Professional Documents
Culture Documents
Lrut Job Preparation Questionnaire Long Range Guided Wave Inspection
Lrut Job Preparation Questionnaire Long Range Guided Wave Inspection
Accurate completion of this form will help make the work on site more efficient and provide better
inspection and markation of the datum, and as such we ask that you answer as many of the questions as
possible in order to gain the most benefit from the process.
We appreciate your response to this questionnaire at least two weeks prior to the projects mobilization to
allow for quotation time and scheduling i.e. Inductions required, Inspection access requirements, etc.
Customer Information:
Client/Company Name
Client Representative Name
Phone No.
E-mail
Report Requirements Prelim report Choose an item.
Final report Choose an item.
Electronic Copies
Choose an item.
Required
Facility Information:
Facility Name
Site Contact Name
Phone No.
E-mail
Others
Frequency of elbows/
bends over proposed
inspection range
Bend/ Elbow Type Choose an item. Other (specify)
Is the Pipe Buried? Choose an item.
If buried, is excavation for
Choose an item.
inspection possible?
Is scaffolding required to
Choose an item.
access the pipes?
Joints Choose an item. Other (specify)
Wrapped Pipe:
Is the Pipe Wrapped? Choose an item.
Type Choose an item. Other (specify)
Condition Choose an item.
Wall Penetrations:
Are Wall Penetrations present? Choose an item.
Type of Wall Choose an item. Other (specify)
Wall Width/Length (approximate) Choose an item.
Pipe Supports:
Basic Configuration Choose an item.
Support Type
Choose an item. Other (specify)
Frequency of Supports
Inspection History (not already detailed) : (A brief description of equipment service history/problems that
might assist us in determining defect mechanisms i.e. results from previous examinations,
repairs/alterations performed, notes/comments or lab results from operations etc.)
Purpose of examination: (The suspected deterioration mode; CUI, internal corrosion/erosion etc. and if
there are unique problems.)
Please provide an electronic copy, fax copy, or courier a copy of the Manufacture/Fabrication drawing,
Isometric sketch or As Built drawing of the equipment that contains the following examples: (to scale if
possible)
- Test Areas (hatch test areas if a partial test is required).
- Line Numbers, Meterage, Elevation, Associated Equipment, Orientation, etc.
- Location of Welds, Seams, Nozzles, Reinforcement Plates, Vessel Skirt, etc.
- External Attachments, Deck/Platform levels and Insulation/Stiffing Rings, etc.
- Internal Components, Trays, Downcomers, Clip Attachments, etc.
If you have any questions, concerns, or require assistance in completing the information, please do not
hesitate to contact us at your convenience!
Respectfully,