D1146T G-DRIVE: Power Rating

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

D1146T G-DRIVE

◎ POWER RATING
Engine
Type of Engine Power
Speed
Operation
rev/min kWm Ps
Prime Power 125 170
1800
Standby Power 138 187
Prime Power 107 145
1500
Standby Power 118 160

-. The engine performance corresponds to ISO 3046, BS 5514 and DIN 6271.
-. Ratings are based on ISO 8528. (If you need more information, contact the sales organization.)
→ Prime power is available for an unlimited number of hours per year in a variable load application.
The permissible average power output over 24 hours of operation shall not exceed 70% of the prime power rating.
→ Standby power is available in the event of a utility power outage or under test conditions for up to 200h of operation per year.
The permissible average power output over 24 hours of operation shall not exceed 70% of the standby power rating.
No overload is permitted.

◎ MECHANICAL SYSTEM ◎ FUEL CONSUMPTION


ㅇEngine Model D1146T ㅇPrime Power (lit/hr) 1,500 rpm 1,800 rpm
ㅇEngine Type In-line 4 cycle, water cooled 25% 8.2 11.4
Turbo charged 50% 13.6 18.1
ㅇCombustion type Direct injection 75% 19.5 24.9
ㅇCylinder Type Replaceable dry liner 100% 25.9 32.5
ㅇ Number of cylinders 6 ㅇStandby Power (lit/hr 1,500 rpm 1,800 rpm
ㅇBore x stroke 111(4.37) x 139(5.47) mm(in.) 25% 8.6 11.9
ㅇDisplacement 8.071(492.49) lit.(in3) 50% 14.3 19.6
ㅇCompression ratio 16.8 : 1 75% 20.4 27.3
ㅇFiring order 1-5-3-6-2-4 100% 27.0 35.1
ㅇInjection timing 11° BTDC
ㅇCompression pressure Above 28 kg/cm2(398 psi) at 200rpm ◎ FUEL SYSTEM
ㅇDry weight Approx. 780 kg (1,720 lb) ㅇInjection pump Zexel in-line “AD” type
ㅇDimension 1,277 x 824 x 1,074 mm ㅇGovernor RSV type ( all speed control )
(LxWxH) (50.3 x 32.4 x 42.3 in.) ㅇFeed pump Mechanical type
ㅇRotation Counter clockwise viewed from Flywheel ㅇInjection nozzle Multi hole type
ㅇFly wheel housing SAE NO.2 ㅇOpening pressure 214 kg/cm2 (3,044 psi)
ㅇFly wheel Clutch NO.11 1/2 ㅇFuel filter Full flow, cartridge type
ㅇUsed fuel Diesel fuel oil

◎ MECHANISM ◎ LUBRICATION SYSTEM


ㅇType Over head valve ㅇLub. Method Fully forced pressure feed type
ㅇNumber of valve Intake 1, exhaust 1 per cylinder ㅇOil pump Gear type driven by crankshaft
ㅇValve lashes at cold Intake 0.30 mm (0.0118 in.) ㅇOil filter Full flow, cartridge type
Exhaust 0.30 mm (0.0118 in.) ㅇOil pan capacity High level 15.5 liters ( 4.09 gal.)
Low level 12 liters ( 3.17 gal.)
◎ VALVE TIMING ㅇAngularity limit Front down 25 deg.
Opening Close Front up 25 deg.
ㅇIntake valve 16 deg. BTDC 36 deg. ABDC Side to side 25 deg.
ㅇExhaust valve 46 deg. BBDC 14 deg. ATDC ㅇLub. Oil Refer to Operation Manual

DOOSAN Infracore Printed in November 2009 PS-D1146T-D


D1146T G-DRIVE
◎ COOLING SYSTEM ◎ ENGINEERING DATA
ㅇCooling method Fresh water forced circulation ㅇWater flow 130 liters/min @1,500 rpm
ㅇWater capacity 14 liters ( 3.70 gal.) ㅇHeat rejection to coolant
(engine only) ㅇAir flow 6.7 m3/min @1,500 rpm
ㅇPressure system Max. 0.5 kg/cm2 ( 7.11 psi) ㅇExhaust gas flow
ㅇWater pump Centrifugal type driven by belt ㅇExhaust gas temp.
ㅇWater pump Capacity 150 liters ( 39.6 gal.)/min ㅇWater flow 150 liters/min @1,800 rpm
at 1,800 rpm (engine) ㅇHeat rejection to coolant 17.4 kcal/sec @1,800 rpm
ㅇThermostat Wax – pellet type ㅇAir flow 10.6 m3/min @1,800 rpm
Opening temp. 71°C ㅇExhaust gas flow 25.7 m3/min @1,800 rpm
Full open temp. 85°C ㅇExhaust gas temp. 470 °C @1,800 rpm
ㅇCooling fan Blower type, steel ㅇMax. permissible restrictions
590 mm diameter, 6 blade -.Intake system 220 mmH2O initial
635 mmH2O final
◎ ELECTRICAL SYSTEM -.Exhaust system 600 mmH2O max.
ㅇCharging generator 24V x 45A alternator ㅇMax. permissible altitude 1500 m
ㅇVoltage regulator Built-in type IC regulator
ㅇStarting motor 24V x 4.5kW ◆ CONVERSION TABLE
ㅇBattery Voltage 24V in. = mm x 0.0394 lb/ft = N.m x 0.737
ㅇBattery Capacity 100 AH (recommended) PS = kW x 1.3596 U.S. gal = lit. x 0.264
ㅇStarting aid (Option) Block heater psi = kg/cm2 x 14.2233 kW = 0.2388 kcal/s
in3 = lit. x 61.02 lb/PS.h = g/kW.h x 0.00162
hp = PS x 0.98635 cfm = m3/min x 35.336
lb = kg x 2.20462

Head office
7-11, Hwasu-Dong, Dong-Gu, Incheon, Korea
TEL : 82-32-211-2246, 2222 FAX : 82-32-761-2759
Seoul Office
Doosan Infracore Co. Ltd.,
22nd Floor, Doosan Tower, 18-12, Euljiro 6-ga, Jung-gu,
Seoul, Korea.
TEL : 82-2-3398-8521~8535 FAX : 82-2-3398-8509
Web site : www.doosaninfracore.com

※ Speccifications are subject to change without prior notice

DOOSAN Infracore Printed in November 2009 PS-D1146T-D

You might also like