Title: Optional Stick Mounted Trim Switch Installation Page: 1 of 6
3. General: This service bulletin explains the procedure for the optional installation
of control stick mounted elevator trim switches. The installation consists
of the replacement of both the pilot and co-pilot control sticks with new
control sticks complete with elevator trim and transmit switches. The
installation also involves a relay wiring harness to be installed under the
pilot seat. The console mounted elevator trim switch is no longer
operational and is removed. The operation of the control stick mounted
trim switches is explained in Supplement 8 to the flight manual DA202-
C1. This supplement must be incorporated into the flight manual for the
aircraft if not already incorporated.
8. Special Tools: Drill Jig KT-HRF-001 (Recognition light/Relay Harness drill jig).
11. Weight and Balance: The effect on the weight and balance is negligible.
General Overview
To obtain satisfactory results, procedures specified in this service bulletin must be accomplished in accordance with
accepted methods and current government regulations. Diamond Aircraft Industries Inc. cannot be responsible for the quality
of work performed in accomplishing the requirements of this service bulletin. Diamond Aircraft reserves the right to void
continued warranty coverage in the area affected by this Service Bulletin if it is not incorporated.
If you no longer own the aircraft to which this service bulletin applies, please forward it to the current owner and send the
name of the current owner to Diamond Aircraft Industries, Inc., at the address below
Diamond Aircraft Industries Inc. 1560 Crumlin Sideroad, London, Ontario, Canada N5V 1S2
Phone: (519) 457-4041 Fax: (519) 457-4020
COPYRIGHT 2001
SERVICE BULLETIN
Service Bulletin No.: DAC1-27-01 Rev 0 Date Issued: April 26, 2001
Title: Optional Stick Mounted Trim Switch Installation Page: 4 of 6
** If the recognition
lights are installed
these holes will have
already been drilled.
Figure 1
SERVICE BULLETIN
Service Bulletin No.: DAC1-27-01 Rev 0 Date Issued: April 26, 2001
Title: Optional Stick Mounted Trim Switch Installation Page: 5 of 6
Figure 2
SERVICE BULLETIN
Service Bulletin No.: DAC1-27-01 Rev 0 Date Issued: April 26, 2001
Title: Optional Stick Mounted Trim Switch Installation Page: 6 of 6
Figure 3