Quiz AIT
Quiz AIT
Quiz AIT
o Above normal.
o Below normal.
o Normal.
o The formation water source located at a higher level than the rig floor.
o The difference in density between gas and formation fluid.
o Compaction of the formation from the above laying formation.
o
one. Around the drill collars if and annular capacity is 0.03 bls/ft
Answer:-----------psi.
Two. Around the drill pipe if the annular capacity is 0.05 bbls/ft
Answer:-----------psi
6- After setting casing, which of the following actions are normally taken prior to
making a leak-off test?
(Two answers)
7- Well data
13-3/8 inch casing is set at 5,210 feet TVD. Formation strength at the shoe is
3,800 psi. Current mud weight = 10.6 ppg.
o 2,050 psi
o 555 psi
o 928 psi
o 1,800 psi
o Stop the pump after 10 barrels has been pumped then read the drill pipe pressure.
o Condition the mud until mud density in the well is constant. Then carry out the
leak-of test.
o Pump at slow circulation rate until fracture pressure is reached.
o Pump down drill string at slow circulating rate and read drillpipe pressure.
11- using the following data calculate the mud required to fill the hole during a
trip.
Calculate volume to fill the hole per stand when pulling ‘dry’ for:-
Calculate volume to fill the hole per stand when pulling ‘wet’ (no returns to
trip tank) for:-