Professional Documents
Culture Documents
LLC3kW GUI Manual
LLC3kW GUI Manual
v1.01 11.08.2015
1 Control board
2 Connections
2.1 Serial communication connector
Graphical User Interphase software controls the MCU by serial bus (UART) with TTL logic
(3.3V). The connector part number is Wurth 619 004 110 21.
TXD
RXD
GND
+3V3
1/8
LLC3kW GUI Manual Tomáš Kupka
v1.01 11.08.2015
Interphase PCB
– the interphase PCB includes FTDI USB to UART converter module
– the PC driver has to be installed before first plug-in
– the drive is downloadable online (http://www.ftdichip.com/Drivers/VCP.htm)
– the virtual comport number should be between 1 and 9
2/8
LLC3kW GUI Manual Tomáš Kupka
v1.01 11.08.2015
3/8
LLC3kW GUI Manual Tomáš Kupka
v1.01 11.08.2015
Setting:
U2 – required voltage
U2_max – output over-voltage protection value
I1_fuse – input (tank) over-current protection value
I2_fuse – output over-current protection value
Check-boxes:
LLC2, LLC2 phases enabler – LLC2 is not allowed to work separately
SR1, SR2 enabler – LLC converters can run without synchronous rectifier, but rectifiers cannot be
enabled without corresponding LLC stage
Automatic SR – synchronous rectifiers are turned on and off automatically if they are enabled
Fault Latched – faults can be latched (until MCU reset) or they are cleared after some time
Buttons:
Start/Stop – inverter run/stop commands
Set – command to transfer all values and setting into MCU
Measurement:
U1 – input voltage
U2 – output voltage
I11 – rectified input (tank) current phase 1
I21 – rectified input (tank) current phase 2
I12 – output current phase 1
I22 – output current phase 2
4/8
LLC3kW GUI Manual Tomáš Kupka
v1.01 11.08.2015
In case of system over-temperature (exceeding 80°C) MCU stops all power conversion and
turns to fault state. This protection function is independent to GUI.
5/8
LLC3kW GUI Manual Tomáš Kupka
v1.01 11.08.2015
3.7 Calibration
– Tools → Calibration
– software provides offset calibration for currents and voltages
– operator only writes the actual correct value into the box, checks corresponding check-box
and press “Calibrate” button
6/8
LLC3kW GUI Manual Tomáš Kupka
v1.01 11.08.2015
+ source
– source pole
pole
for LLC1
– source pole
for LLC2
7/8
LLC3kW GUI Manual Tomáš Kupka
v1.01 11.08.2015
8/8