SmartEdge 100

Multi-Service Edge Router

Compact form-factor Multi-Service Edge Router integrates Edge Routing,
Ethernet Aggregation, and Subscriber Management functionalities to deliver
secure, guaranteed Multi-Play services to consumers and businesses.

Key benefits Ericsson's SmartEdge 100 Multi-Service Edge

Router (MSER) is architected and optimized for
• Simplifies triple play networks by combining edge deployment in advanced networks that deliver
routing, Ethernet aggregation, and subscriber Multi-Play services such as video, voice, data and
management interactive content or business services such as layer
• Suitable for deployment in smaller network 2/3 Virtual Private Networking. Based on proven
environments with fewer subscribers or requiring SmartEdge 400/800 Multi-Service Edge Router
less ports hardware and software technology, SmartEdge 100
unifies high-performance edge routing, Ethernet
• Resilient Operating System (SEOS) allows aggregation and advanced subscriber management
continuous operation capable of independently into an efficient, and compact platform. Powered
restarting tasks by Ericsson’s programmable ASICs, the SmartEdge
• Multicast replication for IPTV and video on demand 100 MSER supports thousands of users and
sessions in smaller network environments such as
• IPV4 (IPv6 ready) routing with up to 1.5 million distributed points of presence (POPs), remote central
route entries and 1,000 BGP Peers offices (RCOs), wireless backhaul and multi-tenant
units (MTU) aggregation. SmartEdge MSERs can be
• Granular service control with up to 8 queues per
directly connected to the access layer of a network,
subscriber
such as a group of DSLAMs or Ethernet switches,
• 12 Gbps throughput, 7 Mpps wire speed eliminating unnecessary network layers and reducing
performance in a compact 2-RU form factor complexity.
• Support for 8,000 simultaneous users with up to SmartEdge 100 subscriber management capability
16,000 VLANs, 10,000 IGMP groups and Multicast supports up to 8,000 subscribers, via Point-to-
Routes; 160,000 MAC Addresses Point Protocol (PPP) and tunneling, DHCP Server,
RADIUS and AAA support. SmartEdge 100 MSER
• Advanced H-QoS and Traffic Management to
applies user configuration and management policies
control bandwidth for each service per subscriber:
Can be configured for up to 2,000 virtual routers or
VPN with 2,000 L2TP tunnels, 2,000 MPLS labels,
1,000 H-VPLS instances with 802.1Q access and
EoMPLS access
to individual data streams on a per-subscriber, SmartEdge 400/800 platforms. The SmartEdge
personalized basis. It also supports Client-Less IP operating system (SEOS) is modular and capable
Subscribers (CLIPS) environments, without requiring of hitless restart. This means that when a software
PPPoE usernames for DHCP environments to process is taken out of service the system can
increase subscriber retention rates. continue to operate until the process is updated and
restarted independently.
Edge Routing capability is supported in hardware
with a full suite of IP routing protocols, Multi-Protocol SmartEdge 100 delivers low latency, wire-speed
Label Switching (MPLS), with hierarchical Quality of performance for all ports. Two Packet Processing
Service (H-QoS). It is suited for smaller size networks ASICs (PPA2) perform per-subscriber packet
or to extend an existing large network into smaller, inspection, processing, and forwarding at wire-
lower port density segments. speed. High throughput is ensured by utilizing
one PPA2 for ingress and the other to egress
Access aggregation is supported via
traffic. SmartEdge 100 has two additional CPUs,
• Hot-swappable 12 port SFP-based Fast Ethernet, separating system management functions from
OR 12 port 10/100 Copper-based packet processing services. One CPU is dedicated
to protocol and subscriber management functions,
• Hot-swappable 2 two-port ATM OC-3/STM-1 and the other is dedicated to time-critical system
• Hot-swappable 2 fixed dual-wired 1xGE uplink functions, such as fault and performance monitoring
ports and alarms. The separation of data, control and
management functions enables the SmartEdge 100
• Full suite of IP QoS and layer 2/3 protocols such to deliver scale and performance predictability for
as, Q-n-Q, VPLS, MPLS, H-VPLS with Traffic every port and every subscriber, regardless of the
Management using Hierarchical Quality of Service number of route entries, BGP Peers or Layer 3 and
(H-QoS) schemes. layer 4 services.
The SmartEdge 100 uses the same highly resilient
operating system that is used in higher capacity
Device specifications for SmartEdge 100

• Dimensions: 3.5 inches (8.9 cm) height, 17.5 inches (44.5 cm) width, 19.6 inches (50.0 cm) depth
• Weight: 20.0 lb (9.1 kg)
• System CPU: Two 600 MHz Power PCs
• Route/Switch Engine: two programmable ASICs, each with 32
• RISC core and 1GB RAM
• 1 GB system RAM
• 1 GB removable compact system flash card

Physical interfaces

Ethernet
•12 10BASE-T, 100BASE-TX, 100BASE-FX
• 2 Gigabit Ethernet ports (TX and FX supported) ATM
• 2-port OC-3/STM-1 cards (includes support for SM and MM)

Power requirements
• AC Power Version Single Auto-sensing AC Power supply – 90-132 VAC or 170-264 VAC, Frequency range: 47-63 Hz Cur-
rent draw, maximum 3.8A @90 VAC
• DC Power Version Two Redundant DC power entry points -39 VDC to –58 VDC Current draw, maximum 7.6A @-40 VDC

