Professional Documents
Culture Documents
Direct-Acting Relief Valve: Download
Direct-Acting Relief Valve: Download
Product Description
Direct-acting relief cartridges are normally closed, pressure-limiting valves used to protect hydraulic components from
pressure transients. When the pressure at the inlet (port 1) reaches the valve setting, the valve starts to open to tank
(port 2), throttling flow to limit the pressure rise. These valves are smooth and quiet, essentially zero leak, dirt tolerant,
immune to silting and are very fast.
Download
Technical Features
All 2-port relief cartridges (except pilot reliefs) are physically and Select a spring range where the desired relief setting is approximately
functionally interchangeable (same flow path, same cavity for a given mid-range to high between the minimum and maximum pressure to
frame size). ensure maximum valve repeatability.
Will accept maximum pressure at port 2; suitable for use in cross port Suitable for use in load holding applications.
relief circuits.
The seals on the adjust screw are exposed to system pressure which Back pressure on the tank port (port 2) is directly additive to the valve
means this valve can only be adjusted when the pressure is removed. setting at a 1:1 ratio.
The setting procedure is; check the setting, remove the pressure, adjust
the valve, check the new setting.
Valve is relatively insensitive to varying oil temperatures and oil borne Incorporates the Sun floating style construction to minimize the
contamination. possibility of internal parts binding due to excessive installation torque
and/or cavity/cartridge machining variations.
Special Notes
U.S. Patent #4,742,846; European Patent Pending
Technical Data
U.S. Units Metric Units
Cavity T-16A
Capacity 100 gpm 380 L/min.
Factory Pressure Settings Established at 4 gpm 15 L/min.
Maximum Operating Pressure 5000 psi 350 bar
Maximum Valve Leakage at Reseat 10 drops/min. 0,7 cc/min.
Response Time - Typical 2 ms
Series (from Cavity) Series 3
Reseat >90% of setting
Adjustment - Number of Clockwise Turns to Increase Setting 5
Valve Hex Size 1 1/4 in. 31,8 mm
Valve Installation Torque 150 - 160 lbf ft 203 - 217 Nm
Adjustment Screw Internal Hex Size 5/32 in. 4 mm
Adjustment Locknut/Cap Hex Size 9/16 in. 15 mm
Adjustment Nut Torque 80 - 90 lbf in. 9 - 10 Nm
Seal Kits - Cartridge Buna: 990-316-007
Seal Kits - Cartridge Viton: 990-316-006
Model Weight 1.50 lb. 0.68 kg.
RDHA-LAN
Material/Coating
Control Adjustment Range Seal Material
Modifier
L Standard Screw Adjustment A 500 - 3000 psi (35 - 210 bar), N Buna-N /AP Stainless Steel,
1000 psi (70 bar) Standard Passivated
Setting
Control:L