Average and RMS Values of A Periodic Waveform:: T T T T DT T F F
Average and RMS Values of A Periodic Waveform:: T T T T DT T F F
Begin by defining the average value of any time-varying function over a time interval
Δt ≡ t 2 − t1 as the integral of the function over this time interval, divided by Δt :
t2
∫ f (t ) dt 1 2
t
t 2 − t1 ∫t1
f avg ≡ =
t1
f (t ) dt (1.1)
Δt
Numerically, this is an extension of the basic definition of the average for a discrete
N
∑x i
variable, x ≡ i =1
, applied to a continuously-varying function.
N
Graphically, this means that the area under the function (between times t1 and t 2 ) is
equivalent to the area of a rectangle of height f avg multiplied by width (t 2 − t1 ) :
t2
f avg ⋅ (t 2 − t1 ) = ∫ f (t ) dt (1.2)
t1
⎛ 2 I p ⎞ ⎡ − cos(ωt ) ⎤ τ 2 ⎛ 2 I p ⎞ ⎡ ⎛ ωτ ⎞ ⎤
I avg = ⎜⎜ ⎟⎟ ⎢ ⎥ | = ⎜⎜ ⎟⎟ ⎢− cos⎜ ⎟ − (−) cos(0)⎥
⎝ τ ⎠⎣ ω ⎦ ⎝ ωτ ⎠ ⎣ ⎝ 2 ⎠ ⎦
0
⎛ 2I p ⎞ ⎛ 2I ⎞ ⎛ 2I ⎞ I
= ⎜⎜ ⎟⎟[− cos(π ) + 1] = ⎜⎜ p ⎟⎟ = ⎜⎜ p ⎟⎟ = p (1.6)
⎝ ωτ ⎠ ⎝ ωτ ⎠ ⎝ 2π ⎠ π
Ip
I avg = calculated over one half-cycle of the sine wave (1.7)
π
● The average of a sine wave over one full-cycle:
τ
1
I p sin (ωt )dt
(τ ) ∫0
I avg = (1.8)
⎛ I p ⎞ ⎡ − cos(ωt ) ⎤ τ ⎛ I p ⎞
I avg = ⎜⎜ ⎟⎟ ⎢ ⎥⎦ |0 = ⎜⎜ ωτ ⎟⎟[− cos(ωτ ) − (−) cos(0)]
⎝ τ ⎠⎣ ω ⎝ ⎠
⎛ Ip ⎞ ⎛I ⎞
= ⎜⎜ ⎟⎟[− cos(2π ) + 1] = ⎜⎜ p ⎟⎟[− 1 + 1] = 0
⎝ ωτ ⎠ ⎝ ωτ ⎠
While this result is mathematically correct, it doesn’t provide any physical insight into
what this sine wave can “accomplish” over one complete cycle. Consider the AC
sinusoidal voltage delivered by Tucson Electric Power at a wall outlet. Its average value
may be 0, yet we know from experience that this sine wave will light up fluorescent
bulbs, heat up tungsten filaments in light bulbs, heat wires in toasters, etc. This is
because these devices absorb energy (power) from the sine wave, whether the voltage is
positive-going or negative-going. Useful work is done during both half-cycles of the
sinusoidal waveform.
τ
YRMS ≡ {f 2
}
(t ) AVG =
1
τ∫
f 2
(t )dt (1.10)
0
The physical meaning of the RMS value is this—it is the constant, or “DC” value that
would cause the same physical effect as the actual time-varying waveform does, during
one complete period. This might be to deliver the same power in a circuit, to cause the
same heating effect in a toaster, to light up a bulb with the same brightness, etc.
Note that, in general, a periodic waveform may not have symmetry like sinusoidal or
triangular waveforms have. In this case, you still calculate the RMS value according to
equation (1.10), by integrating over one complete cycle. Modern-day instrumentation
(the DMMs and oscilloscopes in our lab) digitally sample a waveform, and numerically
integrate the values to calculate the RMS value, according to equation (1.10).
● RMS Value of a Sinusoidal Waveform:
τ τ
1 1
∫ V (t )dt = τ∫
sin 2 (ωt )dt
2
VRMS = 2
V (1.12)
τ
p
0 0
2 τ 2
Vp 1 V p ⎡τ τ
⎤
( )
τ ∫0 2 2τ ⎣ ∫0 ∫0
= 1 − cos 2ωt dt = ⎢ dt − cos( 2ωt ) dt ⎥ (1.13)
⎦
τ
V p ⎡ τ ⎛ sin( 2ωt ) ⎞ ⎤
2
= ⎢(t ) − ⎜ ⎟ ⎥ (1.14)
2τ ⎢⎣ 0 ⎝ 2ω ⎠ 0 ⎥⎦
2 2
V p ⎡ ⎛ sin(2ωτ ) ⎞⎤ V p ⎡ ⎛ sin(2 ⋅ 2π ) ⎞⎤
= ⎢τ −⎜ − 0 ⎟⎥ = ⎢τ −⎜ − 0 ⎟⎥ (1.15)
2τ ⎣ ⎝ 2ω ⎠⎦ 2τ ⎣ ⎝ 2ω ⎠⎦
2
2
Vp Vp
= [τ − 0 + 0] = (1.16)
2τ 2
Vp
VRMS = for a sinusoidal waveform (1.17)
2
(Note that you get the same result whether you integrate from (0 − τ ) , (0 − τ 2) , or even
from (0 − τ 4) , because of the symmetry of this waveform.)
The quoted value of 120VAC for the voltage at the wall socket, as delivered by Tucson
Electric Power is, in fact, the RMS value of the (60Hz) sinusoidal voltage. The peak
voltage is therefore V p = 2 ⋅120 = 169 V, and the peak-to-peak value is 339V!!!
● RMS Value of a Triangular Waveform:
4V p
V (t ) = t (valid between t = 0 and t = τ 4 ) (1.18)
τ
τ 4
1
τ 4 − 0 ∫0
VRMS = V 2
AVG = V 2 (t )dt (1.19)
τ 4 2 τ 4 2
4 ⎛ 4V p ⎞ 2 4 ⎛ 4V p ⎞
= ∫ ⎜
⎜
τ 0⎝ τ ⎠
⎟
⎟ t dt = ⎜
⎜
τ⎝ τ ⎠ 0
⎟
⎟ ⋅ ∫ t 2 dt (1.20)
τ 4
64V p ⎡ t 3 ⎤
2 2 2
64V p ⎛ τ 3 ⎞ Vp
= ⎢ ⎥= ⎜ ⎟ = (1.21)
τ 3 ⎢⎣ 3 0 ⎥⎦ τ 3 ⎜⎝ 3 ⋅ 4 3 ⎟⎠ 3
Vp
VRMS = for a triangular waveform (1.22)
3