The LICCON Work Planner For Mobile Cranes
The LICCON Work Planner For Mobile Cranes
The LICCON Work Planner For Mobile Cranes
planner for
mobile cranes.
ballast.
derrick
tio n of the
Calcula
The load capacity program. The crane selection program.
It enables the representation of all load charts of a crane. The This program permits automatic selection of the suitable ● Listing of all cranes available for which data diskettes
following actions can be performed by means of a symbol bar: crane by entering the load case parameters such as load, radius are existing.
● Representation of a briefing in reference of the program. and lifting height. The following actions are practicable within ● Editing of crane list, i.e. automatic crane selection or
● Display of all programmed charts and operating modes. the program: selection of an individual crane.
● Page forward/backwards of charts. ● Optimization of crane selection according to various criteria,
● Media copy by a connected printer. e.g. shortest boom, minimum counterweight or smallest
● Display of the chart values for every telescoped condition supporting basis.
of the boom sections subject to the radius. ● Allowing for an existing obstructing contour entered by
● Information regarding to locked/unlocked boom sections the 2-D planner.
Prerequisites of the
hardware.
For installing the LICCON work planner into your PC, it
should be equipped with the operating system MS-DOS 3.3
or a higher version. For the most efficient utilization of the
program, you should employ at least an IBM-compatible,
386 DX personal computer with co-processor and colour
monitor. Moreover, your PC should have a hard disk, a
VGA graphic card and a micro soft compatible mouse,
the min. storage capacity of the main memory should
be 4 MB.
Please contact
LIEBHERR-WERK EHINGEN GMBH
D-89582 Ehingen/Donau, Telefon (0 73 91) 5 02-0, Telefax (0 73 91) 5 02-33 99
www.lwe.liebherr.de, E-mail: [email protected]