Epicon DSP: Technical Datasheet
Epicon DSP: Technical Datasheet
Epicon DSP: Technical Datasheet
Epicon DSP
High Performance Surface Primer
Description
Epicon DSP is a solvent free adhesion promoter for use in difficult conditions where a more conventional primer may not give adequate
performance, providing a moisture barrier tack coat to green or damp concrete and as an excellent anti-corrosion protection primer for
steel.
Provides a barrier between damp or wet surfaces and Concrete surfaces should be clean, free from oil, grease and
moisture sensitive finishing coats such as epoxy and chemical contamination.
polyurethane floor finishes.
Steel surfaces should be degreased and blasted to SA2½ to remove
Offers a high degree of anti-corrosion protection. rust, scale and oxide layers. Application of the primer to steel
should take place immediately after blasting or within 4 hours.
Relatively low viscosity with good working properties.
Applications
Application Instructions
All cementitious substrates including damp/green concrete,
Apply Epicon DSP to the substrate with a stiff bristled brush
allowing the early application of subsequent coatings;
ensuring that the primer is well worked into the surface. Coverage
including methacrylate waterproof coatings.
is 2-3M² per kg depending on surface profile. Allow the primer to
Primer for steel. become tacky, between 8-24 hours depending on temperature.
Once the primer has achieved a tacky state, the subsequent
Kiln dried aggregate may be blended with Epicon DSP to
coating/screed should be applied. Normal application temperature
produce a levelling screed.
is between 5 and 15°C, higher temperature will reduce the time in
Chemical resistant primer. which the over-coating materials can be applied. Should the primer
dry on the surface, a further primer coating should be applied,
Suitable for damp or difficult to wet out substrates. always allow the primer to become tacky before over-coating.
A Company
Head Office: Kingston House, 3 Walton Road, Pattinson North, Washington, Tyne & Wear, UK
T: +44(0) 191 416 8360 F: +44(0) 191 415 5966 W: www.nufins.com E: [email protected] Issue: 1/2016
Technical Datasheet
A Company
Head Office: Kingston House, 3 Walton Road, Pattinson North, Washington, Tyne & Wear, UK
T: +44(0) 191 416 8360 F: +44(0) 191 415 5966 W: www.nufins.com E: [email protected] Issue: 1/2016