Power consumption
• 200 Watts for typical configuration to 300 Watts max
• 682 British Thermal Units (BTUs) at average power draw of 200W

Environmental specifications
• Operating temperature, nominal: 41° to 104°F (5° to 40°C)
• Operating temperature, short term (96 hours or less): 23° to 131°F (-5° to 55°C)

Thermal exhaust
• Front to back airflow and exhausts air to the rear of the device

Regulatory compliance, emission certification and immunity

Product Safety Emissions Immunity UL

UL 60950 CSA 22.2 No. 60950 IEC60950
EN60950 AS/NZS 3260 FCC part 15, Class A
ETSI EN300 386-2 CISPR 22, Class A ICES-003, Class A
VCCI, Class A EN55022, Class A EN61000-3-2
EN61000-3-3 AS/NZS 3548, Class A EN61000-3-3
EN61000-4-2 EN61000-4-3 EN61000-4-4
EN61000-4-5 EN61000-4-6 EN61000-4-8
EN61000-4-11 EN300 386-2

Feature specifications

Ethernet
• IEEE 802.1Q, VLAN Trunking/Tagging, IEEE 802.3ad link aggregation (with LACP) Encapsulations and Tunneling
• Ethernet, IEEE 802.1QinQ, MPLS, PPPoA, PPP over Ethernet (RFC 2516), IPoE, DHCP
• Bridge 1483, Route 1483
 IP address management
• DHCP: DHCP Proxy, DHCP Relay
• Integrated DHCP Server
• PPP: IPCP parameter negotiation, L2TP Dynamic
• IP assignment: IP pools, RADIUS assigned addressing and Clientless IP addresses
• Fixed IP address assignment: localized subscriber profile, RADIUS assigned addressing

Multicast protocols
• PIM-SM (RFC 2362 + IETF Draft), PIM-DM (IEFT Draft), IGMPv1, v2, v3 (RFC 3376), SSM (RFC 3569), MBGP (RFC
2858), MSDP (RFC 3618), IGMP snooping, IGMP filtering
• IPv6 Mstatic Support; Enhance PIM Static Joins for V6 Support and Enhanced PIM SSM for V6

Quality of service
• 802.1p Class of Service (CoS), Differentiated Services Code Point (DSCP) ToS, IP Precedence, and MPLS EXP bits
• Packet classification (RFC 474,2475, 2597, 2598); DiffServ packet marking by ACL, ingress policing, or BGP attribute
based QoS; class-based ingress policing and egress shaping; priority queuing and EDRR; RED and WRED; Hierarchical
Scheduling
• Ability to customize mapping of L2 to L3 QoS

Technical specifications

Routing protocols
• BGP-4 (RFC 1771), IS-IS (RFC 1195 & ISO/IEC10589), OSPFv2/v3, RIP v2, RIPng, VRRP (RFC 2338), LDP, RSVP
• LDP tunneling over RSVP LSPs (RFC 3209); BFD for OSPF, ISIS, BGP, static routes and individual links in 802.3ad link
group
• Mobile IP (Foreign Agent)

Security
• Reverse Path Forwarding (RPF), Secure ARP, MD5 support for routing protocols, key rollover, RADIUS, TACACS+;
Administrative ACLs, packet mirroring and sampling, Secure Shell (SSH) Protocol, Kerberos, SNMPv3, IGMP filtering,
SSHv2, VLAN ACLs, IP security router ACLs, subscriber-based ACLs
• Lawful Intercept (CALEA)

Virtual private networking

• L2TP (RFC 2661) LAC, LTS, LNS
• 802.1Q Virtual LAN (VLAN) support with 802.1QinQ - with CoS mutation, 802.1Q tunneling with VLAN mapping
• MPLS VPNs (RFC 4364 previously known as 2547bis), Carrier of carriers and Inter-AS, MPLS VPN (options A, B, C)
MPLS FRR, Multicast over MPLS VPN, GRE, Soft GRE, MPLS over GRE, EoMPLS, Layer 2 VPNs (draft-martini), VPLS,
H-VPLS

Configuration and management

• Command Line Interface (CLI) support via telnet or SSH
• RADIUS, Diameter, TACACS+
• SNMP v1/2/3
• ANCP with support for DSL Sync Rate with Dynamic QoS Change and ATM Ping command to DSLAM

© 2008 to 2009, Ericsson AB. All rights reserved.

Redback and SmartEdge are trademarks registered at the U.S. Patent & Trademark
Office and in other countries. AOS, NetOp, SMS, and User Intelligent Networks are
trademarks or service marks of Redback Networks Inc. All other products or services
Ericsson mentioned are the trademarks, service marks, registered trademarks or registered
100 Headquarters Drive service marks of their respective owners. All rights in copyright are reserved to the
San Jose, CA 95134-1362 USA copyright owner. Company and product names are trademarks or registered trademarks
Tel: +1 408 750 5000 of their respective owners. Neither the name of any third party software developer nor
Fax: +1 408 750 5599 the names of its contributors may be used to endorse or promote products derived
www.ericsson.com from this software without specific prior written permission of such third party.