Syncbox/N2X: Converts NTP or Ieee-1588 To Irig, 10Mhz, PPS, Dcf77 and Serial Time Telegrams
Syncbox/N2X: Converts NTP or Ieee-1588 To Irig, 10Mhz, PPS, Dcf77 and Serial Time Telegrams
Lange Wand 9
31812 Bad Pyrmont, Germany
Phone: +49 (5281) 9309-0
Fax: +49 (5281) 9309-30
https://www.meinbergglobal.com
[email protected]
Key Features
- The following output signals are available: PPO (PPS, PPM, PPH, TC DCLS, DCF77 Marks) 10 MHZ
serial time string (Meinberg, Uni Erlangen, NMEA) Option: TC AM Frequenz Synth. sine
- IEEE 1588-2008 (PTP V2) compatible ordinary clock
- Serial COM port for initial configuration and time telegrams
- Supported Protocols: IPv4, NTP, PTP / IEEE 1588-2008, DHCP
- Signal outputs with fiber optical ST connectors available
- Generates several different modulated (AM) and unmodulated (DCLS) IRIG time code signals
- Option: N2X chassis with clamp for 35mm railmount
- 10/100Base-T Ethernet interface - Power over Ethernet option available on request
- Configuration and montoring with Meinberg Device Manager Software
The Meinberg SyncBox N2X is synchronized by a PTP Grandmaster or by a NTP Server and can be used as a time
source for equipment that requires IRIG AM, Freq.Synth/sine, PPO (PPS, PPM, PPH, IRIG DCLS, Cyclic Pulses, Single
Shot, Timer, DCF77 Mark, Time Sync, Freq. Synth./TTL, Time Slots) or serial time string for synchronization.Optionally,
the following output configurations are available:
* Instead of three BNC connectors, the SyncBox N2X can also be equipped with three photomos outputs: 3 x PPOs
with 2-pin sockets (DFK2),
The configuration and monitoring of the system can be done with our Meinberg Device Manager Software.
The SyncBox N2X is equipped with a high precision oscillator ""TCXO". The oscillator determines the long-term stability
in holdover mode, ie when the synchronization with the time source is disturbed. Oscillator update to OCXO-HQ is
possible.
Control elements [4]Meinberg Device Manager via RS-232 serial interface or network connector (RJ45
jack)
* ST - State
blue: during initialisation
green: normal operation
* IN - Input
red: no network connected (network recognition requires a few minutes after
connecting)
yellow: signal is available but not synchron
green (blink):Control by input signal, internal clock is synchronized but not accurate
green: Oscillsator has warmed up, the internal clock runs accurate
* SP - Speed
out: no cable connection
yellow: 10 Mbit
green: 100 Mbit
* LI - Link Activity
out: no cable connection
yellow (blink): if network traffic and 10 Mbit
grün (blink): if network traffic and 100 Mbit
Accuracy of pulse outputs PTP: +/- 100 ns (relative to the used IEEE 1588 Grandmaster Clock, after initial
synchronization phase)
NTP: +/- 1 ms (relativ to NTP when using a local time server)
Unmodulated time code DCLS, TTL into 50 Ohm (PWM-DC Signal) via BNC female connector, high active or
output via FO connector (Fiber Optical)
Modulated time code output Optional IRIG AM sine wave signal via female BNC connector (Out 3):
3Vpp (MARK), 1Vpp (SPACE) into 50 Ohm
Generated time codes IRIG B002: 100pps, DCLS signal, no carrier, BCD time of year
IRIG B122: 100pps, AM sine wave signal, 1 kHz carrier, BCD time of year
IRIG B003: 100pps, DCLS signal, no carrier, BCD time of year, SBS time of day
IRIG B123: 100pps, AM sine wave signal, 1kHz carrier, BCD time of year, SBS time of
day
IRIG B006: 100 pps, DCLS Signal, no carrier, BCD time-of-year, Year
IRIG B126: 100 pps, AM sine wave signal, 1 kHz carrier frequency, BCD time-of-year,
Year
IRIG B007: 100 pps, DCLS Signal, no carrier, BCD time-of-year, Year, SBS time-of-day
IRIG B127: 100 pps, AM sine wave signal, 1 kHz carrier frequency, BCD time-of-year,
Year, SBS time-of-day
rev 2021.0115.0925 Page 3/5 syncbox_n2x
IEEE1344: Code according to IEEE1344-1995, 100pps, AM sine wave signal, 1kHz
carrier, BCD time of year, SBS time of day, IEEE1344 expansion for date, time zone,
Generated time codes IRIG B002: 100pps, DCLS signal, no carrier, BCD time of year
IRIG B122: 100pps, AM sine wave signal, 1 kHz carrier, BCD time of year
IRIG B003: 100pps, DCLS signal, no carrier, BCD time of year, SBS time of day
IRIG B123: 100pps, AM sine wave signal, 1kHz carrier, BCD time of year, SBS time of
day
IRIG B006: 100 pps, DCLS Signal, no carrier, BCD time-of-year, Year
IRIG B126: 100 pps, AM sine wave signal, 1 kHz carrier frequency, BCD time-of-year,
Year
IRIG B007: 100 pps, DCLS Signal, no carrier, BCD time-of-year, Year, SBS time-of-day
IRIG B127: 100 pps, AM sine wave signal, 1 kHz carrier frequency, BCD time-of-year,
Year, SBS time-of-day
IEEE1344: Code according to IEEE1344-1995, 100pps, AM sine wave signal, 1kHz
carrier, BCD time of year, SBS time of day, IEEE1344 expansion for date, time zone,
daylight saving and leap second in Control Funktions Segment
C37.118: Like IEEE1344 - with turned sign bit for UTC-Offset
AFNOR: Code according to NFS-87500, 100pps, AM sine wave signal, 1kHz carrier,
BCD time of year, complete date, SBS time of day
Power consumption 5W
Form Factor Aluminium Desktop Case TUG 05 160 L MS (like GOAL / DOAL).
Physical Dimensions: 105 mm x 45 mm x 160mm (W x H x D)
Scope of supply SyncBox, 5-pin DFK clamp (DC power supply only), USB Flash Drive with manual and
Meinberg software.
Technical Support Meinberg offers free lifetime technical support via telephone or e-mail.
Firmware Updates Firmware is field-upgradeable, updates can be installed directly at the unit via serial
connection and with MBGFLASH tool. Software updates are provided free of charge, for
the lifetime of your Meinberg product.
WEEE status of the product This product is handled as a B2B category product. In order to secure a WEEE
compliant waste disposal it has to be returned to the manufacturer. Any transportation
expenses for returning this product (at its end of life) have to be incurred by the end
user, whereas Meinberg will bear the costs for the waste disposal itself.
Manual
Links:
[1] https://www.meinbergglobal.com/english/products/
[2] https://www.meinbergglobal.com/english/products/
[3] https://www.meinbergglobal.com/english/products/
[4] https://www.meinbergglobal.com/english/products/
[5] https://www.meinbergglobal.com/download/docs/manuals/english/syncbox_n2x.pdf