Dvb-T-T2-C Receiver
Dvb-T-T2-C Receiver
CableWorld’s latest receivers are available in several versions to meet user demand. The fully equipped
19–inch rack contains six tuners that are capable of receiving DVB-T, DVB-T2 and DVB-C signals and four CI
slots (Conditional Access Module receivers) that may be already known from the previous devices. The CI
slots are available only for the first four tuners, the fifth and sixth ones are reserved for the free-to-air
programs. The output streams are available through both ASI and IP outputs.
Setting up the device is very simple: in automatic mode on the
Fields of application:
web interface only the frequency and bandwidth need to be set
among the reception parameters. After a successful tuning detailed ✔ feeding headends with
modulation parameters are shown and the reception parameters is DVB-T, DVB-T2 or DVB-C
also given (such as: input signal level, signal quality, signal to noise signals over ASI or IP
ratio, etc..). ✔ as a measuring receiver for
The settings of CAMs plugged in the CI slots can be queried and DVB-T and DVB-T2
modified. With one module several encrypted programs can be transmitters or CATV
decrypted simultaneously. In order to decrease the output data rate headends using DVB-C
the unwanted encrypted programs can be filtered. modulation
2015/22
DVB-T-T2-C RECEIVER
Technical data
RF input data IP output
Input frequency range 44 … 1002 MHz Transport streams 10-, 100- and 1000Base-T
Tuner type MxL603 Silicon Tuner (MaxLinear) Protocol Ipv4, ARP, UDP
Bandwidth 6, 7, 8 MHz Number of outputs 64 UDP/RTP stream/device
Noise factor typically 3,8 dB Stream MPTS and SPTS
Raster frequency 1 kHz VLAN tagging configurable for all outputs
Total AGC range (RF+IF) better than 60 dB Connector type RJ-45
RF input impedance 75 ohm Optical output receptacle for SFP (Mini GBIC) module
Return loss typically 10 dB (max. 8 dB)
RF input connector F socket ASI output
Standard according to EN 50083-9
Transmission parameters (for interconnection between devices)
Demodulation MN88472 IC (Panasonic) Impedance 75 ohm
DVB-T, DVB-T2, DVB-C compatibility Connectors BNC sockets (for each tuner)
DVB-T according to EN 300 744
FFT size 2k, 8k Management port
Modulation QPSK, 16QAM, 64QAM IP input 10-, 100Base-T
Code rate 1/2, 2/3, 3/4, 5/6, 7/8 Protocol Ipv4, ARP, ICMP-ping, TCP, UDP
Guard interval 1/4, 1/8, 1/16, 1/32 Connector type RJ-45
AFC range typically ±900 kHz
TPS decoding and application General data
DVB-T2 according to EN 302 755 Mass about 4,8 kg
Bandwidth (1,7) 5, 6, 7, 8 MHz Physical dimensions 19” × 1 RU
FFT felbontás 1k, 2k, 4k, 8k, 16k, 32k W×H×D 483 × 43,6 × 473 mm
Guard interval 1/4, 1/8, 1/16, 1/32 Service period continuous
1/128, 19/128, 19/256 Power requirement 90 … 264 V, 47 … 440 Hz
Modulation QPSK, 16QAM, 64QAM, 256QAM Power consumption max. 50 W
Code rate 1/2, 3/5, 2/3, 3/4, 4/5, 5/6 Temperature at operation +5 … +400C, relative humidity max. 80 %
AFC range typically ±900 kHz
TPS decoding and application
Programming of the device
Programming and control over separate management port, in web
DVB-C according to EN 300 429
environment, optimized to the Firefox
Modulation 16QAM, 32QAM, 64QAM
browser
128QAM, 256QAM
Management IP address 192.168.10.10
Symbol rate 0,7 ... 7 MBaud
AFC range typically ±500 kHz
Ordering data:
CW-4631 1xDVB-T-T2-C tuner in one frame, without CI for FTA programs, ASI and IP output
CW-4632 2xDVB-T-T2-C tuner in one frame, without CI for FTA programs, ASI and IP output
CW-4634 4xDVB-T-T2-C tuner in one frame, without CI for FTA programs, ASI and IP output
CW-4636 6xDVB-T-T2-C tuner in one frame, without CI for FTA programs, ASI and IP output
CW-4641 1xDVB-T-T2-C tuner in one frame, each tuner has Common Interface, ASI and IP output
CW-4642 2xDVB-T-T2-C tuner in one frame, each tuner has Common Interface, ASI and IP output
CW-4644 4xDVB-T-T2-C tuner in one frame, each tuner has Common Interface, ASI and IP output
CW-4646 6xDVB-T-T2-C tuner in one frame, 4xCI, 2x tuner for FTA programs, ASI and IP output