Tkis Paper Waste Water Treatment in Coke Plants
Tkis Paper Waste Water Treatment in Coke Plants
Keywords: coke plant, waste water treatment, Jet Loop Reactor, membrane
INTRODUCTION
The protection of the environment is growing more and more in the focus of public interest worldwide.
Therefore the requirements for reducing the impact of pollution is rising in all industrial areas, including the
coke plant business. To identify and tackle the challenges of tomorrow for our clients, ThyssenKrupp Industrial
Solutions (TKIS) - Process Technologies (formerly known as Uhde) continuously conducts research for
environmentally friendlier processes and technologies.
Modern waste water treatment facilities of coke making plants use the Jet Loop Reactor and membrane filtration
technology. With this process waste water can be recycled for either reuse at the same site or reuse in other
applications. Besides the benefit of reducing liquid emissions and thus minimizing the environmental impact an
additional economic improvement can be achieved: Compared to a conventional waste water treatment plant
equipped with basins, the Jet Loop Reactor requires much less space.
The paper presents a brief abstract about the main topics of this technology as well as the latest beneficial results
of the validating performance and operational data from a full scale plant.
DISCUSSION
The first step of our waste water treatment development was to reduce the necessary floor space. Concrete basins
require much more floor space than the waste water treatment with Jet Loop Reactor and membrane filtration
because the Jet Loop Reactors can be built much higher than concrete basins. For example, the basin waste water
treatment at a Korean coking plant requires an area to flow rate ratio of 122 m²/ (m³/h). By comparison, an
industrial size Jet Loop Reactor waste water treatment plant which has been built at a German coking plant only
requires an area to flow rate ratio of 67 m²/ (m³/h).
The waste water enters the mass transfer zone together with air from a compressor through a two component jet
nozzle. This jet nozzle produces dispersed air bubbles in the water. The bubbles have a very large surface which
is used for mass transfer. There are also extra obstacles installed in the mass transfer zone to create turbulence
and increase the mass transfer. The nutrients, the impurities which should be degraded, and the oxygen are
transported to the bacteria. The jet nozzle and the obstacles create the first loop as shown in Figure 4 below.
From the mass transfer zone the water-air mixture is flowing up to the reaction zone. There the nutrients, the
impurities and the air which has been transported to the bacteria in the mass transfer zone are degraded by the
bacteria. On top of the reaction zone there is a degasing zone where the surplus air escapes from the water and
leaves the reactor to the open atmosphere. Because of the escaping air bubbles, a density difference is created,
causing the denser part of the water to flow down the inside of the reactor. This creates the second loop of the
Jet Loop Reactor. The remaining portion of the water can exit the reactor and proceed to ultrafiltration or the
outer reactor circulation.
Figure 4, Function of a Jet Loop Reactor (JLR)
Because of the optimized mass transfer, a lower retention time is needed in a Jet Loop Reactor than in a
conventional waste water treatment basin. A lower retention time has the advantage that the equipment can be
designed smaller and lower recycle streams are needed. This results in lower investment and operating costs.
Nitrogen removal takes place in the second stage. It consists of a Jet Loop Reactor for nitrification, a basin for
denitrification and final aeration and an ultrafiltration step. The denitrification and the final aeration are taking
place in a conventional concrete basin. During nitrification the ammonia is degraded to nitrate and during
denitrification the ammonia is degraded to nitrogen which escapes into the atmosphere. In the final aeration the
bacteria degrades surplus COD (chemical oxygen demand). The ultrafiltration holds back the bacteria and
returns it to the nitrification in the Jet Loop Reactor. The bacteria in the second stage are thereby specialized on
degrading ammonia and nitrate.
Surplus sludge can be removed from both ultrafiltration units and sent to a centrifuge.
Downstream from the second ultrafiltration, the filtered waste water is cleaned, fulfilling the actual German
regulatory limiting values and can be safely discharged. A waste water treatment plant which consists of these
two described stages has been built and commissioned by TKIS at a German coke plant.
To reach even stricter limiting values or to completely reuse the cleaned water on site, a third stage may be
necessary. Depending on the requested limiting values, the third stage can consist of different membrane
treatment combinations.
CONCLUSIONS
Advantages and disadvantages of the Jet Loop Reactor and membrane technology
Figure 6 summarizes the advantages and disadvantages of the Jet Loop Reactor and membrane technology in
comparison to the conventional basin technology:
Figure 6, Advantages and disadvantages of the Jet Loop Reactor and membrane technology
Because a Jet Loop Reactor can be built higher than a conventional basin less floor space is required. By using a
two component jet nozzle and some flow obstacles a high turbulence with a great mass transfer can be reached
so that lower retention times, smaller treatment reactors and lower recycle streams are sufficient. When a third
stage is also installed, some or all the treated waste water, depending on the required limiting values, can be
reused. The Jet Loop Reactor and membrane process has only the slight disadvantage that a c-source for the
denitrification is required. This can be called a slight disadvantage because some conventional waste water
treatments also need a c-source.
Reachable degradation rates of the Jet Loop Reactor and ultrafiltration waste water treatment
The following figures show the degradation rates which could be reached during commissioning the two stage
German waste water treatment plant.
Figure 7, Degradation rate free cyanide
The following figure shows the reachable degradation rates according to the experience TKIS has made during
commissioning the German two stage Jet Loop Reactor and ultrafiltration waste water treatment.