Professional Documents
Culture Documents
Dash8 200 300 Fuel PDF
Dash8 200 300 Fuel PDF
FUEL
Page 1
Dash8-200/300 - Fuel System
Page 2
Dash8-200/300 - Fuel System
SYSTEM DESCRIPTION
Fuel is contained in two integral main wing tanks, designated number 1 (left) and number 2
(right). Each wing tank includes a collector tank, which houses its associated AC auxiliary
pump. Fuel from each collector tank supplies its respective engine. No cross feed capability
is provided.
Positive main tank venting is into a surge tank provided at each wing tip. Any fuel
accumulated into the surge tank drains back to the main tanks.
Fuel quantity
Six fuel probes in each tank measure fuel quantity indication. Usable fuel quantity in each
main tank is displayed in kilos on two fuel quantity indicators in the flight compartment and
repeated on the refuel/defuel panel in number 2 nacelle. When the fuel in either collector
tank drops below 60 kilo’s, the associated TANK FUEL LOW caution light illuminates and the
master caution light flashes.
Fuel temperature
The fuel temperature in the left collector tank is displayed on the fuel temperature indicator
whenever the left secondary bus is energized.
The fuel supply to each engine is heated prior to entering the engine driven fuel pump. The
temperature is displayed on the respective temperature indicators on the engine instrument
panel.
Fuel to each engine is fed from the collector tank and delivered to the hydro-mechanical
control unit (HMU). Two pumps perform this function, a main engine driven pump and a
boost ejector pump. The ejector pump draws fuel from the collector tank and delivers it to the
main pump inlet continuously throughout the normal engine operating range. The main pump
then delivers the fuel directly to the HMU.
If the main pump inlet boost pressure drops below 5.5 Psi, the respective ENG FUEL PRESS
caution light illuminates.
An AC (variable frequency) auxiliary pump serves as a back up source of fuel boost pressure
to the main pump if the ejector pump fails to provide the minimum boost pressure. A green
advisory light adjacent to the AUX PUMP switch illuminates when the auxiliary pump is
selected ON and providing fuel boost pressure.
The engine feed system from each tank incorporates an emergency shut off valve which
closes when the associated PULL FUEL OFF handle on the fire protection panel is pulled.
Adjacent fuel valve position indicator lights display when either valve is open or closed.
The fuel supply to each engine is heated and filtered before entering the engine driven fuel
pump. If the fuel filter becomes clogged, fuel bypasses the filter to supply the engine and
illuminates the respective FUEL FLTR BYPASS caution light and master caution light.
Page 3
Dash8-200/300 - Fuel System
12 12
Fuel quantity
Page 4
Dash8-200/300 - Fuel System
Magnasticks
Two magnetic dipsticks (magna sticks) in each tank provide an alternate means of
measuring fuel quantity when on the ground. Each consists of a calibrated rod, which slides
within a tube extending vertically from the bottom of the fuel tank. When the rod is released,
allow it to fall slowly until resistance is felt as the rod magnet becomes attracted to the float
magnet. Read the tank contents from the bottom of the rod in U.S. gallons or in litres.
Due to wing dihedral, two dipsticks are required for each tank. If the inner dipstick does not
drop when it is released, the fuel level is at the top of the tank (at that location). Total fuel
quantity must then be read from the outer dipstick.
Page 5
Dash8-200/300 - Fuel System
FUEL GRADE: Fuels conforming to any of the following specifications are approved for
use. Mixing of fuels is permitted.
CANADIAN U.S.
KEROSENE TYPE
CAN 2 - 3.23 - M81 ASTM D1655 JET A
CAN 2 - 3.23 - M81 ASTM D1655 JET A1
MIL-T-5624 JP-5
MIL-T-5624 JP-8
WIDE CUT TYPE
CAN 2 - 3.22 - M80 ASTM-D1655-JET B
MIL-T-5624 JP-4
USABLE FUEL: Fuel remaining in fuel tanks when quantity indicators show zero fuel is not
usable in flight. Usable fuel tank capacities are 1287 kg per tank.
Tank 1 and tank 2 auxiliary pumps must be on for take-off and landing.
Take-off with fuel heater outlet temperature indication below 11qC is prohibited.
