Pages de ASME VIII - DIV.1 (2019) Table UW-12
Pages de ASME VIII - DIV.1 (2019) Table UW-12
--`,``,``,,`,`,,````,`,``,,,`-`-`,,`,,`,`,,`---
ASME BPVC.VIII.1-2019
jackets not over 5/8 in. (16 mm) in nominal thickness
where the distance from the center of the plug weld to
the edge of the plate is not less than 11/2 times the
diameter of the hole for the plug.
Not for Resale, 07/02/2019 13:29:04 MDT
Licensee=Khalda Petroleum/5986215001, User=Amer, Mohamed
121
(6) Single full fillet lap joints without plug welds (a) For the attachment of heads convex to pressure to shells A and B NA NA 0.45
not over 5/8 in. (16 mm) required thickness, only with
use of fillet weld on inside of shell; or
(b) for attachment of heads having pressure on either side, to A and B NA NA 0.45
shells not over 24 in. (600 mm) inside diameter and not
over 1/4 in. (6 mm) required thickness with fillet weld
on outside of head flange only
(7) Corner joints, full penetration, partial penetration, and/or fillet welded As limited by Figure UW-13.2 and Figure UW-16.1 C and D NA NA NA
[Note (8)]
(8) Angle joints Design per U-2(g) for Category B and C joints B, C, and D NA NA NA
UW-13