2 - Introduction MCQ Questions 2

1.
Multiple access schemes are used to allow ________ mobile users to share simultaneously a finite
amount of radio spectrum.
a) Many
b) One
c) Two
d) Ten-Fifteen
2. The technique that makes possible the task of listening and talking in communication system is called
________
a) Simplexing
b) Duplexing
c) Modulating
d) Multiple access technique
3. Frequency division duplexing provides ________ distinct bands of frequencies for _________ user.
a) Two, two
b) One, two
c) Two, one
d) Two, many
4. In ______, each station is allocated a band to send its data. In other words, each band is
reserved for a specific station, and it belongs to the station all the time.
a) FDMA
b) TDMA
c) CDMA
d) none of the above
5. In _______, the stations share the bandwidth of the channel in time.
a) FDMA
b) TDMA
c) CDMA
6. Full duplex operation-permits transmission in both directions at the

same time.
a) True
b) False
7. Three or more devices share a link in ________ connection.

a) Unipoint
b) Multipoint
c) Point to point
d) Simplex
8. Which of the following transmission directions listed is not a legitimate channel?
a) Simplex
b) Half Duplex
c) Full Duplex
d) Double Duplex
9. A half-duplex communication channel permits information to travel
a) At timed intervals
b) One direction only
c) Both ways, but not at once
d) Both ways at once
10. Time division duplexing uses ________ to provide both a forward and reverse link.
a) Frequency
b) Time
c) Time and frequency
d) Cell spacing
11. Narrowband FDMA allows users to share the same radio channel allocating a unique time slot to
each user.
a) True
b) False
12. Frequency division multiple access (FDMA) assigns ______ channels to _______ users.
a) Individual, individual
b) Many, individual
c) Individual, many
d) Many, many
13. Bit error rate provides the information about the type of error.
a) True
b) False
14. In this method of wireless communication, communication happens only in one direction:
a) Simplex
b) Duplex
c) Half duplex
d) None of the mentioned
15. What is the time duration of a bit if data is transmitted at 270.833 kbps in the channel?
a) 270.833 s
b) 3 μs
c) 3.692 μs
d) 3.692 s
16. TDMA stands for:
a) Time Domain Multiple Access
b) Time-Division Multiple Access
c) Tone Division Multiple Access
17. CDMA stands for:
a) Code-Division Multiple Access
b) Carrier Division Multiple Access
c) Compact Digital Multiplex Arrangement
18. CDMA allows many transmitters to use a band simultaneously
a) True
b) False
19. The different access methods which permit many satellite users to operate in parallel through a
single transponder without interfering with each other as
a) TDMA
b) FDMA
c) CDMA
d) All of the above
20. Digital communication is _______ to environmental changes?

a) Less sensitive
b) More sensitive
c) Does not depend
21. Advantages of digital Signals are:

a) Operation can be readily programmed
b) Little chance of error
c) Information storage is easy
d) All of the mentioned
22. Analog to digital conversion includes
a) Sampling
b) Quantization
c) Sampling & Quantization
23. What form of waveform is shown here?
a) A Binary Signal
b) A Multi valued digital signal
c) An Analogue signal
d) Noise Signal
24. Synchronous transmission:
a) Sends information byte by byte
b) Is cheaper and more commonly used
c) Expensive but very fast
d) a and b
25. The difference between the highest and the lowest frequencies of a signal is known as
a) Frequency
b) Period
c) Bandwidth
d) Amplitude
26. Using CDMA on a radio channel, all signals can transmit ____________________ of the time.
a) all
b) part
27. In FDM, each signal uses part of the bandwidth ____________________ of the time.
a) all
b) part
28. In TDM, each signal uses all of the bandwidth ____________________ of the time.
a) all
b) part
29. Three methods of multiple access are FDMA, TDMA, and ____________________.
a) CDMA
b) FDD
c) TDM
d) FDM
ANSWERS:
1. a
2. b
3. c
4. a
5. b
6. a
7. b
8. d
9. c
10. b
11. b
12. a
13. b (BER) gives a good indication of the performance of a communication system.
14. a
15. Tb = (1/270.833 kbps) = 3.692 μs.
16.b
17. a
18. a
19. d
20. a
21. d
22. c
23. b
24. c
25. c
26. a
27. a
28. b
29. a

2 - Introduction MCQ Questions 2

Uploaded by

Copyright:

Available Formats

2 - Introduction MCQ Questions 2

Uploaded by

Document Information

Original Description:

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

2 - Introduction MCQ Questions 2

Uploaded by

Copyright:

Available Formats

1.

d) none of the above

5. In _______, the stations share the bandwidth of the channel in time.

d) none of the above

6. Full duplex operation-permits transmission in both directions at the

7. Three or more devices share a link in ________ connection.

8. Which of the following transmission directions listed is not a legitimate channel?

9. A half-duplex communication channel permits information to travel

b) One direction only

c) Both ways, but not at once

d) Both ways at once

16. TDMA stands for:

a) Time Domain Multiple Access

b) Time-Division Multiple Access

c) Tone Division Multiple Access

d) none of the above

17. CDMA stands for:

a) Code-Division Multiple Access

b) Carrier Division Multiple Access

c) Compact Digital Multiplex Arrangement

d) none of the above

18. CDMA allows many transmitters to use a band simultaneously

d) All of the above

20. Digital communication is _______ to environmental changes?

21. Advantages of digital Signals are:

23. What form of waveform is shown here?

b) A Multi valued digital signal

24. Synchronous transmission:

a) Sends information byte by byte

b) Is cheaper and more commonly used

c) Expensive but very fast

13. b (BER) gives a good indication of the performance of a communication system.

15. Tb = (1/270.833 kbps) = 3.692 μs.

You might also like