Operation with fuel heater outlet temperature indication above 57qC is prohibited.
Page 6
Dash8-200/300 - Fuel System
Page 7
Dash8-200/300 - Fuel System
The fuel transfer system transfers fuel from tank to tank to correct any lateral imbalance. A
single transfer switch on the fuel control panel controls the system. Transferring is not
possible if refuelling is in progress.
During transfer, the auxiliary pump of the donor tank is activated to pump fuel through the
transfer manifold to the receiving tank. A flow control valve in the receiving tank opens to
admit fuel while the corresponding valve of the door tank remains closed.
Electrically operated shutoff valves open when the transfer system is active and close when
system is shut off. OPEN and CLOSED advisory lights show the position of each valve.
The refuel/transfer servo valve is controlled by the fuel transfer switch and opens in the
receiving tank during fuel transfer and pressure refuelling. When the transfer system is
deactivated, the servo valve closes causing the flow control valve terminating the fuel
transfer.
A pressure refuelling pilot valve protects both tanks from overfilling during pressure refuelling
or the receiving fuel tank during fuel transfer by shutting the fuel off when the desired level in
the tank is reached.
Page 8
Dash8-200/300 - Fuel System
Page 9
Dash8-200/300 - Fuel System
Refuel/defuel schematic
Page 10
Dash8-200/300 - Fuel System
Fueling
When the refuel/defuel master switch is selected to REFUEL, this activates all appropriate
fuelling valves, which control the fuel flow from the pressurized manifold to the tanks. The
control circuit’s compare the quantity selected by the bug with the existing tank level, and
opens the associated refuelling valves until the actual quantity in each tank corresponds to
the bug setting. When the desired quantity (as selected on the quantity indicators) is
reached, or, whenever the tanks are full, the control valves automatically shutoff the fuel flow
to the tanks. Advisory lights on the refuel/defuel control panel indicate the position of the fuel
control valves when fuelling is in progress.
A dump valve in each tank protects the tanks from damage due to overfilling should the
normal and backup fuel shutoff functions fail. Any excess fuel entering the main tanks is
pumped via the dump valve into the surge tank and then dumped overboard through the
surge tank vents. Should the surge tank vents become blocked, increased pressure on the
tanks dumps fuel overboard via a pressure relief valve through vents below each wing.
A pre-check test system simulates filled tanks thereby ensuring the serviceability and
operation of the automatic shutoff system. During test, when the left or right tank is selected,
refuelling through the manifold stops. Refuelling to the tank resumes when the switch is
released.
NOTE: The refuelling control circuits are armed through switches activated by the
dump valves. This ensures that dump valves are fully open before refuelling can
take place.
Page 11
Dash8-200/300 - Fuel System
Defueling
During defueling, the flow through the refuel/defuel manifold is reversed so that fuel flows
from the tanks back into a receiving fuel truck.
When the refuel/defuel master switch is selected to DEFUEL, the shutoff valves operate
automatically to limit refuelling to a preset quantity. If variable frequency AC power is used,
the auxiliary pumps activate automatically to aid the defueling process. In the absence of a
suction defueling facility but with an AC power source available, pressure defiling may be
accomplished using the auxiliary fuel pumps.
NOTE: The refuel/defuel panel access door can be closed with the master refuel/defuel
switch at REFUEL or DEFUEL. With the panel closed, the only indication that
REFUEL or DEFUEL is still selected, is illumination of the FUELING ON caution
light in the flight compartment. Fuel cannot be transferred when the FUELING
ON caution light is illuminated.
Battery fueling
The aircraft may be refuelled on battery power only, without powering up the aircraft. This is
accomplished by selecting the capped BATT REFUEL switch on the refuelling panel ON,
which powers the fuel system controls and indicators. Refueling can now take place.
NOTE: During battery refuelling the quantity indicators and fuel valve lights in the flight
compartment will also be powered. There is no indication other than the fuel
valve lights that the BATT REFUEL switch is in the ON position. Therefore, care
should be taken to ensure the switch is OFF and capped before commencing
flight.
Page 12
Dash8-200/300 - Fuel System
Caution lights
Remarks: None
Remarks: Master caution light will not illuminate when this caution light
illuminates.
Fuel transfer is not possible
Page 13