Professional Documents
Culture Documents
Rapid Set Repair Material
Rapid Set Repair Material
MSDS D4
Revision: May-12
NTP: The National Toxicology Program, in its “Ninth Report on Carcinogens” (released May 15,
2000) concluded that “Respirable crystalline silica (RCS), primarily quartz dusts occurring in
industrial and occupational settings, is known to be a human carcinogen, based on sufficient
evidence of carcinogenicity from studies in humans indicating a causal relationship between
exposure to RCS and increased lung cancer rates in workers exposed to crystalline silica dust
(reviewed in IAC, 1997; Brown et al., 1997; Hind et al., 1997)
IARC: The International Agency for Research on Cancer (“IARC”) concluded that there was
“sufficient evidence in humans for the carcinogenicity of crystalline silica in the forms of quartz or
cristobalite from occupational sources”, and that there is “sufficient evidence in experimental
animals for the carcinogenicity of quartz or cristobalite.” The overall IARC evaluation was that
“crystalline silica inhaled in the form of quartz or cristobalite from occupational sources is
carcinogenic to humans (Group 1).” The IARC evaluation noted that “carcinogenicity was not
detected in all industrial circumstances or studies. Carcinogenicity may be dependent on inherent
characteristics of the crystalline silica or on external factors affecting its biological activity or
distribution of its polymorphs.” For further information on the IARC evaluation, see IARC
Monographs on the Evaluation of carcinogenic Risks to Humans, Volume 68, “Silica, Some
Silicates.” (1997)
Signs and Symptoms of Exposure: Symptoms of excessive exposure to the dust include
shortness of breath and reduced pulmonary function. Excessive exposure to skin and eyes
especially when mixed with water can cause caustic burns as severe as third degree.
Medical Conditions Generally Aggravated by Exposure: Individuals with sensitive skin and with
pulmonary and/or respiratory disease, including, but not limited to, asthma and bronchitis, or subject
to eye irritation, should be precluded from exposure. Exposure to crystalline silica or the disease
silicosis is associated with increased incidence of scleroderma, Tuberculosis and possibly increased
incidence of kidney lesions.
Chronic Exposure: Dust can cause inflammation of the lining tissue of the interior of the nose and
inflammation of the cornea. Hypersensitive individuals may develop an allergic dermatitis. (May
contain trace (<0.05 %) amounts of chromium salts or compounds including hexavalent chromium,
or other metals found to be hazardous or toxic in some chemical forms. These metals are mostly
present as trace substitutions within the principal minerals)
Medical Conditions Generally Aggravated by Exposure: Individuals with sensitive skin and with
pulmonary and/or respiratory disease, including, but not limited to, asthma and bronchitis, or subject
to eye irritation, should be precluded from exposure.
SECTION III - HAZARDOUS INGREDIENTS/IDENTITY INFORMATION
Other Limits: National Institute for Occupational Safety and Health (NIOSH). Recommended
standard maximum permissible concentration=0.05 mg/M3 (respirable free silica) as determined by
a full-shift sample up to 10-hour working day, 40-hour work week. See NIOSH Criteria for a
Recommended Standard Occupational Exposure to Crystalline Silica
Eyes: Immediately flush eye thoroughly with water. Continue flushing eye for at least 15 minutes,
including under lids, to remove all particles. Call physician immediately.
Skin: Wash skin with cool water and pH-neutral soap or a mild detergent. Seek medical treatment if
irritation or inflammation develops or persists. Seek immediate medical treatment in the event of
burns.
Inhalation: Remove person to fresh air. If breathing is difficult, administer oxygen. If not breathing,
give artificial respiration. Seek medical help if coughing and other symptoms do not subside.
Inhalations of large amounts of Portland cement require immediate medical attention.
Ingestion: Do not induce vomiting. If conscious, have the victim drink plenty of water and call a
physician immediately.
If spilled, use dustless methods (vacuum) and place into covered container for disposal (if not
contaminated or wet). Use adequate ventilation to keep exposure to airborne contaminants below
the exposure limit.
Do not allow water to contact the product until time of use. DO NOT BREATHE DUST. In dusty
environments, the use of an OSHA, MSHA or NIOSH approved respirator and tight fitting goggles is
recommended.
Engineering Controls: Local exhaust can be used, if necessary, to control airborne dust levels.
Personal Protection: The use of barrier creams or impervious gloves, boots and clothing to protect
the skin from contact is recommended. Following work, workers should shower with soap and
water. Precautions must be observed because burns occur with little warning -- little heat is sensed.
Stability: Stable.
Incompatibility (Materials to Avoid): Material when mixed with water will react with Aluminum and
other alkali and alkaline earth elements liberating hydrogen gas.
Hazardous Decomposition or By-products: None
Hazardous Polymerization: Will Not Occur.
Condition to Avoid: Keep dry until used to preserve product utility.
SECTION XI – TOXICOLOGICAL INFORMATION
Waste Disposal Method: The packaging and material may be land filled; however, material should
be covered to minimize generation of airborne dust. This product is not classified as a hazardous
waste under the authority of the RCRA (40CFR 261) or CERCLA (40CFR 117&302).
US OSHA 29CFR 1910.1200: Considered hazardous under this regulation and should be included
in the employers hazard communication program
SARA (Title III) Sections 311 & 312: Qualifies as a hazardous substance with delayed health
effects
SARA (Title III) Section 313: Not subject to reporting requirements
TSCA (May 1997): All components are on the TSCA inventory list
Federal Hazardous Substances Act: Is a hazardous substance subject to statues promulgated
under the subject act
California Regulation: WARNING: This product contains chemicals known to the State of
California to cause cancer, birth defects or other reproductive harm.
Canadian Environmental Protection Act: Not listed
WHMIS Classification: Considered to be a hazardous material under the Hazardous Products Act
as defined by the Controlled Products Regulations (Class D2A, E- Corrosive Material) and subject to
the requirements of Health Canada’s Workplace Hazardous Material Information (WHMIS). This
product has been classified according to the hazard criteria of the Controlled Products Regulation
(CPR). This document complies with the WHMIS requirements of the Hazardous Products Act
(HPA) and the CPR.
NOTE: The information and recommendations contained herein are based upon data believed to be correct.
However, no guarantee or warranty of any kind, express or implied, is made with respect to the information
contained herein. We accept no responsibility and disclaim all liability for any harmful effects which may be
caused by exposure to silica contained in our products.