Professional Documents
Culture Documents
Wa180-3 Op PDF
Wa180-3 Op PDF
1. Turn the engine starting switch to the ON position, then check the
fuel level with fuel gauge G.
After checking, return the starting switch to the OFF position.
䖃 After traveling for one hour, stop the machine for 30 minutes and
check the tires and all parts for any abnormality. Check the oil level
and coolant level also.
When stopping the machine in extremely cold areas, do as follows.
To prevent the radiator water temperature from rising suddenly, do
not suddenly stop the engine. Gradually cool the radiator water
down before stopping the engine.
䖃 Always travel with the bucket empty.
䖃 Never put calcium chloride or dry ballast in the tires when traveling.
䖃 Wipe off the grease from the hydraulic cylinder rods.
䖃 Add oil and grease to all places.
䖃 Check that there is no rust on the engine pulley and no abnormality
in the belt.
If there is excessive rust on the belt contact surface of the pulley,
remove it with a wire brush.
Alarm 2
1. Turn the engine starting switch to the ON position, then check the
fuel level with fuel gauge G.
After checking, return the starting switch to the OFF position.
.
©
2007 KOMATSU
All Rights Reserved
Printed in Japan 08-07